Product

Combination Board Tester

-

Qmax Test Technologies Pvt. Ltd.

Qmax Test Technologies Pvt. Ltd.

Combination Board Tester capable of testing highly complex and dense PCBs employing various test techniques on a single platform. It can perform Board Level Functional Test through edge connectors of a PCB, and guided probe diagnostics utility to reliably repair Digital/Analog and Mixed Signal PCBs of various complexities and conventional PCBs. An In –Circuit device test by configuring Pin Drivers to High Current Pin Driver mode and interface to the UUT either through Clips / Probes or nail bed and on board clock disable HW feature are the all time favorite . The in-built high frequency 14bit Analog Driver / sensors synchronized with digital drivers for covering analog / mixed signal devices with high degree of accuracy.

Product

Vol-Con® Solenoid Voltage Tester

61-076

-

IDEAL Industries, Inc.

61-076 - IDEAL Industries, Inc.

*Extremely rugged and reliable*Vibrates when AC voltage is present*Indicates AC/DC voltage level*Replaceable leads with shielded probe tips (IEC61010-031 compliant)*Bright, long-life LED™s and neon indicator lamp*Dual voltage indication for backup safety*2-year warranty

Product

AC Current Probe 2 mV/A, 3,000A, 0.11 Hz LF Bandwidth, 6.5MHz HF Bandwidth, 4m cable, 300mm coil

T3RC3000-LF

-

Teledyne LeCroy

T3RC3000-LF - Teledyne LeCroy

AC Current Probe 2 mV/A, 3,000A, 0.11 Hz LF Bandwidth, 6.5MHz HF Bandwidth, 4m cable, 300mm coil.

Product

CO2 Concentration Transmitter

H5321

-

COMET SYSTEM, s.r.o.

H5321 - COMET SYSTEM, s.r.o.

The device is supplied with CO2 probe with 1m cable. Cable lengths 2, 4 or 10 meters available optionally.

Product

Expanding In-Circuit Capabilities

-

Circuit Check, Inc.

Circuit Check, Inc.

Circuit Check supports reading linear bar codes and 2D symbols within each of its fixture product lines.When spring-loaded probes are not practical or access is limited, Circuit Check can help you with thru-connector tests to contact connectors on any surface or edge of a circuit board. These tests can be implemented spring probes, mating connectors, sacrificial SMT connectors, and stabber cards.

Product

High Voltage Differential Probes

DP Series

-

Shenzhen Micsig Instruments Co., Ltd.

DP Series - Shenzhen Micsig Instruments Co., Ltd.

*Micsig DP Series High Voltage Differential Probes can be used with any brand of oscilloscope. *It adopts high-impedance isolation between the input and output to protect personal safety, converts the input high-voltage signal to a low-voltage signal for observation and analysis on oscilloscope.

Product

Clamp Meters

-

Beha-Amprobe

Beha-Amprobe

Is an electrical test tool that combines a basic digital multimeter with a current sensor. Clamps measure current. Probes measure voltage.

Product

CAM/GATE Test Kits

Series 45

-

Semco Machine Corp.

Series 45 - Semco Machine Corp.

The CG Series 45 CAM/GATE linear over clamp kits utilize the same patented “Z” axis motion as our CAM/TRAC® Series products offering precise Z axis linear motion when testing higher point count and finer pitch test centers. By using the Z axis motion, side load of the test probes is minimized thus increasing probe life and performance. The latch assembly engages and disengages when actuating the clamping assembly. The CAM/GATE utilizes a cam roller system for precision guiding and smooth operation and 1.00” push plate movement. The gate assembly is movable to three different positions which allows for the versatility of top side probing, or relocating the frame assembly for PCA’s the have tall components

Product

Multi-Channel Anemometer

1550/1560 Series

-

KANOMAX USA, Inc.

1550/1560 Series - KANOMAX USA, Inc.

Kanomax Multi-Channel Anemometers are research-grade airflow measuring instruments designed for high performance and precision. When coupled with our highly accurate probes this four-channel anemometer provides highly accurate and reliable data readings. It features a LCD display that displays the data from each channel. The Our 1550 & 1560 models house module bays for the connection of up to 24 channels (model 1560) or 64 channels (model 1550) of simultaneous air velocity measurements. Each bay accepts one of five unique modules allowing for a wide variety of custom configurations for air velocity, temperature, and humidity measurement. For a larger system, you can connect up to 5 units in a cascade for up to 320 air velocity channels and transfer the data to your company computer.

Product

I-V Measurement Systems

-

Photo Emission Tech., Inc.

Photo Emission Tech., Inc.

The I-V Curve Data Acquisition includes a fixture for holding cells for testing (see Figure 1 below). This fixture can accommodate cells from small to up to 100 mm x 100 mm. Adjustable cell stops, in the X & Y-axis, are provided to consistently locate the cells for testing. Two micro-manipulators are provided as shown in Figure 1. Each micro-manipulator has two spring loaded contacts to allow 4-wire measurement even for cells that have top contacts only. Two back-side voltage contacts are embedded in the Plate (galvanically isolated from the Plate) and make good electrical contact when the cell is held down by vacuum to the plate. All voltage and current probes are gold-plated. The cell is held down with vacuum during testing (built-in vacuum pump).

Product

Color Probe

AS56-F

-

optek

AS56-F - optek

AS56-F is a probe for direct installation into pipelines and vessels measuring VIS light absorption of various liquid samples. Optical path length can individually configured to meet the process control requirements.

Product

Tooling And Fixturing

-

EIIT, S.A.

EIIT, S.A.

Control develops and supplies fixtures and test accessories :*For a vast field of applications - ICT (In-Circuit Test), functional test, Flash programming, EoL (End-of-Line) test systems, etc.*For all handling systems currently used in the market: online or offline, mechanical, pneumatic or vacuum operation*From simple mechanical fixtures, with a few hundred probes and low production volumes, to highly complex accessories with thousands of probes, double-sided probes, double acting, etc.

Product

Standard Type Spring Probes

-

KITA Manufacturing Co.,Ltd.

KITA Manufacturing Co.,Ltd.

From for bare board to for ICT, we have variety of spring probes for PCB. In addition to variety of tip type and total length, we also have receptacles that match the best to spring probes. We can also attach lead wire to the receptacles.

Product

Gaussmeter And Teslameter

-

MAGNET-PHYSIK Dr. Steingroever GmbH

MAGNET-PHYSIK Dr. Steingroever GmbH

The FH series offers compact devices from simple battery-operated handheld meters to versatile laboratory meters. The meters display the field strength in Tesla, Gauss or Ampere per meter. A standard sample is included in the price of each meter. Hall probes for older Gauss meters are available on request.

Product

8VSB/QAM And ASI Analysis Probe For USB-2

DTU-236A

-

DekTec Digital Video B.V.

DTU-236A - DekTec Digital Video B.V.

DekTec's USB-2 hardware-based analyzer for 8VSB and QAM. Equipped with advanced RF measurement options and designed to operate USB powered, this is a very convenient tool for analysis in the field.

Product

Temperature and Humidity Transmitter

T3319-2

-

COMET SYSTEM, s.r.o.

T3319-2 - COMET SYSTEM, s.r.o.

Humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.

Product

Probe Accessories for AP033/34

PK033

-

Teledyne LeCroy

PK033 - Teledyne LeCroy

Probe Accessories for AP033/34.

Product

Waterproof pH/mV Meter with ATC Probe

CyberScan pH 610

-

Eutech Instruments

CyberScan pH 610 - Eutech Instruments

6 calibrations points and 20 auto/manual buffer options sets for quick, convenient calibration. Cal-Due Alarm Prevents Out-dated Calibrations, while Set-Point Alarms warns when readings are outside set-point limits.

Product

Non-Rotating Probes

-

Equip-Test Kft.

Equip-Test Kft.

Blade terminal housing test - fixed angles for tips - easy to change.