Magnetic Susceptibility
Determines the maximum amount of Electro Static Discharge or Electrical Over Stress a piece of electronic equipment can withstand before damage is incurred.
See Also: Magnetic, Susceptibility, Magnetic Test, Magnetic Field, Magnetic Head, Magnetic Flux, Magnetic Stripe, Magnetic Permeability, H-field
-
Product
Magnetic Susceptibility Meter for Multi-Layer Survey
MULTI KAPPA
-
Multi Kappa instrument serves for fast field survey allowing both spot measurement and mapping by means of several probes. Together with GF Instruments traditional pocket magnetic susceptibility meters cover wide range of demands for accurate susceptibility measurement on ground surface, outcrops and samples of rock and soil. geological survey, archaeology, agriculture and forestry, raw material prospecting, mineralogy, sedimentology, detection of metallic objects, UXO survey.
-
Product
Helmholtz Coils
-
Helmholtz coils is a candidate test apparatus for low frequency magnetic field susceptibility testing on military equipment and subsystems. Use of this coils reduce electromagnetic compatibility (EMC) qualification tests time, and subject the equipment under test (EUT) to a relatively uniform field.
-
Product
Magnetic Susceptibility Meter
SM-20
-
The SM-20 magnetic susceptibility meter is very useful tool for a number of geological and geophysical applications where the unique sensitivity of 10-6 SI units together with its small, shirt-pocket size and low weight are appreciated.
-
Product
Cut Susceptibility Tester
-
King Design Industrial Co., Ltd.
Equipment conforms to IEC61730 MST12 specification. Pre- or post-round can be selected for control wiring connection. With weights block’s positioning pin is removed before test; and is inserted in the rear positioning hole for the remaining time. Equipped with rings at both front and rear end; used to connect a rope and control the driving direction. Use replaceable special cutting chip.
-
Product
Magnetizer
-
MAGSYS magnetizers allow the magnetization, adjustment and also the demagnetization of isotropic and anisotropic magnetic materials of different sizes. In particular, all highly coercive magnetic materials, such as Sm2Co17 or plastic-bonded NdFeB magnets, can be magnetized easily and with short cycle times. In addition to raw magnets, e.g. directly after production, complete workpieces with magnets already installed can also be magnetized.
-
Product
Magnetic Flaw Detector (Magnetic Yoke)
NOVOTEST MPD-DC
-
Magnetic Flaw Detector (Magnetic Yoke) NOVOTEST MPD-DC applies in circumstances where the electric equipment mustn’t be used or prohibited by the rules.
-
Product
Reference Magnet
-
Reference magnets generate a homogeneous magnetic field in an air gap. They are mainly used to calibrate hall probes for their full scale value of output for the magnetic field strength H or the magnetic flux density B they measure. For example Gaussmeters can be calibrated by using reference magnets.
-
Product
Magnetic Calibration
-
Trescal provides full Magnetic Calibration services that are accredited and/or certified in accordance with ISO/IEC 17025. Magnetic Calibration services can be delivered at your site or at our lab. Accreditations for our magnetic calibration service guarantees calibration results are traceable to the International Systems of units (SI) through NIST or NRC.
-
Product
AC Susceptibility
-
The AC Susceptometer option uses a small primary excitation coil to apply an AC field to a sample (typically 1mT at frequencies from 0.1 Hz 10000 Hz). A pair of secondary pick-up coils positioned close to the excitation coils are used to detect the sample response.
-
Product
Magnetizer
X-Serie
-
MAGNET-PHYSIK Dr. Steingroever GmbH
The X-series pulse magnetizers are designed in control cabinet construction. They offer a full range of functions and can magnetize up to 500,000 Ws at an energy of 8,500 Ws!
-
Product
Normal Magnets
-
MAGNET-PHYSIK Dr. Steingroever GmbH
Standards are used to calibrate measuring instruments. There is a corresponding standard for every measuring device and every probe. Take a look around and discover not only moment etalons and comparison magnets but also other high-quality products from the "Standards" category, which we offer you in the best quality and at absolutely fair prices.
-
Product
Magnet Tester
-
The Magnet Tester invented by JUNG locates magnetic fields and notify it with its integrated lamp: compact, simple and fast!Easily check switch conditions with zero set-up time and no need to halt operations. The magnetic field test stylus is an indispensable tool for countless companies and toolboxes. Its light-function also makes it as an ideal flashlight.
-
Product
Magnetic Testing
-
A method for detecting surface and slightly subsurface discontinuities in ferromagnetic material.
-
Product
Current Sense Magnetics
-
Current sense magnetics are used as a low loss method for sensing AC current in a circuit and also provide electrical and safety isolation between the source of the current and the measurement circuit. The key parameters for a current sense transformer are the rms current rating (to ensure it does not overheat in the application) and the safety and voltage isolation (to ensure it conforms to the end-application requirements).
-
Product
Linear Magnetic Encoders
-
Non-contact length measuring operations, cost-efficient and precise.
-
Product
Multi-Probe Magnetic Transducer
-
The Multi-Probe Magnetic Transducer (MPMFT) is an advanced multichannel measurement device designed for precise magnetic flux density-to-analogue voltage conversion. Tailored specifically for the F3B and F1A Hall probe types, this transducer system accommodates up to 10 individual transducers simultaneously. Equipped with up to six SENIS F1A Single-Axis Hall probes, this system excels in multi-point monitoring of complex electromagnetic systems, providing a high-accuracy, temperature compensated output signal for the Y component of the measured magnetic flux density. Whether it’s for quality control in the development of magnet systems, or for laboratory applications, the MPMFT guarantees superb reliability and precision.
-
Product
Magnetic Effects Test
-
This test determines if an object can operate normally in strong externally generated magnetic environments. The magnetic effect test helps to assist in determining the proper location of the equipment in the installation.
-
Product
Magnetic Field Meter
MP-1000
-
The List-Magnetik MP-1000 magnetic field meter is equipped with externally connectable transverse and axial field probes, making it easy to carry out precise magnetic field measurements. This versatile device is ideal for measuring direct, alternating (true RMS), and pulsed fields, making it suitable for a wide range of magnetic field measurement applications. It is also ideal for measuring residual magnetism.
-
Product
Magnet Analyzer
-
Since miniaturization and high accuracy is the most important theme in the motor industry, a progression in the field of magnetizing ripple analysis is demanded. Taking advantage of our spindle motor design experiences, we develop and manufacture many magnet analyzers with high accuracy, functionality, and operability. We also produce a magnet analyzer which fulfills each customer's needs.
-
Product
NMR Permanent Magnet
PM1055
-
A secondary field reference for NMR testing and Hall teslameters calibration.
-
Product
Magnetic Testing Instruments
-
Yuxiang Magnetic Material Ind. Co., Ltd.
Magnetic Testing Instruments for testing electromagnets and automatic hysteresigraph
-
Product
Magnetizer
K-Serie
-
MAGNET-PHYSIK Dr. Steingroever GmbH
The K-series magnetizers close the gap between the U-series tabletop devices and the X-devices in control cabinet design. By concentrating on the essential core functions, these pulse magnetizers are unbeatable in terms of price-performance ratio.
-
Product
Magnetizer
M-Serie
-
MAGNET-PHYSIK Dr. Steingroever GmbH
With a maximum energy of 5,000 Ws, the M-series magnetizers perfectly complement our standard range of devices. They offer the extensive functionality of the X-series in a compact housing that is mobile and flexible in use.
-
Product
Magnetic Field Sensor
-
Vernier Software & Technology, LLC
The Magnetic Field Sensor can be used to study the field around permanent magnets, coils, and electrical devices. It features a rotating sensor tip to measure both transverse and longitudinal magnetic fields.
-
Product
Magnetic Stripe Card Reader
UTC-100P-M
Card Reader
Card Standard: ANSI/ISO Standards 7810,7811-1~6, 7813. Read Speed: 3 ips to 100 ips (7 cm/s to 250 cm/s). TRACK 1: IATA / 210 bpi / 79 Alphanumeric Characters.
-
Product
Electronic Magnet Pole Finder
MPF-120
-
The hand-held electronic magnetic pole finder / magnetic pole detector that instantly provides a positive reading of N or S polarity. Simple, push-button operation. Just point and read RED indicates NORTH, GREEN indicates SOUTH.
-
Product
Superconducting Magnet Systems
-
Fully integrated cryogen-free magnet systems. Choose from various options, from standalone to complete turnkey measurement systems. Helium-cooled systems are also available.
-
Product
Magnetic Field Generator
PFM61000-8A
-
PFM61000-8A Magnetic Field Generator is high reliability test equipment with stable performance, specially designed for electrical and electronic products for measuring immunity characteristics and requirements of normal frequency magnetic fields. It provides an accurate basis for the tested equipment in the immunity test of normal frequency magnetic field. The generator can imitate the magnetic field environments such as residential, commercial, industrial and mining enterprises, power plants, as well as middle and high substation. It fully meets IEC61000-4-8 and GB / T17626.8 standards.
-
Product
Magnetic Encoders
-
The magnetic encoder detects rotational position information as changes of the magnetic field, converts them into electrical signals, and outputs them. The simplest magnetic encoder consists of a permanent magnet and a magnetic sensor.
-
Product
Hall (Magnetic) Sensors
-
Small, compact axial and transverse Hall generators for measuring flux density. Available for use at cryogenic temperatures.
