Elemental
of the periodic table.
-
Product
Field Sensor
TR_B
-
The terraTEM TR_B Field surface sensor has been fully integrated to work seamlessly with the terraTEM. Recording three components of the Earth’s magnetic field simultaneously, the TR_B Field sensor comes with solid state rotation elements to be used in conjunction with the terraTEM inbuilt rotation software. The sensor also has automatic nulling of the ambient B-field.
-
Product
Diode Power Sensor
8487D
Power Sensor
Excellent SWR for reducing mismatch uncertainty Accurate calibration and traceability to US National Institute of Standards and Technology (NIST) millimeter-wave sensor calibration Compatible with EPM (new N1913A/ 14A, E4418B/ 19B), EPM-P (E4416A/ 17A) and P-series (N1911A/ 12A) power meters, plus the E1416A VXI and discontinued 70100A and 43X power meter Accurate average power measurements over -70 to -20 dBm Frequency range 50 MHz to 50 GHzDiode power sensing element
-
Product
Imaging X-Ray Photoelectron Spectrometer
Kratos AXIS Nova
-
X-ray photoelectron spectroscopy (XPS), also known as electron spectroscopy for chemical analysis (ESCA), is a mature and widely used surface analysis technique for materials characterisation. XPS provides quantitative elemental and chemical state information from the upper most 10 nm of material. The The AXIS Nova photoelectron spectrometer can collect X-ray photoelectron spectra and images from any material that is stable under the ultra-high vacuum conditions required for the technique.
-
Product
Vessel For Testing Bob Elements
IEC60335-2-6 Figure101
-
Shenzhen Chuangxin Instruments Co., Ltd.
IEC60335-2-6 Figure 101 Aluminium Test Vessels also conforms to the clause 3.1.9.108 of IEC60335-2-9.The IEC60335-2-6 Figure 101 Aluminium Test Vessels is made of unpolished commercial quality aluminium.
-
Product
Resistance Temperature Detectors
-
Sensors used to measure temperature by correlating the resistance of the RTD element with temperature.
-
Product
Moisture/PH/Alcohol Testers
-
The soil is one of the most basic elements for plant life.Check pH of the soil and add the proper amount of lime to the soil necessary for neutralization.
-
Product
Linear Actuators
-
Electrical linear actuators of the LME... / RSD ... series are the optimal solution for the operation of final control elements with preferably linear movement. The internal rotary / linear conversion is done virtually wear-free and the actuator thrust rod transfers the force directly to the final control element.
-
Product
Temperature & Humidity Transmitter
HTO
-
- CO2 measuring element: NDIR Sensor 2- CO measuring element: Electrochemical sensor- Temperature/Humidity sensing element : CMOS sensor- Analog output option:4~20mA or 0~10V- Communication output option:RS485 Modbus RTU- Configured by PC with free software via USB cable (option)- Present value offset adjustable- Inside buttons for adjust output parameters- LCD backlight color to Indicated CO/CO concentration 2- Temperature measuring range can be -50~100℃ via USB console port to setting
-
Product
Composite Material Behavior Software
Helius Composite
-
Helius Composite software offers detailed information on composite material behavior without finite element analysis (FEA). Use Helius Composite to integrate materials into your designs.
-
Product
Humidity Sensors
-
ST’s digital humidity and temperature sensor is based on a planar capacitance technology that integrates the temperature and humidity sensors in the sensing element.
-
Product
Thermal Load Boards
-
Thermal Engineering Associates, Inc.
A Thermal Load Board (TLB) is used to simulate an application printed circuit assembly (PCA) either before all the heat-producing components are available for mounting on the application PCA or if the heat-producing components require complex electronic circuitry to create heat within the components. The TLB is typically designed to be as mechanically and thermally equivalent to the application PCA and usually offers a way to vary the power dissipation of the elements that simulate the heat-producing components.
-
Product
Temperature Logger for PT100 Probe-50 to +300/600C
TV-4104
-
This data logger uses an external PT100 probe to record high temperatures. Probes are available to measure up to 300 and 600C. These are listed in the 'You will also need' section. The PT100 probes are of 3-wire construction and use class A elements.
-
Product
Secondary Ion Mass Spectrometry (SIMS Analysis)
-
Rocky Mountain Laboratories, Inc.
Secondary ion mass spectroscopy is operated either in the dynamic mode (DSIMS) or the static mode (SSIMS). DSIMS is useful for profiling impurity and trace elements through films and interfaces. SSIMS is useful for characterizing polymeric materials and only measures the outermost molecular layer of a specimen.
-
Product
Pressure Sensors For Blast Testing
-
Pressure sensors with quartz, ceramic and tourmaline sensing elements are used for a wide variety of shock wave, blast and explosive testing. All of these applications require high frequency response and durability, ability to drive long cables and operate in adverse environments.
-
Product
AC/DC Digital Clamp Meter
SK-7720/SK-7722
-
Up to 1000A AC/DC.Conductor dia. : Φ36mm max.True RMS.Dual measurement and display.(Two electrical elements can be measured together)Peak hold and MAX/MIN functions.Temperature Measurement.Dust proof and water resistant.Analog output terminal (SK-7722)
-
Product
K-Band Silicon SATCOM Rx Quad Core IC
AWS-0102
-
The AWS-0102 is a highly integrated silicon quad core IC intended for satellite communications applications. The device supports four dual polarization radiating elements with full programmable polarization flexibility. The device provides 22 dB of gain with a noise figure of 3.4 dB. Additional features include gain compensation over temperature and temperature reporting. The chip features ESD protection on all pins, operates from a +1.8 V supply, and is packaged in a 56 lead 7x7 mm QFN for easy installation in planar phased array antennas.
-
Product
Through Hole/ Donut Load Cell (3.00 O.D.) Compression Only
THD SERIES
-
Our THD Series through hole donut load cells offer an outside diameter of 3.00 inches and up to nine different through hole diameter options per capacity range. These load cells are manufactured from heat treated 17-4 ph stainless steel. The sensing element incorporates bonded foil strain gages of the highest quality and are sealed for protection against most industrial Environments.
-
Product
X-ray Analytical Microscope (Micro-XRF)
XGT-9000
-
- <15µm probe size with ultra-high intensity without compromising sensitivity or spatial resolution. - High resolution cameras and multiple illumination modes to help capture images.- Dual types of detectors for transmission and fluorescent X-rays.- Detectable element range down to carbon with a light element detector.
-
Product
Average Reading Directional RF Wattmeter
81000-A
-
The Model 81000-A Wattmeter ... now you can measure RF Power in 50-Ohm coaxial cable and transmission lines, and accept plug-in elements in the range of 100 mW to 10 kW full scale, and from 0.45 to 2300 MHz.
-
Product
Triaxal Seismograph
BC 1313 TRIAXIAL SEISMOGRAPH
-
BC 1313 seismographs are seismic accelerometers, the parameter measured – vibration acceleration. For BC 1313 seismic transducers, the system is provided for sensing element electrical stimulation using an actuator to determine conversion ratio true value during periodic recalibration without dismantling. Power check system is also allowed for in BC 1313 seismographs.
-
Product
Laser-induced Breakdown Spectroscopy (LIBS)
LIBS
-
HORIBA designs and manufactures for Laser-induced Breakdown Spectroscopy (LIBS) very high resolution OEM spectrometers. Thanks to a low stray light aberrations corrected concave holographic grating (Jobin Yvon Technology), HORIBA LIBS spectrometer offers in a ~90x70x30mm footprint (without electronics) a very robust and accurate spectrometer.Adopt the HORIBA LIBS spectrometer to monitor the elemental fingerprint of your liquid, solid or gas samples.
-
Product
Salt Spray Chambers
-
Dongguan Amade Instruments Technology Co., Ltd
Salt spray chamber is intended to use method of salt-spray corrosion to evaluate the performance of corrosion resistance of specimens to salt fog under the specified conditions. It is capable of simulating a locally salt mist environment in which the test piece is placed. There are different types of salt fog chambers including microprocessor digital version, touch-screen control version and compound version featuring temperature&humidity control and adjustment. widely applied to components and parts, electronics elements, metal materials etc.
-
Product
Ultrasonic Thickness Gauge
45MG
-
The 45MG is an advanced ultrasonic thickness gauge packed with standard measurement features and software options. This unique instrument is compatible with the complete range of Olympus dual element and single element thickness gauge transducers, making this innovative instrument an all-in-one solution for virtually every thickness gauge application.
-
Product
Structural Testing
-
Structural testing is used to verify the static strength, or fatigue strength, of a component by applying measured loads. Testing can be done to failure, to contractual requirements, or to validate finite element model predictions.
-
Product
S-GW Functional Tester
-
The LTE SGW Functional Tester provides a wrap-around test solution for the Serving Gateway by emulating all the LTE network elements surrounding the SGW (System Under Test). The S-GW Functional Tester emulates an LTE eNodeB and other Core Network entities such as the MME, P-GW, S-GW, RNC and SGSN. It tests the S1-u, S11, S5/S8 , S12 and S4 interfaces of the S-GW.
-
Product
Radioactivity Meters
-
At PCE Instruments you will find three types of radioactivity meters: Alpha radioactivity meter, meter for Alpha, Beta and Gamma radioactivity, radioactivity meter for human beings. It is very important to measure radioactivity as well as to classify radioactivity values. An example of Gamma radioactivity: Terrestrial gamma radiation is measured according to general values from 0,03 – 0,3 µSv / h (micro Sievert/ hour). This "normal“ oscillation range is conditioned by contents in the ground of natural radioactive elements such as uranium, potassium, etc.
-
Product
Detectors
-
A detector head comprises one or more photodiodes each with an appropriate optical bandpass filter, diffuser, lens assembly, integrating sphere or other optical elements. Detector heads are calibrated in the Gigahertz Optik GmbH's calibration laboratory.
-
Product
Antennas And Related Products
-
Murata offers a range of antenna-related products, including LF-band RFID antennas meeting automotive standards, parasitic element coupling devices enabling wider bandwidth and more compact size, and the Radiation Interference Solution (Radisol).
-
Product
Pro Antenna Analysis Software
MININEC
-
MININEC Pro is an antenna analysis program for Windows and Macintosh computers. Any type of antenna may be analyzed. The physical design of the antenna is entered (such as the lengths of wires and elements). For a given frequency, the feedpoint impedance is calculated, along with theoretical efficiency.
-
Product
Inductively Coupled Plasma Spectroscopy (ICP-OES/MS), ICP Analysis Services
-
ICP-OES measures the light emitted at element-specific characteristic wavelengths from thermally excited analyte ions . This light emitted is separated and measured in a spectrometer, yielding an intensity measurement that can be converted to an elemental concentration by comparison with calibration standards. ICP-MS (ICP-Mass Spec) measures the masses of the element ions generated by the high temperature argon plasma. The ions created in the plasma are separated by their mass to charge ratios, enabling the identifcation and quantitation of unknown materials. ICP-MS offers extremely high sensitivity (i.e. low detection limits) for a wide range of elements
