RF-LAMBDA Inc.
A manufacturer of radio frequency (RF) and microwave components, systems, and amplifiers.
- (888) 976-8880
(972) 767-5998 - sales@rflambda.com
- 4300 Marsh Ridge Rd
STE 110
Carrollton, TX 75010
United States of America
-
Product
TX / RX Module
-
RF Lambda’s TX /RX modules include both a block upconverter and downconverter. They can include front end amplifiers for lower noise figure or power amplifiers for high output power of signal conditioning and image rejection as required.
-
Product
Phase Shifter
-
A microwave network module which provides a controllable phase shift of the RF signal.
-
Product
Power Limiter
-
RF Lambda’s power limiters are used to protect downstream RF components and equipment. Both active and passive models are available with fast response time and high power handling.
-
Product
USB/Ethernet Control Step Attenuator
-
Digital control attenuators with Ethernet or USB control
-
Product
Phase Array Antenna System
-
Electronically steers radio waves without physical movement by using an array of antennas.
-
Product
Digital Step Phase Shifter
-
RF Lambda’s digital step phase shifters are designed to actively change the phase of an RF signal using digital TTL control signals. They are available in a variety of frequencies, phase shift ranges, and step sizes. Hermetically sealed options are available upon request.
-
Product
Power Amplifier (DC Powered)
-
RF Lambda’s DC solid state power amplifiers (PA) are used in a variety of applications and offer high output power, wide band operation and good linearity. Hermetically sealed options are available upon request.
-
Product
Variable Gain Amplifier
VGA
-
RF Lambda’s variable gain amplifiers (VGA) are standard amplifiers which include a gain control pin to allow the customer to tune the gain for various applications without sacrificing performance and eliminating the need to use a separate amplifier and attenuator. Hermetically Sealed options are available upon request.
-
Product
Isolator (Coaxial / Drop-In)
-
RF Lambda’s coaxial and drop in isolators are typically used to prevent unwanted reflections. They offer low insertion loss and high isolation and are available in a variety of frequencies and power levels.
-
Product
Manual Attenuator (Coaxial)
-
RF Lambda’s manual coaxial attenuators are used to control signal levels using a manual control knob or buttons. These are highly reliable and commonly used in test setups where the operator needs access to tune RF signals without the need for any digital or voltage control.
-
Product
USB/Ethernet Control Phase Shifter
-
RF Lambda’s USB/Ethernet control phase shifters use the same RF circuits as our digital step phase shifters to control the phase of an RF signal. Various frequencies and step sizes are available with the addition of a USB and ethernet port for easy interfacing to a computer or a network.
-
-
Product
RF Waveguide Load
-
RF Lambda’s waveguide loads are used at end of an RF signal chain to provide a good 50ohm match and dissipate any RF energy into heat. They are available in a variety of power levels and offer low VSWR.
-
Product
USB/Ethernet Control Step Attenuator
-
RF Lambda’s USB / ethernet control step attenuators utilize the same RF core as our standard digital attenuators only they incorporate a USB / ethernet controller to allow users to easily setup the control from any PC or network.
-
Product
Multiplexer
-
RF Multiplexers supporting commercial communication bands to reduce antennas and cabling.
