Product

Low Voltage DC / Battery Powered HV Amplifiers

WMA-02 And WMA-02LF

-

Falco Systems

WMA-02 And WMA-02LF - Falco Systems

The Falco Systems WMA-02 is a high voltage amplifier that runs from an 24 - 30V DC power supply and can be battery powered if required, e.g. for use in a Faraday cage. Its internal high voltage generator is inductor-free and hence does not spread magnetic interference in sensitive experimental setups. The output noise is impressively low at 4mVrms. For extremely low noise applications where bandwidth is not an issue, a dedicated WMA-02LF version is available that contains an output low pass filter capacitor which reduces the bandwidth to 50Hz, but makes the noise drop to below 0.2mVrms. This bandwidth-limited amplifier is ideal for MEMS or piezo positioning with manual voltage adjustment.

Product

Antenna Rotator

PRO.SIS.TEL

-

Array Solutions

PRO.SIS.TEL - Array Solutions

This manual cover installation on a mounting plate inside a tower or a rotator cage with a thrust bearing. The rotator consists of a rotator and a control box unit.

Product

Analog Output Module, 16-bit D/A

IP231

-

Acromag, Inc.

IP231 - Acromag, Inc.

The IP231 outputs analog voltage signals to drive up to 16 devices. When used with a carrier that holds four IP modules, up to 64 voltage outputs can be obtained from a single card cage slot.

Product

Type 12R2, 8U, 19" Rackmount, MIL-Rugged, Top Load

12R2-8U-TL

-

ELMA Electronic, Inc.

12R2-8U-TL - ELMA Electronic, Inc.

The 8U, 12R2 is designed to meet the harsh environment of shipboard, airborne, and ground mobile applications per MIL-STDs. Shock isolated versions are designed to attenuate 25G shock inputs to the chassis to less than 10Gs at the card cage.

Product

VME Test Extender 3U/220mm J2

111EXT3122-12XX

-

ELMA Electronic, Inc.

111EXT3122-12XX - ELMA Electronic, Inc.

The VME extender boards are designed to bring a circuit card completely out of a card cage so that it can be tested or debugged on both sides of the test board. Each signal, power, and ground line can be individually isolated with the DIP switches.

Product

L-Frame, CompactPCI Serial, 5 Slots, SSR, 6U, 32HP, 299mm

632V0-E05R-50FA1-000

-

ELMA Electronic, Inc.

632V0-E05R-50FA1-000 - ELMA Electronic, Inc.

CompactPCI Serial System Type L-Frame with 5 Slots: 4x CompactPCI-S.0 Peripheral Slots and 1x CompactPCI-S.0. 1x 550W ATX, air-cooled with fan fix-mounted.Vertical backplanes and have a 160mm card cage in the front and a 80mm rear I/O.

Product

High Speed Caged Ball

SBK

-

THK America, Inc.

SBK - THK America, Inc.

High Speed Caged Ball Ball Screw. THK high speed caged ball ball screw type SBK that eliminates collisions and friction between ball and prolongs the effectiveness of grease by utilizing the caged ball mechanism. This mechanism reduces a noise level, torque fluctuation, and a long maintenance-free period. 

Product

Picoamp Booster and Faraday Cage

CHI200(B)

-

CH Instruments, Inc.

CHI200(B) - CH Instruments, Inc.

With the CHI200(B) Picoamp Booster and Faraday Cage, current down to a few picoamperes can be readily measured. The CHI200 is compatible with the Model 600/A, 700/A series of instruments, while the CHI200B is compatible with Model 600B/C and 700B/C series. When used with 700/A/B/C series bipotentiostat, the Picoamp Booster will affect the primary channel only.

Product

Die-cast Rotor Tester

AIP868X series

-

Qingdao AIP Intelligent Instruments Co., Ltd

AIP868X series - Qingdao AIP Intelligent Instruments Co., Ltd

Introducing the international testing technology and developing special sensor according to digital signal processing method, the die-cast rotor tester able to automatically analyze and judge the filling quality of die-cast rotor.This system is applied to all kinds of cast aluminum and copper rotors, such as: cast aluminum rotor of compressor motor, cast aluminum rotor of washing machine motor, cast aluminum rotor of fan motor, cast aluminum rotor of pump motor, rotor of automobile motor and three-phase asynchronous motor, etc. The main detection functions are: broken bar, fullness of the bar (thin bar, hole, bubble and porosity ), leakage between the squirrel cage and lamination, squirrel cage eccentricity, slot deviation.Test items: broken bar, thin bar, maximum amplitude value, minimum amplitude value, comprehensive value.

Product

VME Test Extender 9U/220mm J1/J2/J0

111EXT9122-0120

-

ELMA Electronic, Inc.

111EXT9122-0120 - ELMA Electronic, Inc.

The VME extender boards are designed to bring a circuit card completely out of a card cage so that it can be tested or debugged on both sides of the test board. Each signal, power, and ground line can be individually isolated with the DIP switches.

Product

VME Test Extender 6U/220mm 64X w/o P0

116EXT6122-012XR

-

ELMA Electronic, Inc.

116EXT6122-012XR - ELMA Electronic, Inc.

The VME extender boards are designed to bring a circuit card completely out of a card cage so that it can be tested or debugged on both sides of the test board. Each signal, power, and ground line can be individually isolated with the DIP switches.

Product

EMF Measurements/EM Measurements/Electromagnetic Radiation

-

Holland Shielding Systems B.V.

Holland Shielding Systems B.V.

Electromagnetic fields cause interference in electronic devices and may affect the health of people close to where the fields are generated. It is important to recognize this at an early stage in a construction process, for instance at a future construction location or while construction is already underway, so that budgets are not exceeded. By means of field-strength measurements one can chart the existing electromagnetic fields and radiation emitted by GSM, UMTS antennas and transformer spaces, to mention a few examples. These measurements can help determine the best location in the new building for rooms where sensitive measurements are to take place, e.g. in hospitals or nano laboratories. And last but not least, field-strength measurements can detect sources of interference and can be part of a scheduled check of existing screened spaces and Faraday cages.

Product

Highly Dynamic XY Linear Motor Scanning Stage

L-731

-

Physik Instrumente GmbH & Co. KG

L-731 - Physik Instrumente GmbH & Co. KG

The magnetic linear direct drive is designed to provide high velocity and acceleration for inspection and microscopy. With a travel range of 205 mm square and solid velocity to 100 mm/sec, the L-731 is equipped to deliver high accuracy and smooth motion. Precision crossed roller bearings with anti-creep cage assist enable superior guiding accuracy (1.5 m straightness for loads up to 20 kg). An integrated optical reference encoder and limit switch provide further positioning control and accuracy for this compact stage with 5 nm resolution. DC servo motor versions are available on request.

Product

VME Test Extender 6U/400mm J1/J2

111EXT6140-012X

-

ELMA Electronic, Inc.

111EXT6140-012X - ELMA Electronic, Inc.

The VME extender boards are designed to bring a circuit card completely out of a card cage so that it can be tested or debugged on both sides of the test board. Each signal, power, and ground line can be individually isolated with the DIP switches.

Product

Freestanding Modular Faraday Cage

-

Holland Shielding Systems B.V.

Holland Shielding Systems B.V.

A freestanding (independent of the host building) prefabricated modular Faraday cage provides a superior screening of RF-signals and is applicable in a wide range of situations for a wide range of purposes as described below.

Product

VITA, Type 32V, Portable Tower Family

32V-VITA

-

ELMA Electronic, Inc.

32V-VITA - ELMA Electronic, Inc.

Elma Type 32V family of enclosures provide a lightweight, tower platform for packaging portable system applications. Designed to meet VITA & IEEE specifications. Systems can be configured with or without rear I/O card cage.

Product

Corrosion Inhibitor Evaluation

ASTM G202

-

Metal Samples Company

ASTM G202 - Metal Samples Company

Metals Samples provides solutions to study the performance of corrosion inhibitors in the laboratory. The Rotating Cage is helpful in selecting corrosion inhibitors for use in oil and gas production pipelines and facilities, transmission pipelines, as well as in oil refineries. It simulates aggressive field flow conditions that cause localized pitting corrosion in a simple laboratory setup. The precision, i.e., repeatability and reproducibility, of the rotating cage has been established (ASTM G202).

Product

2-in-1 High-Voltage Test Hood

LX-HVE900EC

-

LXinstruments GmbH

LX-HVE900EC - LXinstruments GmbH

The test cells are made of stable, highly insulating plastic and are closed by a swiveling, transparent cover. The built-in safety switch is used to lock the hood and release the high-voltage sources. This ensures that no high voltage is active when the door is open. There is a generously dimensioned wiring space in the floor of the test cage. An interchangeable adapter plate in the test cell - optionally with an interchangeable interface or an interchangeable adapter cassette - allows quick adaptation to different types of test items. Prepared openings enable connectors and other common interfaces or cable bushings to be easily attached. The hood is opened and closed almost effortlessly thanks to precisely coordinated gas springs.

Product

7 Slot VME64x Portable Tower Development Platform

32V07OP448N3VCB0

-

ELMA Electronic, Inc.

32V07OP448N3VCB0 - ELMA Electronic, Inc.

Elma Type 32V family of enclosures provide a lightweight, tower platform for packaging portable VITA System applications. Designed to VITA & IEEE. Systems can be configured with or without rear I/O card cage.

Product

PCI Termination Products

-

Acromag, Inc.

Acromag, Inc.

Acromag provides a broad selection of hardware accessories to simplify the use of our I/O boards. This collection of panels, cables, and adapters facilitate field wiring and cable connections between boards within the card cage. Select from an assortment of cables and termination panels to simplify wiring and installation.