Monitoring
-
Product
MIL-STD-1553 XMC Interface Module
XMC-1553
-
Avionics Interface Technologies
Dual redundant, single, dual, or quad stream configurations - Transformer & Direct Bus Coupling - Concurrent Bus Controller, 31 Remote Terminals, & Bus Monitor operation - Full error injection and detection - Multi-level trigger for capture and filtering - IRIG-B time code encoder/decoder - Ten high voltage (up to 30V) programmable DIO lines - Real-Time recording and physical bus replay - ANSI Application interface supporting C, C++, C#, and .NET development - Device driver support: Windows, Linux, VxWorks, & LabVIEW Real-Time (others on request) - Conduction-cooling and/or conformal coating availableDesigned for extended temperature operations - x1 Lane PCI Express Host Interface - Rear (P14) and Front Panel Input/Output - Compatible with AIT’s Flight Simulyzer GUI Bus Analyzer Software
-
Product
kSA BandiT
-
The kSA BandiT is a non-contact, non-invasive, real-time, absolute wafer and thin-film temperature monitor used during thin-film deposition and thermal processing.
-
Product
Protocol Test Family
-
The VIAVI Protocol Test product family provides scalable end to end protocol analysis of multiple mobile technologies for issues that occur at any time (including in the past) for multiple users in a fraction of the time. The product family also supports Virtual Ethernet lifecycle management solution for test, service activation, performance monitoring and troubleshooting on all network layers.
-
-
Product
SF6 Gas Online Monitor Test System
KVXJ
-
KV Hipot Power Test Equipment Co.,Ltd
KVXJ SF6 Gas Online Monitor Test System is mainly applied on 35KV SF6 500KV, 220KV, 110KV GIS in the substation to monitor the SF6 gas leakage in the SF6 combined electrical equipment room environment and the oxygen content in the air in real time.
-
Product
8000
Performance Series
-
This accurate, durable, and simple to install iEquus 8000 Performance 2 5/8 in. mechanical temperature gauge features race inspired styling, superior 270-degree sweep for enhanced resolution, white dial, satin silver aluminum bezel, and backlit illumination for efficiently monitoring engine oil temperature.
-
Product
Composite 2×12 Video Distribution Amplifier
VDA212RM
-
Video Distribution Amplifiers (sometimes called a video splitter – not to be confused with a video split screen controller such as our PXD510E split screen controller) are typically used for connecting a camera or other video source to several monitors that do not have “looping” inputs. In this situation, each monitor has a permanent 75 ohm termination. With two non-looping monitors connected together, the line would be double loaded and result in a dim picture on each monitor. Using a Video Distribution Amplifier will solve this problem by driving each monitor individually at 100%.
-
Product
LED Driver Aging Rack
LEDRACK-100W192P
-
• Application range: LED driver and multi channel driver power aging. It has equipped with computer operation and monitor system. The working condition can be set by the computer, and the computer will record real time data to do statistical analysis. • The parameters of load can be set freely on the software, to monitor the real time voltage, current, and power etc • Load mode: CC, CV, CR, CP, and LED • Aging Control System includes: ON/OFF control signal output; Signal of relay switch control; K type thermocouple temperature acquisition • The channels are parallel connected under arbitrary load mode, which can allow product power expansion • The LED Driver Aging rack will design according to customer’s LED driver power and aging quantity per time • Automatic current switching function (optional) • AC power meter to measure modules, and test power input characteristics (optional) • Temperature monitoring function at product zone (optional) • PWM dimming and two sets of logic control signal function (optional)
-
Product
Management
-
It enables users to provision, monitor, manage and search data while organizing it in logical data containers, in a simple and intuitive way regardless of its data type. It enables multi-tenancy and secure data sharing between different business units and it simplifies IT operations through proactive and automated management.
-
Product
Large Format Infrared Inspection Windows
FLIR IRW-xPC/xPS Series
-
The FLIR IRW-xPC/xPS joins the existing FLIR IR Window family to help you inspect more efficiently, make inaccessible components accessible, and save money by preventing unplanned downtime. The rectangular polymer windows are impact resistant and provide the largest viewing area available to monitor completely undisturbed assets inside energized electrical equipment. IR Windows-xPC/xPS are durable and stable in harsh environments, making them suitable for most industrial settings as well as for shipboard use.
-
Product
LED Analytics
colorCONTROL MFA
-
The colorCONTROL MFA is used for measurement of color and intensity on LEDs, displays, and colored objects. An additional benefit is the flexible positioning of the small fibers to the targets. By utilizing the colorCONTROL MFA up to 495 measurement points can be monitored simultaniously.
-
Product
Liquid Particle Counters
-
Provides groundbreaking capabilities for monitoring the most demanding de-ionized and ultrapure water systems.
-
Product
In-line Sensor & Auto Range Switching Concentration Monitor
HF-960EM
-
Measures a wide range of HF concentration from low concentration to undiluted liquid. The HF-960EM achieves high precision measurement by the auto-correction range switching function. Also has the capibility of cleanliness with all PFA sensors. Measurement range: 0 - 50%.
-
Product
Human Vibration Monitor
HVM200
-
The HVM200 is a small rugged vibration meter with built in Wi-Fi that can be used to measure hand-arm, whole body and general vibration. It includes the metrics and frequency weightings needed to measure human vibration. This 3 channel meter meets the requirements of ISO 8041:2005 and it is designed to measure per ISO 2631-1, 2 & 5 and ISO 5349 in support of the American Conference of Governmental Industrial Hygienists (ACGIH) Threshold Limit Values (TLVs) and the directive 2002/44/EC. This makes the HVM200 an ideal choice for an instrument used to demonstrate compliance with human vibration requirements and regulations worldwide.
-
Product
Noise & Vibration Tester
-
System PC Based particularly suitable for vibration and noise measurements for the characterization of mechanical, electromechanical and electroacoustic and for the control and monitoring of installations of production. Complete configurability for the use of platforms PC (Notebook, desktop, PXI) suitable to applications of both static labotatorio, both dynamic (eg road-test) and also in the production line (functional tests and monitoring).
-
Product
55" UHD Industrial Digital Signage Monitor & Touch
DSD-3055
-
Superior Resolution UHD (3860 x 2160) Contrast 4000 :1, Ultra-Wide Viewing Angle (178°) Response time : 6.5ms. Power consumption 145 W, Life time 50,000 hrs, Fanless design.
-
Product
Battery Module
-
Each Gavia Battery Module contains several independent "smart" Li-Ion battery packs and battery chargers. Each battery pack is monitored for health and operational information, and the battery packs are protected against short-circuit and overcharge. The Battery Module also contains an intelligent power management processor.
-
Product
Dual-Port HS-1760 Test & Simulation PXI Express Module
PXIe-C1760
-
Avionics Interface Technologies
3U PXI form factor fits into PXIe or PXI hybrid slotTwo independent ports programmable as NC or NT(s) simultaneouslyTwo SFP sockets accepts FC-0 AS5653 or AS5625/AS5627 transceiversSupports NC-to-NT transfers, NT-to-NC Transfers, Mode Codes, and BroadcastFull control of sequence and exchange managementSupports large file exchangesFull Monitoring of all Bus TrafficTriggering and FilteringFull Error InjectionSupports DMA for high speed streaming of data to/from the boardIRIG-B Time Code Encoder/Decoder for Data CorrelationOptional Special FC-0 physical layer compliance with SAE AS5653Optional fcXplorer Analyzer for decoding HS1760 frames
-
Product
Software
-
Software to help you easily use Silex technology, such as managing and monitoring Silex network products or implementing network functionality on USB devices.
-
Product
Vibration Analysis and Balancing Tools
-
PRÜFTECHNIK Condition Monitoring GmbH
Predictive maintenance tools for vibration analysis can help prevent machine failure and avoid costly production downtime. Our vibration analysis tools are used for condition monitoring on rotating equipment to help detect early component wear and damage. Vibration analysis and balancing are integral parts of any condition-based and predictive maintenance program.
-
Product
Ionic Contamination (Cleanliness) Tester
Zero-Ion
-
Current IPC standards now require ROSE testing for process monitoring. The Zero Ion ionic contamination tester fully complies with current IPC standards.
-
Product
IR Temperature Sensor with GigE (Manual Focus)
FLIR A35
-
The FLIR A35 is a thermal imaging temperature sensor for condition monitoring, process control/quality assurance, and fire prevention applications. The A35 integrates seamlessly into existing systems, offering comprehensive visual temperature monitoring. As part of the Ax5-Series, the A35 is among the only thermal imaging temperature sensors on the market to provide temperature linear output through GenICam™ compliant software.
-
Product
Temperature Transmitter
650
-
The Series 650 Temperature Transmitter combines low cost with small size making it ideal for a wide variety of HVAC, industrial and commercial multi-point temperature monitoring applications. Non-polarized terminals simplify connection to any 12-35 VDC power supply.
-
Product
Monitoring & Control Systems
-
PBE's Vantage software is designed to allow users to monitor real time data from a site remotely and accurately. Vantage allows for tracking, telemetry monitoring, alerting, and reporting of data to users. It can be configured to accept telemetry from almost any device via custom developed drivers. Capable of importing CAD maps and image files the mapping software offers a 2D GUI with icons. Vantage also offers historical playback of the data reported to replay a set timeframe. Reports are customizable and exportable to multiple common formats.The user configuration manager allows for user defined roles to grant or restrict access to and from all modules and features of those modules. The Electronic Tag Board module offers a tagging system designed to track assets that are checked in or out, while the Asset Summary module provides a list of assets with user selected telemetry streams and configurable alerts. Vantage provides location tracking and tagging, telemetry monitoring, ventilation control and reporting off data to users.
-
Product
Battery Load Bank
-
Foresight Electronics Co., Ltd.
Utility is used for battery systems range from 21-30V, if higher current is needed, two or more FST-24V units can be linked together. Discharge to Battery string voltage as 24V, Cell voltage as 1.2V/2V/6V/12V adjustable stop points and multiple alarm designs to control the discharge process intelligently 7inch LCD touch screen for easy operation and showing various parameters real time Support RS232 real time monitoring by PC or SD Card download data after discharge
-
Product
Thermalert Monitoring Thermometer
TH-5
-
The TH-5 is one of our most economical precision thermometers in the Physitemp product line. The TH-5 offers the same high accuracy (0.1°C ±1 digit) and resolution as all our other thermometers, but with a narrow temperature range. The TH-5 is ideally suited for either a laboratory or hospital setting where continuous temperature readings within the physiological range are sufficient.
-
Product
Bonnet EFS for Horizontal Wellhead Completions
-
This Electrical Feedthrough System design provides a high-reliability circuit for transmitting electrical signals from downhole gauges through the wellhead and Subsea Tree to the Subsea Control Module (SCM) for topside monitoring. The system incorporates Teledyne DGO's high integrity glass-seal technology in three critical pressure barriers for maximum long-term reliability. The feedthrough system creates a permanent connection to the Subsea Control Module when the tree is installed onto the wellhead. In addition, a permanent rig-based DHG cable termination is completed to connect the control line to the feedthrough system. The DHG connector is available with a variety of sealing packages, including fully testable, dual metal-to-metal sealing of all downhole tubing hanger interfaces.
-
Product
Dust Monitoring
-
There are 100-times as many deaths in the workplace caused by the inhalation of dust as there are from all other workplace causes combined. Protecting your workers’ health and welfare is a serious responsibility. Take some of that weight from your shoulders with the world’s most advanced Personal Dust Monitors.
-
Product
Wrist CCTV Test Monitor
M-IPC-200B
-
Fuzhou Metricu Technology Co Ltd
4 inch IP camera tester with analog, HD-TVI, HD-CVI, AHD, wrist design
-
Product
Capacitive Sensors
-
Capacitive proximity switches detect conductive and non-conductive materials that can be in a solid or liquid state. They serve the purpose of monitoring product levels in containers, checking contents in filling and packaging systems as well as detecting, positioning, monitoring and counting objects, e.g. in sequence control systems, conveyor belts.
