Discrete Semiconductor
semiconductor typically having one circuit.
-
Product
Slot 0 Module Retainer Block Set, For Discrete Wiring, 1 Position
510109150
Module Retainer
These module retainer blocks are used to attach modules directly to the inner frame of a VXI receiver for discrete wiring. These modules then hinge down with the receiver to provide easy access to wiring.
-
Product
Receiver, G18, 18 Module For Discrete Wiring
310120101
Receiver
The lightweight and rugged 18 module Receiver provides a solution that will accommodate larger ATE chassis’ (PXI, VXI, SCXI). It allows immense versatility by affording space for up to an 18 slot PXI chassis.
-
Product
100-Pin Micro-D Connector, Male, Discrete Wire, 2-56 UNC Screwlocks, Metal Shell
C100SMR-1CW-6A
SCSI Male Connector
This accessory is designed to allow users to directly terminate a cable to the connector. It is difficult to terminate cable to the 100-Pin SCSI Style Micro-D connector because of the high density and fine pitch. Pickering Interfaces recommends the use of purchased cable assemblies for applications where most or all of the contacts are in use.
-
Product
Combination Module: 2 Ch. MIL-STD-1553 & 12 Ch. Discrete I/O
CM8
-
The CM8 module is a combination of NAI's MIL-STD-1553B module, FTB, and Enhanced Discrete I/O module, DT4. The CM8 offers twelve channels of discrete I/O and two channels of MIL-STD-1553B communications. The twelve discrete I/O channels are programmable as either input (voltage or contact sensing with programmable, on-module pull-up/pull down current sources), or output (current source, sink, or push-pull) up to 500 mA per channel from an applied, external 3-60 VCC source. The discrete I/O channels also provide additional functionality modes such as Pulse Width Modulation (PWM) output mode and Pattern Generator output mode. The two MIL-STD-1553B communications channels feature a dual, redundant, balanced-line, physical layer; a (differential) network interface; time division multiplexing; half-duplex command/response protocol; and up to 31 remote terminals (devices).
-
Product
16-CH Discrete Input 16-CH Discrete Output Module with US Type Connector
HSL-DI16DO16-US
-
*16-CH digital input and 16-CH digital output*Shrounded-type connector*Isolation Voltage: 2500Vrms*Higher output current up to 90mA/channel*Easy installation and wiring
-
Product
Metrology Solutions for Semiconductors
-
Bruker Semiconductor develops, manufactures, markets, and supports metrology solutions for thin films, which are based on novel, rapid, non-contacting and non-destructive X-ray technology. With Bruker’s acquisition of Jordan Valley Semiconductors, a name synonymous with unparalleled worldwide customer service and support, 75% of the world's top 25 semiconductor manufacturers rely on Bruker metrology tools for front-end and back-end applications, including development of their next-generation thin films. Bruker commitment to innovation and technology leadership drives the continued release of new advancements in metrology, and has garnered numerous awards and industry recognition. In applications ranging from C-S thin films materials characterization to wafer substrate analysis and defect detection, Bruker’s systems provide simulation analysis and fit. HRXRD, XRR, WA-XRD, and XRDI measurement types are fully supported, enabling researchers, production engineers, and process developers unparalleled capabilities. Whether you are a semi and C-S fabricator, R&D center or academy, or an industry materials research facility, Bruker has a specifically designed solution for your metrology needs.
-
Product
Benchtop Discrete Component Tester
Imapact 7BT
-
The 7BT Benchtop Discrete Component Tester is designed to test small signal and power semiconductor components in both single and multi-device packages or hybrids.. The 7BT automatic test system can be used in all test applications including incoming inspection, wafer probe, QC, engineering, production, final test, and high reliability.
-
Product
Discrete Input Event Recorder
-
Wabtec M Series Recorders provide a compact recording solution for discrete electrical and pneumatic signals and provide compliance to FRA Crash Hardening requirements.
-
Product
Switch Modules - 16 Single Pole, Form A, Discrete Relays Which are Wired & Controlled Individually
JX16/KA
Switch Module
This module has 16 single pole, Form A, discrete relays which are wired and controlled individually. The relays can be externally wired to make any configuration needed. Use as individual ON/OFF relays or use them to drive external relays, solinoids, or any external device. It is available with Type S or M reed relays.
-
Product
OEM DC Power System For Semiconductor
-
AMETEK Programmable Power, Inc.
*Single Package 6-Pack of 600W power supplies*Complete self-contained controller operates independently once pre-set*Capable of ramps and sequences*Capable of inter-channel dependent operation*DeviceNet Interface*Solid State polarity switching
-
Product
Spread Resistance For Slanting Polished Sample Of Semiconductor By Tow Kinematically-mounted Probe Contacting .
SRS-2010
-
*Resitivity map along with depth direction, thickness of epitaxial , depth of PN junctin and carier density profiles
-
Product
Comprehensive Suite of Software Tools for Semiconductor Test Applications
ICEasy Test Suite
-
Marvin Test Solutions' ICEasy Test Suite is supplied with both the TS-900 and TS-960 semiconductor test platforms and provides a comprehensive set of software tools - facilitating the development and debugging of test programs for semiconductor devices. In addition the suite includes I-V curve and Shmoo plot tools for analyzing a device's DC and AC characteristics. The complete suite of tools interfaces seemlessly with Marvin Test Solutions' ATEasy®, a test executive and test development evironment which is supplied with each TS-900 / TS-960 system.
-
Product
Signal, Module, ID, CASS, 64 Position, Discrete Wiring
510114108
ITA Module
Signal, Module, ID, CASS, 64 Position, Discrete Wiring.
-
Product
Atlas DCA Semiconductor Analyser
DCA55
-
Intelligent and flexible semiconductor analyser. Connect any way round! The DCA55 then displays the following on its backlit alphanumeric display:- Component type (such as NPN transistor, P-Ch MOSFET, LED, diode etc)- Pinout information (such as Base, Emitter, Collector etc)- Parameter measurement (hFE, Vbe, Vf, leakage current etc)
-
Product
Switch Modules - 16 Single Pole, Form C, Discrete Relays which are Wired & Controlled Individually
JX16/KC
Switch Module
This module has 16 single pole, Form C, discrete relays which are wired and controlled individually. The relays can be externally wired to make any configuration needed. Use as individual A-B relays or use them to drive external relays, solinoids, or any external device. It is available with Type S or M reed relays.
-
Product
Semiconductor Test
Ismeca NY32
-
32-position turret platform for semiconductor test, inspection and packaging, providing the highest process integration capabilities. Integrating innovative hardware and software technology such as Intelligent Features that enables extended autonomous operation and productivity.
-
Product
Impulse Semiconductor High Current Integrated
Transmission Line Pulse Test System
-
The Impulse Semiconductor High Current Transmission Line Pulse (TLP) test system is the tool of choice for extracting ESD parameters for transient protection devices in a package, or at wafer level. With accuracy better than 100 milliohms at 40 amps peak current, the Impulse high current TLP is specially tailored to the needs of today's ESD device designers who must accurately measure low values dynamic resistance irrespective of breakdown voltage.
-
Product
Automotive Power Discretes
-
ST offers a wide portfolio of automotive grade power discrete devices for reliable, robust and power-efficient automotive applications.
-
Product
Smartchem Discrete Analyzers
-
Fully automated, multi-parameter, direct read discrete analyzers, available in bench-top or floor-stand models, for simple and automated chemistries. Up to 200 samples and up to 600 tests/hour.
-
Product
Software to Simulate Large Area Semiconductor Devices
Laoss
-
Laoss is a powerful software to simulate large area semiconductor devices (OLED, thin-film PV), taking into account the voltage drop in the electrodes due to important resistive effects when the size of the device increases.Simulation of large area semiconductor devices (OLED, thin-film PV)Coupling law input: analytical or tabulated (experimental or simulated) IV curveDevice optimization (electrode material, device geometry etc...)High speed computation
-
Product
Semiconductors Testing
test
Our Testers support the production lines of variety of products such as 40/100 GBps Mux/DeMux, LNA, WiMAX RF Transceivers, Microwave & Millimeter Wave components. This high reliability products are being used in (a) Networking & Communications (b) Consumer Electronics (c) Military & Space
-
Product
Coax, Module, Receiver, CASS, 64 Position, Discrete Wiring or Side PCB
510113121
Receiver Module
Coax, Module, Receiver, CASS, 64 Position, Discrete Wiring or Side PCB.
-
Product
Emulates Dallas Semiconductors DS89C420
FE-C420
-
* Emulates Dallas Semiconductors DS89C420 * 16K Code Memory * Real-Time Emulation * Frequency up to fmax at 3V and 5V * ISP Support * MS-Windows Debugger For C And Assembler * Emulation Headers and Signal Testpoints * Target Board and Programmer Included * Serially Linked to IBM PC at 115Kbaud
-
Product
Semiconductor Test Equipment
IC Tester
-
Equipment to determine the pass/fail of devices in the wafer inspection process and the final inspection process after packaging.
-
Product
Module, Receiver, RTCASS, Coaxial, 64 Position, Discrete Wiring or Side PCB Mount
510113142
Receiver Module
Module, Receiver, RTCASS, Coaxial, 64 Position, Discrete Wiring or Side PCB Mount.
-
Product
Semiconductors
-
Multiphysics Analysis Solutions for Chips and 3D IC Systems. Ansys cloud-native solutions provide unparalleled capacity to speed up completion times for even the largest finFET integrated circuits (IC) and 3D/2.5D multi-die systems. These powerful multiphysics analysis and verification tools reduce power consumption, improve performance and reliability, and lower project risk with foundry-certified golden signoff verification.
-
Product
Switch Modules - 8 Single Pole, Form C, Discrete Power Relays which are Wired & Controlled Individually
JX8/KCP
Switch Module
This module has 8 single pole, Form C, discrete power relays which are wired and controlled individually. The relays can be externally wired to make any configuration needed. Use as individual A-B relays or use them to drive external relays, solinoids, or any external device. Screw Terminal Connectors and Armature power relay for switching up to 8 Amps of DC or AC current.
-
Product
Semiconductor Optical Amplifiers
-
A Semiconductor Optical Amplifier (SOA) is essentially a laser diode (LD) with no feedback from its input and output ports and hence is also referred to as a Traveling-Wave Amplifier (TWA). Semiconductor Optical Amplifiers (SOAs) have proven to be versatile and multifunctional devices that are key building blocks for optical networks.
-
Product
Semi-automatic Semiconductor Probe Assembly Equipment
-
The components of the incoming parts are pre-assembled and preloaded to two packages. We use a high-speed four-axis robot equipped with high-precision multi-sensor grips to grab these pre-assembled subcomponents. Under CCD visual guidance, a set of rotary grab devices is equipped to capture top plunger. The device uses a multi-set CCD visual module to ensure accuracy, and the positioning accuracy of each motion link is controlled within 15um.
-
Product
Semiconductor Wafer Defect Inspection Management Software
ProcessGuard
-
Microtronic ProcessGUARD Software is the desktop client for the EagleView auto macro wafer defect inspection system. ProcessGUARD is a high volume, high speed semiconductor wafer defect inspection management solution that provides an easy-to-use, customizable and extensible platform and interface to automate your fabs defect inspection process. ProcessGUARD is feature rich (see below) and its newest releases include complete wafer randomization software, a user-defined defect library, and an integrated trainer and knowledge base.
