ORTEC
ORTEC is an industry leader in the design and manufacture of ionizing radiation detectors, nuclear instrumentation, analysis software, and integrated systems.
- 865-482-4411
- 865-483-0396
- ortec.info@ametek.com
- 801 South Illinois Avenue
Oak Ridge, TN 37830
United States of America
-
Product
Radiation Detectors
-
High Purity Germanium (HPGe) DetectorsSilicon Charged Particle DetectorsScintillation DetectorsORTEC is a leading supplier of solid-state, high resolution, semiconductor radiation detectors. These radiation detectors are used in research, commercial industry, environmental protection, health and medical physics, as well as homeland security to detect gamma-rays, X-rays, and charged particles.
-
Product
Time to Amplitude Converters and Calibrator
-
A Time-to-Amplitude Converter (TAC) can achieve exceptional precision by using an analog technique to convert small time intervals to pulse amplitudes. When a timing application demands picosecond precision, a time-to-amplitude converter is a prime candidate. A time-to-amplitude converter is a productive solution for measurements less than 10 μs when time resolutions from 10 ps to 50 ns are required.
-
Product
Gross Gamma Screening System
-
The Gross Gamma Screening system is intended for the rapid screening of urine samples for the presence of elevated radioactivity in a post-radiological event scenario. This system allows up to eight urine samples to be counted simultaneously in discretely shielded 3” x 3” NaI Well radiation detectors to quickly identify elevated radioactivity from personnel in the exposed population. This screening process provides critical information to Emergency Response Agencies and is accomplished with minimal operator training.
-
Product
Counters, Timers, And Ratemeters
-
ORTEC offers the broadest range of nuclear counters, timers, rate meters and multichannel scalers. Counters simply count the number of input pulses received during the counting period. Timers count pulses generated by an internal or external clock and are used to measure elapsed time, or to establish the length of the counting period. Rate meters provide a readout of the pulse count rate. Multichannel scalers count the number of events that occur during a specified time interval, referred to as the dwell time, resulting in a time-histogram of counts. “Standalone” and programmable computer controlled versions are available.
-
Product
Pulse Generators
-
Pulse generators provide electronic pulses which mimic events from radiation detectors and are useful in set-up, diagnostics, and noise measurement in spectroscopy systems.
-
Product
Digital Current Integrator
-
The ORTEC Model 439 Digital Current Integrator was designed to accurately measure DC currents or the average value of pulse currents such as produced by accelerator beams. It digitizes the input current by producing an output pulse for specific values of input charge. A front-panel switch permit the selection of three different amounts of charge (10–10, 10–8 or 10–6 coulomb) required to produce an output pulse. The instrument has a digitizing rate from 0 to 10 kHz to provide wide dynamic range on each setting and high-resolution readout without meter interpolation.
-
Product
Single Channel Analyzers
-
A single channel analyzer (SCA) produces an output logic pulse on the condition that the peak amplitude of its input signal falls within the pulse-height window that is established with two preset threshold levels. ORTEC provides two basic types or classifications of SCAs: non-timing SCAs and timing SCAs. Non-timing SCAs produce an output pulse if the input signal is within the window settings. Timing SCAs produce an output logic signal precisely related in time to the occurrence of the event being measured.
-
Product
Chemical Weapons Identification Systems
-
Portable Isotopic Neutron Spectroscopy (PINS) Systems have been deployed world-wide; increasingly, being deployed as part of national counter-terrorist efforts. PINS provides a non-contact and non-destructive means of identifying the CHEMICAL contents of "suspect" packages.
-
Product
Alpha Spectroscopy
-
Alpha spectroscopy is used to identify and quantify radionuclides based on the alpha particles emitted in the decay process. Similar to Gamma Spectroscopy, energy spectra are generated with high precision detectors and electronics and analyzed with special software. Typically, samples are measured following chemical separation to isolate the radionuclides of concern due to the complexity associated with correcting for these interferences with spectrum analysis software as is common for many Gamma Spectroscopy measurements.
-
Product
Multichannel Analyzers
-
Multichannel Analyzers (MCAs) are workhorse instruments in many scientific measurements. An MCA analyzes a stream of voltage pulses and sorts them into a histogram, or “spectrum” of number of events, versus pulse-height, which may often relate to energy or time of arrival. The stored spectrum may then be displayed and analyzed.
-
Product
Hand-held Radioisotope Identification Device
RadEAGLET
-
Combining a large, high sensitivity crystal with a proven and tested intelligent algorithm, the RADEAGLET can quickly, accurately, and simultaneously detect and identify up to six isotopes, typically in under 30 seconds. The RADEAGLET performs well, even in complex shielded or masked scenarios. ANSI 42.34 compliant, the RADEAGLET offers a user-friendly interface that is intuitive, simple to navigate, provides visually clarity, and utilizes an extensive array of alarms. Supports NaI(Tl) and LaBr3(Ce) to optimize performance across multiple applications.
-
Product
Silicon Charged Particle Radiation Detectors
-
ORTEC introduced the first silicon surface barrier detectors for charged particle spectroscopy in the early 1960’s. Since then, ORTEC has expanded the product line with more than ten different options to choose from.
-
Product
Gross Alpha/Beta Measurement Systems
-
Gross alpha/beta measurement is one of the simplest radioanalytical procedures which are applied widely as a screening technique in the field of radioecology, environmental monitoring and industrial applications. This procedure has been developed to determine whether radionuclide specific analysis is required to further characterize the water. Regular measurements of gross alpha and gross beta activity in water may be invaluable for early detection of radioactive contamination and indicate the need for supplemental data on concentrations of more hazardous radionuclides.
-
Product
Food Monitoring Systems
-
Is a system of repeated examination, measurement and evaluation of levels of undesirable substances, such as plant protection products, heavy metals and other contaminants, in and on food.
-
Product
Scintillation Radiation Detectors
-
ORTEC offers a variety of scintillation based radiation detector solutions including Thallium-activated sodium iodide [NaI(Tl)] and Lanthanum Bromide [LaBr3(Ce)].
Parent
-
Ametek Materials Analysis Division
The AMETEK Materials Analysis Division´s goal is to be the recognized market leading provider of world-class analytical systems, nuclear instrumentation and digital imaging solutions.
Siblings
-
Ametek Scientific Instruments
AMETEK Scientific Instruments has been recognized as a global leader in the design and manufacture of instrumentation for scientific research, particularly in the field of electrochemistry and weak AC signal recovery.
Siblings
-
SPECTRO Analytical Instruments GmbH
Elemental analysis is continuing to develop at a fast pace worldwide with the need for ultimate precision, complex system requirements, and expanding fields of applications for even routine operations. SPECTRO leads the progress advancements in this field by providing new solutions and continuous innovations.
Siblings
-
Vision Research Inc.
Vision Research is the manufacturer of the phantom cameras and that their parent company is Ametek.
Siblings
-
Amptek Inc.
A high technology company and a recognized world leader in the design and manufacture of state-of-the-art nuclear instrumentation for the satellite, x-ray and gamma ray detection, laboratory, analytical, and portable instrumentation industries.
Siblings
-
CAMECA
The CAMECA instruments provide elemental and isotopic composition data from micron down to sub-nanometer scale and equip the most prestigious government and university labs as well as leading high tech industrial companies around the world.
Siblings
-
EDAX
EDAX is now combined with Gatan to develop new approaches to uncover insights and explore the boundaries of your transmission and scanning electron microscopy (TEM and SEM) research. Under the Gatan name, customers will receive reliable, cutting-edge products of the highest quality while maintaining the responsive customer care that you expect.
