Vapor Deposition
-
Product
Cold Vapor Atomic Absorption (CVAA) Mercury Analyzer
QuickTrace M‑7600
-
The QuickTrace® M-7600 Cold Vapor Atomic Absorption (CVAA) Mercury Analyzer easily achieves the ultra-trace mercury detection limit of <0.5 ng/L. The QuickTrace® M-7600 is ideal for ultra-trace to sub-mg/L mercury quantitation. The M-7600 is designed for routine and research use in a variety of settings, including environmental laboratories, industry, and research institutes, for virtually any aqueous acidified sample.
-
Product
CVAF – Cold Vapor Atomic Fluorescence
-
Cold Vapor Atomic Fluorescence (CVAF) is a powerful technique based on detecting fluorescence light emitted by the sample. Below the principle of the technique is explained in a nutshell.
-
Product
Dual Vapor Gravimetric Sorption Analyzer
DVS Resolution
-
DVS Resolution’s key feature is the combined ability to precisely control and measure temperature and relative humidity while recording the highest resolution changes in mass. DVS Resolution uses a dry carrier gas typically nitrogen or compressed air for its operation. Digital mass flow controllers regulate flows of dry and saturated gases. Relative humidity is generated by precisely mixing dry and saturated gas flows in desired flow ratios which produce expected relative humidity. In a typical experiment a known concentration of water vapor is delivered over a sample placed inside the sample pan connected to the Surface Measurement Systems Ultrabalance™ measuring realtime mass changes caused by sorption or desorption of water molecules. Prior to sorption measurements, the sample can be in-situ preheated/dried at temperatures of up to 300oC.
-
Product
Dynamic Vapor Sorption Analyzer
IGAsorp-XT
-
The IGAsorp-XT is a fully automated water sorption analyzer designed for measurements at temperatures and humidities beyond those available with conventional DVS analyzers. High resolution sorption isotherms are recorded at humidity values from 0.2 %RH or lower, using the unique climate-XT control method. Combined with high temperature water sorption measurements to 300 °C, an integrated pre-heater and completely flexible method programming, the IGAsorp-XT is the world’s most advanced benchtop DVS analyzer.
-
Product
Large Flow Liquid Source Vaporization Control System
LE Series
-
A high-flow, high-efficiency, liquid vaporizer with flow channels and heater elements embedded in a cast aluminium block which ensures maximum heat transfer, and the elimination of both cold spots and the risk of condensation. This Liquid Source Vaporization Control System can operate at up to 300 °C and can vaporize up to 30g/min of IPA (or equivalent).
-
Product
Crude Oil Package for Vapor Pressure
-
The GRABNER INSTRUMENTS' Crude Oil Package is a comprehensive solution for the transport and measurement of the vapor pressure of crude oil according to ASTM D6377 (Expansion Method). The unique Floating Piston Cylinder allows safe sample transfer of “live crude oils” according to ASTM D3700 and eliminates the risk of evaporation of light hydrocarbon ends during transport. The Grabner Instruments crude oil package is also strictly in accordance with the Russian standard GOST 52340.
-
Product
Vapor Source Mass Flow Controller With Viscous Laminar Flow
-
The 1152C Vapor Source Mass Flow Controller is a pressure-based measurement and control system designed to meter and control vapor from low vapor pressure liquid and solid sources directly, without the need of a carrier gas. The 1152C consists of a fixed flow element and two capacitance manometers for flow measurement, with a proportioning solenoid control valve for flow control.
-
Product
Mixed Injection System Liquid Vaporizer
MV-2000
-
The MV-2000 achieves stable vaporization, even at low temperatures, using the new tornado flow method. This is suitable for vaporization a range of liquids even challenging sources such as "High-k", a liquid source which is pyrolyzed easily.
-
Product
Vapor Source Mass Flow Controller With Viscous Choked Flow
-
The 1150C Vapor Source Mass Flow Controllers are pressure based measurement and control systems designed to meter and control vapor from low vapor pressure liquid and solid sources directly, without the need of a carrier gas using viscous flow through a choked orifice.
-
Product
Cold Vapor Atomic Fluorescence (CVAF) Mercury Analyzer
QuickTrace M‑8000
-
The QuickTrace® M-8000 Cold Vapor Atomic Fluorescence (CVAF) mercury analyzer is ideal for ultra-trace to sub-mg/L mercury quantitation. Due to the high sensitivity of the M-8000, it easily achieves the ultra-trace detection limit of <0.05 ng/L total mercury that is demanded by customers following EPA method 1631. The QuickTrace® M-8000 is also versatile enough to analyze samples >400 µg/L without dilution in a research or industrial setting.
-
Product
Duct Deposit Measuring System
-
The Elcometer 456 Duct Deposit Measuring System has been specifically designed to meet the requirements of the DTT (Deposit Thickness Test) in HVCA’s (Heating & Ventilation Contractor’s Association) Guide to Good Practice, for the measurement of dust and grease deposits within ventilation systems and kitchen ducts made of ferrous metals.
-
Product
Dynamic Vapor Sorption Analyzer
IGAsorp-CT
-
The IGAsorp-CT is a fully automated dynamic vapor sorption analyzer for the measurement of water and organic solvent isotherms and kinetics on a wide range of materials. Operating at temperatures from 5 to 85 °C and humidity values from 0 to 98 %RH, the IGAsorp-CT offers the widest combined range of any DVS analyzer. An optional internal heater allows fully programmable pre-heating and thermal desorption measurements to 350 °C.
-
Product
Water Vapor Absorption Tester
DRK854A
-
Shandong Drick Instruments Co., Ltd.
Used to test the water vapor absorption performance of the sample.
-
Product
Parylene Deposition Equipment
-
SCS offers Parylene deposition systems that range from a portable laboratory unit to production models for high-volume manufacturing applications. SCS Parylene deposition systems are designed for accurate and repeatable operation, featuring closed-loop monomer pressure control, which ensures deposition of the polymer film at a precise rate. Whether researching new coating applications or developing structures out of Parylene in the laboratory, or coating components in a production environment, SCS leads the industry with its state-of-the-art Parylene deposition systems.
-
Product
Reid Vapor Pressure Analyzers
-
Increase your gasoline blending profits with process Reid Vapor Pressure measurements and automatic air saturation of the sample.
-
Product
Dynamic Vapor Sorption Analyzer
IGAsorp
-
The IGAsorp is a fully automated compact benchtop DVS analyzer, for fast and accurate vapor sorption measurements using the dynamic flow technique for water and organic solvents. Measured vapor uptake isotherms and kinetics are used to characterize, test and evaluate materials in precisely defined environmental conditions.
-
Product
Water Vapor Transmission Rate Tester
(Electrolysis Method)
-
Shandong Drick Instruments Co., Ltd.
DRK311 water vapor transmission rate tester (electrolytic method), the instrument is suitable for the determination of water vapor transmission rate of plastic films, composite films and other films and sheet materials. Through the measurement of water vapor transmission rate, the technical indicators of control and adjustment of packaging materials and other products can be achieved to meet the different needs of product applications.
-
Product
Water Vapor Transmission Rate Tester (infrared method)
DRK311
-
Shandong Drick Instruments Co., Ltd.
DRK311 water vapor transmission rate tester (infrared method), the instrument is suitable for the determination of water vapor transmission rate of plastic films, composite films and other films and sheet materials. Through the measurement of water vapor transmission rate, the technical indicators of control and adjustment of packaging materials and other products can be achieved to meet the different needs of product applications.
-
-
Product
Thin-film deposition
Plasma Source
-
SPECS Surface Nano Analysis GmbH
Thin-film deposition covers any technique for depositing material onto a bulk or thin film substrate. Elemental alloy or compound films are produced by non-reactive or reactive (co-)deposition. Often functionalization or tailoring of device interfaces by predeposition or deposition assisting surface treatment with atoms or ions is necessary.
-
Product
Water Vapor Sorption Analyzer
DVS Adventure
-
DVS Adventure is a water vapor sorption analyzer that measures sorption and desorption isotherms over a broad range of humidities and temperatures. It offers unprecedented temperature stability and humidity performance.
-
Product
Water Vapor Desorption Products
-
RBD's vacuum chamber water vapor removal products include high-power, high temperature IR radiant bakeout emitters, and low-power, low temperature UVC emitters.
-
Product
Water Vapor Transmission Rate WVTR Tester
WPT Series
-
Water Vapor Permeability Tester is based on the Gravimetric method and is applicable to the water vapour transmission rate (WVTR) test of plastic films, composite films, sheets and other materials.
