VEGA Grieshaber KG
VEGA is a global manufacturer of level measurement sensors, point level switches and pressure transmitters.
- 513-272-0131
- 513-272-0133
- americas@vega.com
- 3877 Mason Research Pkwy
Mason, OH 45036
United States of America
-
Product
Guided Wave Radar
-
A top-down, direct sensing technology that uses low-energy microwave pulses sent down a probe to accurately detect the boundary between two immiscible liquids.
-
Product
Components
-
Electronic devices and circuits that manipulate, transform, and refine sensor signals to make them suitable for measurement, recording, or control systems.
-
Product
Interface Measurement
-
Interfaces, that is, boundaries between separation layers, can be found everywhere in the process industry, e.g. in the chemical or oil & gas industry. An interface arises when two media with different densities are filled into a container: for example, water and oil. To separate the two media from one another, it is necessary to determine where the transition from one medium to the other is located. VEGA sensors can be used to measure both the total level and the interface reliably.
-
Product
Level Measurement
-
In continuous level measurement, the level of a medium in a tank or silo is detected with the help of different measuring methods and converted into an electronic signal. The level signal is either displayed directly on site or incorporated into a process control or management system.
-
Product
Hydrostatic
VEGABAR, VEGAWELL, VEGADIF
-
In hydrostatic level measurement, the measuring cell of the pressure transmitter detects even the slightest changes in hydrostatic pressure, which increases or decreases depending on the filling level. The acting pressure is converted into an electrical signal by the integrated electronics and then outputted as an output signal. Different types of measuring cells are used in level measurement based on the hydrostatic principle.
-
Product
Hydrostatic Pressure
VEGABAR, VEGAWELL
-
The measuring cell of the pressure transducer detects minute changes in hydrostatic pressure, which increases or decreases depending on the filling level. The acting pressure is converted into an output signal by the integrated electronics.
-
Product
Process Pressure
VEGABAR
-
Pressure transmitters measure the pressure of liquids, gases and vapours in pipes or closed vessels. The pressure of the measured medium acts on a pressure measuring cell, which converts it into an electronic signal.The process pressure transmitters are ideal for detecting the relative or absolute pressure in applications with condensation or rapid temperature changes.
-
Product
Vibration
VEGASWING, VEGAVIB, VEGAWAVE
-
In point level measurement with vibrating level switches, a rod or a fork is set vibrating. When the vibrating probe comes into contact with the medium, the vibration changes and the vibrating level switch outputs a switching command. Vibrating level switches are used as overfill protection devices or low-level indicators in liquids as well as in granular and powdery bulk solids.
-
Product
Radiometric Principle
-
In radiometric density measurement, an isotope emits focussed gamma rays. The detector on the opposite side of the pipeline receives the radiation.
-
Product
Level Switches
-
In point level detection, a point level switch detects when a certain predefined level is reached. Such a device is employed when it is not necessary to measure every possible intermediate level, as is the case with continuous level measurement. A switching command starts or stops filling equipment such as conveyors or pumps. Point level switches outputting a binary signal can be integrated into a process control system.
-
Product
Radiation-Based
-
A non-contact, industrial process technology that uses gamma radiation to detect the boundary layer (interface) between different materials.
-
Product
Ultrasonic
VEGASON
-
In non-contact ultrasonic level measurement, the sensor emits ultrasonic pulses in the direction of the medium, which then reflects them back.
-
Product
Radar
VEGAPULS
-
In continuous non-contact level measurement with radar, the sensor sends microwave signals towards the medium from above. The surface of the medium reflects the signals back in the direction of the sensor. Using the received microwave signals, the sensor determines the distance to the product surface and calculates the level from it.
-
Product
Magnetic Level Indicator
VEGAMAG
-
A safe, durable, and non-invasive instrument used to measure liquid levels in tanks or pressurized vessels.
-
Product
Differential Pressure
-
In differential pressure measurement, different pressures act on an oil-filled, pressure difference measuring cell from two sides. The instrument converts the pressure differential into an electronic signal.
