Contamination Monitors
-
Product
Monitor Debugger/RAM Monitor
-
The Monitor Program is automatically written to the MCU when the Debugger is started up.
-
Product
SCTE35 And DPI Monitoring System
SCM200
-
The SCTE35 splicing message and advertisement insertion monitoring system can be used by service providers to monitor Ad placement opportunities and verify correct Ad insertion. The system will log all SCTE35 messages discovered in the transport streams and perform triggered recording for the verification of Ad insertion process.
-
Product
CCTV Monitor Testers
-
Shenzhen Noyafa Electronic CO.,LTD
NOYAFA CCTV Moniter Tester has a built-in high-resolution and wide-size high-definition screen display, automatic video signal detection (AHD / TVI / CVI). The design of the monitor and wristband is ergonomic and convenient to use at any time and place.
-
Product
Multi Circuit Leakage Current Monitor
MCM-8000
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
●The leakage current of max.8 circuits at the same time.●Easy for data management (storage by CSV formula)●Cost performance, high-speed sampling with high-frequency cut function.
-
Product
24/7 Nuclear Radiation Monitor
NukAlert
-
More than just a detector, the NukAlert is a patented personal radiation meter and alarm. Small enough to attach to a key chain, the device operates non-stop, 24/7 and will promptly warn you of the presence of unseen, but acutely dangerous levels of radiation.
-
Product
Noise Monitoring System
NoiseTutor
-
Continuous monitoring of environmental data in remote areas has always presented a unique set of challenges. Typical solutions involve complex installations, frequent visits to remote locations to keep the system fully operational and require expert level attention to retrieve and share data amongst customers, consultants and project leads.
-
Product
Aerosol Monitor
DUSTTRAK II-8530
-
The DUSTTRAK™ II Aerosol Monitor 8530 is a desktop battery-operated, data-logging, light-scattering laser photometer that gives you real-time aerosol mass readings. It uses a sheath air system that isolates the aerosol in the optics chamber to keep the optics clean for improved reliability and low maintenance.
-
Product
Power Supply and Current Monitor
DC Connect
-
DC Connect enables measurement of current consumption of battery operated and other low voltage devices such as hearing aids
-
Product
Engine Health And Vibration Monitoring
-
Engine Health and Vibration Monitoring systems provide the data required to support condition-based maintenance and “power-by- the-hour” commercial frameworks. They can also tell the pilot or maintenance crew if the engine rotors are out of balance (a mandatory requirement for passenger-carrying jet-powered civil aircraft).
-
Product
Radiation Monitor
-
The Radiation Monitor is the survey meter in measuring the beta, gamma and x-ray radiation. It is useful in monitoring the environment/home safety, nuclear, medical, mining and metal industries. It is also ideal for the border control, customs and cargo inspections.
-
Product
Monitoring System
A112
-
The photoelectric sensor model A112 allows to realize a system for detecting breaks of thin wires from 10 um in diameter, with a detection range greater than 50 cm.The A112 produces these results without the use of laser technology, allowing high immunity to vibration and a secure alignment between receiver and transmitter.
-
Product
Explosion Proof Area Hydrogen Monitor
HY-ALERTA™ 2620
-
H2scan’s 2620 Explosion Proof Area Hydrogen Monitor provides hydrogen-specific leak detection and measurement for hydrogen concentrations as low as 4000 ppm and can be scaled to any concentration up to 5% hydrogen by volume, a range representing 10% to 125% of hydrogen’s low flammability limit. The monitor is designed for either ceiling or wall mount. H2scan’s hydrogen-specific sensor technology has no cross sensitivity to other combustible gases, thus eliminating false positive alarms and ensuring safety system reliability.
-
Product
Wired Hazard Monitoring
-
Grain dust is extremely volatile and can easily explode with the proper ignition source in confined spaces. OSHA has mandated that grain elevators in Class II, Division 1 environments must have the 3 monitoring sub-systems for elevator safety (1910.272(q)(4)(ii), 1910.272(q)(5), 1910.272(q)(5)).
-
Product
PM Mass Monitor
Model T640
-
Teledyne Advanced Pollution Instrumentation
The Model T640 PM Mass Monitor is the next breakthrough in ambient particulate monitors. The T640 delivers 1-min or better time resolution with exceptional sensitivity and precision. The instrument is very low maintenance and requires no sample media for minimal cost of operation.
-
Product
Power Quality Monitoring Equipment
-
Outram Research Ltd manufacture, sell and hire a wide range of Power Quality Monitoring Equipment. From a single phase, plug and play instrument for solving residential Power Quality complaints to comprehensive 3 phase, 8 channel, high speed troubleshooting technology used by Power Quality Consultants, Distribution Network Operators and Electrical Utility Companies around the world.
-
Product
Fiber Optic Type Chemical Concentration Monitor
CS-600F
-
The CS-600F achieves a higher level of functionality best suited for manufacturing, such as the ability to perform in-line measurement of high temperature chemical solutions in various applications, stable operation for reduced downtime, and compact size for improved space productivity in order to meet the precise chemical solution concentration management required in leading-edge semiconductor wet process.
-
Product
Vibration Control, Monitoring and Diagnostics System for Hydraulic Units
-
Stationary system for vibration control, monitoring and diagnostics of hydraulic units is used for constant technological and safety control, diagnostics of vibrational and mechanical parameters of hydraulic units and auxiliary equipment of hydroelectric power stations in accordance with the applicable requirements.
-
Product
PXI Monitored Multiplexer, Dual 25-Channel, 1-Pole
40-619-102
-
The 40-619-102 is a high density PXI 2 A multiplexer module in dual 25-channel configuration using high quality electro-mechanical signal relays allowing each channel to switch current up to 2 A and voltage up to 250 VAC/DC.
-
Product
AFDX ® /ARINC664P7 Networks Test, Simulation, Monitoring & Analyzer
ACE-FDX-3U-2
-
AFDX®/ARINC664P7 Test and Simulation module for PCIe x1 with 2 full duplex ports programmable for 10/100/1000 MBit/s. Versions available for both Airbus and Boeing variants of ARINC664P7. Test, verification and simulation of AFDX®/ARINC664P7 End Systems, Switches and Networks. Support for Single or Redundant AFDX®/ARINC664P7 operation. Support for Boeing ARINC664 extensions for EDE at the hardware interface layer.
-
Product
Social Distancing Monitor
Aura
-
The Aura personal proximity sensor is designed to tackle the challenge of social distancing brought about by COVID-19. It allows businesses to ensure a minimum distance between workers and customers with a lightweight, wrist unit.
-
Product
Respiration Monitor Belt Logger Sensor
NUL-236
-
This sensor comes with a belt and measures the air pressure in it. The pressure changes according to the breathing of the subject. From the measured values, the respiration rate can be calculated.
-
Product
Real-Time Quality Monitoring For 4K
RTM 4K
-
4K or multi-channel HD with 12G-SDI Interfaces Optional 10G IP for ST 2110 Networks
-
Product
Thermalert Clinical Monitoring Thermometer
TH-8/AOP
-
The TH-8/AOP is one of our most economical precision thermometers in the Physitemp product line. The TH-8 offers the same high accuracy (0.1°C ±1 digit) and resolution as all our other thermometers, but with a narrow temperature range. The TH-8 has a temperature range 0f -10 to +60°C with 3 probe inputs. The TH-8 is also switchable from celsius to Fahrenheit. The TH-8 is ideally suited for either a laboratory or hospital setting where continuous temperature readings within the physiological range are sufficient.
-
Product
10.4" SVGA / XGA Industrial Panel Mount Monitor
IDS-3210
-
10.4" SVGA LCD panel with LED backlight for 20% power saving and environmental protection. -20° C ~ +60° C wide range operating temperature, 5-wire resistive touchscreen solution or tempered smudge resistant protected glass.
-
Product
PDS Excavator Monitoring System
-
It shows a real time overview of the excavator in navigation, profile, and 3D views; displaying the dredge tool, pontoon/vessel, design depths, and color-coded digital terrain model (DTM). The navigation view highlights the high and low spots and is updated in real time, recording the progress of the dredging work. The recording follows the shape of the dredge tool and is visible immediately in all views. Up/down indicators show the operator the exact distance to the seafloor and design depth continuously. 3D design models allow the use of complex designs. The monitoring system can also be used for a remote presentation on the bridge of the vessel and it is possible to draw the vessel in the views of the excavator as well.
-
Product
Real-Time Video/Audio quality monitoring
VQEmbed
-
VQEmbed libraries provide real-time video/audio quality monitoring for OEMs wanting to offer a fully automated Quality of Service monitoring solution to their customers.
-
Product
Livestock Heat Stress Monitor
DROP D2AG
-
Livestock heat stress can cause serious health issues in your valuable livestock as well as reduced performance and productivity. Stay informed of heat conditions in the barn or during transport with the Kestrel D2AG Livestock Heat Stress Monitor. Multiple built-in environmental measurements mean your DROP D2AG can also be used for many other agricultural applications including hay and feed storage areas and greenhouses.
-
Product
ABex Current Sense Module for Six Channel UUT Supply Monitoring
ABex TM-406 Current Sense
-
The ABex TM-406 is a six-channel shunt current measurement extension. It’s designed to work in combination with the Konrad ABex TM-501 and PXI-501.Each of the six shunt current measurement units have a passive measurement shunt, an overcurrent protection, a sense bridge relay and the possibility to route the quiescence current to an ABex measurement device TM-501 with PXI-501.In addition, the ABex TM-406 features 8 isolated digital outputs (IDOs), and 12 measurement inputs, which can be routed to the analog bus.
-
Product
A Serial Data Link Monitor for Windows
Listen
-
Listen is a Data Link monitor designed to assist debugging & troubleshooting serial communications links. Listen utilizes standard Windows COM port drivers to tap into RS-232 transmit signals for monitoring bi-directional communications between two devices.
-
Product
Monitoring Devices
-
TDK Monitoring Devices - rf shielded hd video camera, rf shielded hd mini video camera, camera controller
