Product

Wire Crimp Pull Tester (Motorized)

WT3-201M

-

Mark-10 Corp.

WT3-201M - Mark-10 Corp.

The WT3-201M motorized wire crimp pull tester is designed to measure pull-off forces of up to 200 lbF [1 kN] for wire and tube terminations. The tester conforms to numerous UL, ISO, ASTM, SAE, MIL, and other requirements for destructive testing. Non-destructive testing is also possible, such as pulling to a load or maintaining a load for a specified period of time, as per the requirements of UL 486A/B. Programmable pass/fail limits with red and green indicators and audio alerts help identify non-conforming samples.

Product

Open-Frame Collet Socket with Wire Wrap Pins

Series 508

-

Aries

Series 508 - Aries

Open Frame Collet Sockets with Wire Wrap Pins. Features: Open frame allows for more efficient utilization of board space and better cooling. 2 and 3 level wire wrap pins available. Compatible with automatic insertion equipment. Side-to-side and end-to-end stackable.

Product

LXI Wired Trigger Bus Adaptors And Accessories

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

We manufacture LXI Wired Trigger Bus adaptors and accessories. These adaptors and accessories are designed to help debug a WTB system or provide conversion of signals to or from the WTB to products that do not support the WTB. LXI approved WTB cable assemblies and terminators are available to interconnect LXI devices that support the LXI Wired Trigger Bus extended function.

Product

Straight Wire Porbe Pins

Buckling Beam

-

Prospect Products Inc.

Buckling Beam - Prospect Products Inc.

Straight wire probe pins are a proven solution for various electronics production test environments.

Product

Wires and Pipe Locator

LKZ-720

-

Sonel S.A.

LKZ-720 - Sonel S.A.

*Detection of wires and cables (live or not)**detection of cables in ceilings, walls and floors,**detection of breaks in cables,**tracing cables in building installation,**locating power points and switches in buildings,**locating short circuits between leads,**tracing shielded cables,**tracing cables in metal ducts.*Identification of fuses on the distribution board.*Tracing underground cables.*Tracing conductive water and heating pipelines.*Non-contact detection of live cables.

Product

Wire Piercing Clips

619

-

Electronic Specialties Inc.

619 - Electronic Specialties Inc.

This new clip makes wire piercing much easier. Just slide the wire into the cradle and screw the pin down into the wire. This method is clean and leaves minimal wire damage. If you have to proceed to pierce the wire, do it the right way with 619.

Product

Cables, Harnesses & Wiring Looms

-

AmFax Ltd

AmFax Ltd

​Amfax manufacture a wide range of wiring harness solutions in a variety of styles and finishes. These wiring harnesses, or looms as they are often called, can be constructed using heat-shrink, conduit tube, braid, tape, tie-wraps or lacing cord.

Product

Wire Crimp Pull Tester (Manual)

WT3-201

-

Mark-10 Corp.

WT3-201 - Mark-10 Corp.

The WT3-201 wire crimp pull tester is designed to measure the pull-off force of crimped wire and tube terminations. An ergonomic lever allows for easy application of up to 200 lbF (1,000 N) of crimp pull force. Adjustable wire terminal grip contains multiple slots for wire diameters up to AWG 3 (0.25 in [6.3 mm]). The tester accommodates most insulation types. Samples can be sent to Mark-10 for evaluation prior to purchase.

Product

68-Pin DIN-Rail SCSI Wiring Board

ADAM-3968

-

Advantech Co. Ltd.

ADAM-3968 - Advantech Co. Ltd.

DIN-rail mounting screw terminal module for industrial applications with 68-pin SCSI female connectoCase dimensions (W x L x H): 77.5 x 191.2 x 51 mm (3.1" x 8.4" x 2.0")To Be Used With PCI-1710U/UL/1710HGU/1711U/UL,PCI-1712/L,PCI -1716/L,PCI-1741U/1742U/1747U/1780U

Product

10 Micron Wire Grid Polarizer

-

PureWavePolarizers Ltd.

PureWavePolarizers Ltd.

Fabricated from 10 micron diameter tungsten wire, and with a choice of wire spacing starting from 25 microns, these wire grid polarizers are suitable for use from approximately 100 microns (or 3 THz) to longer wavelengths. Please refer to the table below for the standard availability of wire spacing and frame clear aperture / outer diameter.

Product

3 Wire (Analogue) Earth Resistance Tester

ST-1505

-

Standard Electric Works Co., Ltd

ST-1505 - Standard Electric Works Co., Ltd

● High quality Taut Band movement.● Capable of measuring earth resistance and earth voltage.● The timer operates automatically for about three to five minutes when the “PUSH BUTTON SWITCH” and “TIMER ON BUTTON” are pressed together. ● This will keep test “ON” for the duration of the timer.● Battery check function.● Calibration performed with supplied test leads.

Product

IEC60695-11-2 Single Wire And Cable Vertical Burning Tester

CX-D12

-

Shenzhen Chuangxin Instruments Co., Ltd.

CX-D12 - Shenzhen Chuangxin Instruments Co., Ltd.

It’s strictly designed according to IEC60695-11-2, IEC60332-1, GB/T18380.11-2008, GB/T18380.12-2008 etc. Stainless steel screen with a sliding burner handle support for approaching or movingback the flame from the sample under test according to the CEI standards for test on cables.

Product

Gauge Type T Thermocouple Wire

W-TW-44P2

-

Physitemp Instruments

W-TW-44P2 - Physitemp Instruments

Most thermocouple wire used in the manufacture of sensors is "Special Limits" wire which, to meet NIST standards, must be accurate to 0.5°C in the range 0-50°C. This means that even with most sophisticated electronics, the best possible accuracy for the system is 0.5°C.

Product

Temperature Wire Sensors

-

Omega Engineering, Inc

Omega Engineering, Inc

Temperature Wire Sensors

Product

3 Wire (Digital) Earth Resistance Tester

2120 ER

-

Standard Electric Works Co., Ltd

2120 ER - Standard Electric Works Co., Ltd

● Capable of measuring earth resistance and earth voltage.● 2mA measuring current permits the testing of earth resistance without tripping earth leakage current breakers in the circuit under test.● The test leads are supplied as standard accessories for simplified two-wire measuring system.● 0Ω adjustment.● Battery operated.● Data hold function.● Low battery indication.● Calibration performed with supplied test leads.

Product

Bulk Wire and Cable

-

Teledyne Marine Cable Solutions

Teledyne Marine Cable Solutions

With 50 years of dedicated experience in providing cable and interconnect solutions, Teledyne Cable Solutions meets challenges for application-specific, multi-core cables for harsh environments and complex ruggedized cable assemblies and harnesses.​

Product

4-Wire Resistance Measurement | Continuity & HiPot Cable & Wire Harness Testers

-

CAMI Research Inc.

CAMI Research Inc.

An add-on option for the CableEye HVX high voltage cable tester series that permits expanded testing for contact and wire resistance as low as 1 mΩ. After checking for opens, shorts, miswires, and resistance limits, the 4-wire Kelvin measurement applies a user-selectable test current from 10 mA to 1 A to determine connection resistance within 1 mΩ. The resistance profile of a model cable may be stored and used as a basis of comparison during later testing to reveal cold solder joints, faulty crimps, recessed pins, pin contact contamination, improper wire gauge, and stress-extruded wire.This option may be purchased with any new HVX tester, or added as an upgrade to any of your existing HVX testers.

Product

Compact Deuterium, Tungsten Halogen or Glow Bar Light Source

LSH Illuminator

-

HORIBA, Ltd.

LSH Illuminator - HORIBA, Ltd.

Compact lamp housing for a variety of types of light sources from the UV to the IR including deuterium, tungsten halogen and glow barApplications for compact arc lamp housings cover a broad range of scientific, OEM and research applications. Arc lamp illuminators are used for a broad range of applications almost as diverse as the wavelength range across which they emit.

Product

Gauge Type T Thermocouple Wire

W-TW-40P

-

Physitemp Instruments

W-TW-40P - Physitemp Instruments

Most thermocouple wire used in the manufacture of sensors is "Special Limits" wire which, to meet NIST standards, must be accurate to 0.5°C in the range 0-50°C. This means that even with most sophisticated electronics, the best possible accuracy for the system is 0.5°C.

Product

Drawing Die And Wire Measurement

DGMS – Die Geometry Measuring System

-

Optik Elektronik Gerätetechnik GmbH

DGMS – Die Geometry Measuring System - Optik Elektronik Gerätetechnik GmbH

Measuring system for diameter, roundness, reduction angle and bearing length of wire drawing dies.

Product

Gauge Type T Thermocouple Wire

W-TW-30

-

Physitemp Instruments

W-TW-30 - Physitemp Instruments

Most thermocouple wire used in the manufacture of sensors is "Special Limits" wire which, to meet NIST standards, must be accurate to 0.5°C in the range 0-50°C. This means that even with most sophisticated electronics, the best possible accuracy for the system is 0.5°C.

Product

Wiring Boxes

-

Seitron

Seitron

Radio receiver for heating / cooling systems equipped with an integrated antenna, an output with SPDT relay and an RS485 Modbus® RTU slave communication port.