Backplanes
An interconnection structure allowing multiple printed circuit boards to coexist using a single bus.
-
Product
21 Slot, 3U PXIe Chassis
GX7200 Series
Chassis
The GX7200 Series mainframes are 21-slot PXI chassis that can accommodate up to 20 instruments as well as a PXI Express controller (an embedded CPU or a PXI bus expander interface such as the MXI). The backplane architecture supports Gen 2 PCI Express bus signaling and the use of both x1 or x4 system controllers. By offering a combination of PXI-1, Hybrid, and Express slots, the GX7200 offers users the ultimate in flexibility for general purpose as well as high bandwidth test needs.
-
Product
RF Coaxial Interconnect System VPX Compatible Rectangular Harness Solutions
VITA 67 Rectangular Harness
-
VITA 67 is a VPX standard for blindmate coax connectors that allows high density, high performance RF connections to be made between a backplane and plug-in modules.
-
Product
Backplane
P47
-
VECTOR Electronics and Technology, Inc.
Power supply backplane provide a modular approach for the addition of plug-in, hot-swap power supplies. As a result there is no need to modify expensive backplanes to incorporate redundant power supplies or N+1 configurations. Multiple power supply backplanes may be bridged together for additional power supply requirements.
-
Product
4U 20-slot Extended Rackmount Chassis
AX61492
-
*Three 5.25" and two 3.5" HDD drive bays*Three 12 cm hot-swap ball-bearing fans*Supports 20-slot backplane*Hot-swap redundant or PS/2 power supply supported
-
Product
8-Channel 250 MHz A/D with Virtex UltraScale+ HBM FPGA - SOSA Aligned 3U VPX
Model 5585
-
- Jade 5585 and 5586 FAQ- Complete radar and software radio interface- Wideband data acquisition- Multi-channel, multi-board synchronization for high channel count systems- High-bandwidth memory, FPGA logic and DSP density make this board a single-slot 3U VPX processing powerhouse- Exceptional dynamic range and analog signal integrity- Features Xilinx Virtex UltraScale+ HBM FPGAs- Eight 250MHz 16-bit A/Ds- 10 GigE Interface- 40 GigE Interface- Dual 100 GigE UDP interface- Optional VITA 67.3C optical interface for backplane gigabit serial communication- Compatible with several VITA standards including: VITA 46, VITA 48.11, VITA 67.3C and VITA 65 (OpenVPX™ System Specification)- Navigation Design Suite for software and custom IP development
-
Product
VME J1J2 Monolithic 8 slot
101VMEM108-0500R
-
VME J1J2 Monolithic backplane 8 slot, compliant with ANSI/VITA 1-1994. 8-layer stripline design Includes passive termination inboard and automatic daisy chain connectors.
-
Product
9U cPCI Chassis
DP-cPCI-8001
-
DP-cPCI-8001 is a compact high performance, high reliability 9U cPCI chassis.The DP-cPCI-8001 provides the right platform options to meet system integration needs. The chassis complies with the features defined by the CompactPCI specifications. Ruggedness, modular construction, integrated cooling and EMI-EMC protection are available. The DP-cPCI-8001is available with 4 -14 cPCI slot backplane and various power supply configurations.
-
Product
PXIe-1082DC, 8-Slot, DC Power Supplies, Up to 8 GB/s PXI Chassis
782946-01
Chassis
PXIe, 8-Slot, DC Power Supplies, Up to 8 GB/s PXI Chassis—The PXIe‑1082DC features a high-bandwidth backplane to meet a wide range of high-performance test and measurement application needs. It accepts PXI Express modules in every slot and supports standard PXI hybrid-compatible modules in up to four slots. The chassis supports DC inputs from 11 V to 32 V.
-
Product
PXI Prototyping Module, 1-Slot, 96-Pin Micro-D
40-225A-101
Prototyping Module
The 40-225A PXI Prototyping Modules are stripped down versions of the 40-220A PXI Breadboard series. These are very basic, low cost prototype modules. They have no PXI interface but do have access to fused power supplies from the PXI backplane.
-
Product
OpenVPX Chassis Platforms
-
With options for VITA 46/VITA 48 compliant specifications for VPX (with VITA 65 OpenVPX compliant backplanes), Pixus offers complete systems with power supply unit and backplane, fully assembled, pre-wired and tested. With a modular design approach, Pixus can offer virtually unlimited VPX chassis configurations for 3U and 6U boards. The VPX enclosures come in 1U-4U horizontal-mount (for 6U boards), 4U-5U vertical-mount (for 3U cards), and 7U, 9U, and higher chassis (for 6U OpenVPX boards).
-
Product
MTCA.4 Power Supply
-
To match the requirements of the next generation of “carrier grade” communication equipment the PCI Industrial Computer Manufacturers Group PICMG created in 2002 a new standard AdvancedTCA / ATCA. The ATCA crate backplanes are based mainly on 48V industrial power supplies. From this form factor evolve the Advanced Mezzanine Module carrier card AMC form factors defined in AMC.3 in types of single or double width.
-
Product
PXI Power Supplies
-
PXI is an abbreviation for PCI eXtensions for Instrumentation. It is based on the PCI architecture, a commonly-used standard in personal computers, with an industrial connector. A second connector adds instrumentation-specific signals to the backplane, like clock and trigger signals. Applicos is providing PXI modules that intend to close a gap in the portfolio of the big players such as National Instruments, Keysight, ADlink and others. We focus on special functions and above average performance. Also in PXI the Applicos culture yields excellence on noise, accuracy and other analog properties.
-
Product
CompactPCI Serial Backplanes
-
CompactPCI Serial (PICMG CPCI-S.0) supports high-speed serial data transmission of up to 12 GB/s. This means excellent computing power in your applications and incredible precision for automated work processes.
-
Product
SLSC RTIs
-
Rear Transition Interfaces (RTIs) are mounted at the rear side of the SLSC chassis as part of the backplane. The RTIs contact the signal and power connector of the SLSC card and provide a powerful and flexible solution to connect a wide range of industrial measurement equipment. The connectors and pinouts are designed to match the National Instruments (NI) standard. For this there is a wide choice of cables to connect the SLSC and the NI measurement units.
-
Product
PXI / PXIe Backplanes
-
PXI (PCI eXtensions for Instrumentation) is a PC-based bus platform for measurement and automation systems. PXI uses commercial PC-based PCI bus technology while combining rugged CompactPCI modular packaging, as well as key timing and synchronization features. While derived from cPCI, PXI adds the timing and synchronization features, among other things, that were not present in cPCI.
-
Product
F9 Systems CalBlade
-
The CalBlade backplane calibration fixture isdesigned to permit accurate and convenient impedance and transmission measurements of a HM-Zd backplane. The CalBlade is used to calibratethe logic card connector interface to the backplane rather than to the usual far-end of the coaxial measurement cables. Very accurate impedance, skew and propagation delay measurements are possible since parasitic fixturing effects are removed.
-
Product
XMC GPU, Video & Format Converter Messanines
-
Curtiss-Wright Defense Solutions
Curtiss-Wright XMC format converters, GPU, and video processors fit conveniently onto existing modules equipped with a mezzanine site saving a backplane slot. Field-proven, our rugged modules feature powerful capabilities, including various input, output, and performance level options to meet your requirements.
-
Product
2 Slot 6U VME 64x Backplane
DP-VME-7008
-
DP- VME-7008 is a 2 slot 6U VME 64x backplane designed to be used with VME boards. This module provides the interface and communication between 2 slot and the rear side mating for the rear boards.
-
Product
VME J2 14 slot
101VMEJ214-0900
-
VME J2 backplane 14 slot, compliant with ANSI/VITA 1-1994. The A+C rows are bussed in all slots. Also, row B has onboard, inboard termination.
-
Product
AdvancedTCA, Type 11A, 2U 19" Horizontal, DC
11A02FJB28Y3HMXX
-
Elma's ATCA, DC, 2U horizontal enclosure with backplane, and shelf mgmt. options. Pluggable and redundant fan trays, PEMs and shelf managers for availability (99.999%). Optimized via backplane signal integrity studies and chassis thermal simulation.
-
Product
1 PICMG® CPU, 1 PCI-E® x16, 1 PCI-E® x4, 4 PCI™ Slots Backplane
EBP-7E2
Backplane
- Segment: 1- Slots: 1 PICMG® CPU, 1 PCI-E® x16, 1 PCI-E® x4, 4 PCI™- Support ATX power supplies- Dimension: 328 mm x 206 mm
-
Product
PICMG 1.0 Full-Size Single Board Computers
Single Board Computer
PICMG 1.0 Single Board Computers (SBC) features comprehensive backplane support. The Slot SBC are the most flexible and expansible solutions for industrial applications.
-
Product
3U CompactPCI Serial 8-slot SSL w/ RTM w/ Ethernet
1CPCIS-308-L210
-
3U CompactPCI Serial Backplane with 8 CompactPCI S.0 slots, system slot left, with rear IO : 1x CompactPCI S.0 CPU slot, 7x CompactPCI S.0 peripheral slots, with connectors for RTMs (Rear Transition Modules) in slots 2 to 8, Ethernet full mesh.
-
Product
ATCA 5U 5 Slot Mesh
109ATCA505-300XR
-
The 5U 5-slot ATCA backplane is a 3X Replicated Mesh. However, Dual Star, 1X and 2X Meshes can all be implemented across the 5-slot backplane.
-
Product
CompactPCI Chassis for 3U
-
Advantech offers 3U or 4U height enclosures for 3U CPCI boards, with fan or fanless, and with CPCI legacy backplane or CPCI plusIO backplane.
-
Product
3U VME J1 Classic 2-slot With 12A Fastons
50510-202-3600
-
3U VMEbus J1 backplane 2-slot, VITA, termination passive inboard, daisy chain without power, power connection 12A fastons, I/O pins 13mm gold-plated, shroud (1P1) without latches.
-
Product
PXI Prototyping Module, 1-Slot no Connector
40-225A-001
Prototyping Module
The 40-225A PXI Prototyping Modules are stripped down versions of the 40-220A PXI Breadboard series. These are very basic, low cost prototype modules. They have no PXI interface but do have access to fused power supplies from the PXI backplane.
-
Product
PXI Digital I/O Module With Power Distribution - Without DC-DC Converter
40-228-002
Digital I/O
The 40-228 provides 32 channels of digital input and 32 channels of digital output, together with switched +12V, +5V, +3.3V and -12V supply outputs derived from the PXI backplane. The module is available fitted with a DC-DC converter (40-228-001) which provides an additional -5V supply ouput. Alternatively the module can be supplied with an industry standard footprint for a DC-DC converter (40-228-002) allowing the user to fit one of their own specification if required. The 40-228 includes a breadboard area that allows users to add their own circuitry to the module.
-
Product
VME64X 7U 3 slot with P0
101V64XM03-0621R
-
7U VME64x Backplane 3-slot with P0, compliant with ANSI/VITA 1.1-1997, VME extension, and VITA 1.7 Increased Current. The extra 1U provides room for extra power bugs or busbars. Includes termination passive inboard and daisy chain automatic active.
-
Product
Open Frame 3U 34HP Chassis
-
An open-frame solution for the open-minded engineer. With moveable rear profiles (up to 2.5mm,) 3U and 6U backplane compatibility options, air or conduction cooling options and the ease of fast and simple backplane interchangeability for fluid transition between VITA and PICMG bus architectures, the Hartmann Open Frame Chassis solution is the tool for customers who need versatility, accessibility and longevity.
