Product

GPS / GNSS Antenna Signal Splitters

-

INSTOCK Wireless Components, Inc

INSTOCK Wireless Components, Inc

INSTOCK Wireless GPS Signal Splitters are available in 2-way thru 48-way configurations spanning 1-2 GHz with unpeered performance in GPS (L1-L5), GNSS, Galileo, GLONASS, BeiDou, and IRNSS antenna splitting applications. The 200 ohm internal load on the DC-blocked port(s) prevents receivers from incorrectly sensing an antenna fault when there is no current draw. Type N, SMA, TNC, BNC, and QMA connector configurations INSTOCK.

Product

2x8 QPSK Mixer

-

Optoplex Corporation

Optoplex Corporation

To be used for optical coherent detection such as DP-QPSK receivers, Optoplex’s ten-port 2x8 Coherent Mixer (aka QPSK mixer) combines the incoming signal with a local oscillator to generate eight light states in the complex-field space. The eight light output signals can then be coupled into four pairs of balanced detectors. The block diagram below shows the application of a 2x8 coherent mixer in a DP-QPSK receiver. Since the mixing process is data rate independent, the devices can be used for any data rate in applications such as 40Gb/s or 100Gb/s transmission systems.

Product

Fully Differential Amplifiers

-

Analog Devices Inc.

Analog Devices Inc.

Differential amplifiers allow the process of single-ended input to complementary differential outputs or differential inputs to differential outputs. These amplifiers feature two separate feedback loops to control the differential and common-mode output voltages. Analog Devices fully differential amplifiers are configured with a VOCM pin, which can be easily adjusted for setting output common-mode voltage. This provides a convenient solution when interfacing with analog-to-digital converters (ADCs). ADI also offers a series of differential receiver products that convert differential input signals to single ended output.

Product

The USRP-2920 Teaching Bundle

781908-01

-

NI

781908-01 - NI

The USRP-2920 Teaching Bundle helps students experiment with real-world signals using LabVIEW software and USRP-2920 receivers. - The USRP-2920 Teaching Bundle is a hardware and software bundle that includes two USRP (Universal Software Radio Peripheral) Software Defined Radio Devices, the LabVIEW Modulation Toolkit software add-on for LabVIEW, and turnkey courseware. The bundle also includes components of a lab station designed to help students gain hands-on experience with a live communication link between two USRP Software Defined Radio Devices.

Product

L Series Receiver

LR

-

Lectrosonics, Inc.

LR - Lectrosonics, Inc.

Excellent performance in a small package for ENG and DSLR video production is the purpose and intent of the LR receiver design. Tracking front-end filters block interference from high powered RF signals on nearby channels to preserve the extended operating range. RF spectrum scanning displays accurate results on the LCD to make finding clear spectrum quick and easy.

Product

Dosage System

Okhta

-

ViTec Co. Ltd

Okhta - ViTec Co. Ltd

The "Ohta" system is designed for automated dosing of bulk materials. By controlling the dispenser valve based on feedback from digital scales, the system optimizes the operation of filling and packing machines with manual control of the dispenser valve, which reduces the number of underweightes. The hardware of the complex is built on the basis of the industrial platform CompactRIO of National Instruments. The user interface and software for statistical processing and analysis of the received data are realized on a tablet computer that interacts with the controller via the WiFi interface.

Product

Light-Transmitting/-Receiving Devices for Optical Communication Systems

-

Sumitomo Electric Industries, Ltd.

Sumitomo Electric Industries, Ltd.

Various light-transmitting/-receiving devices support the foundation of optical communication systems. The portfolio includes semiconductor lasers and photodiodes for optical transceiver modules and board level design, as well as wavelength-tunable lasers and optical receivers for optical coherent communication devices in the backbone systems.

Product

Test Antennas

-

Lumistar Inc.

Lumistar Inc.

Lumistar provides small, lightweight portable fixed antennas for Test applications. They are available in lower L thru S bands for transmit and receive applications.

Product

TDRSS

-

L-3 Cincinnati Electronics

L-3 Cincinnati Electronics

L3 Cincinnati Electronics (L3 CE) continues to broaden its offering of TDRSS-compatible receivers and transmitters. Virtually any TDRSS forward or return service can be utilized with the following products. All TDRSS products have been live-link tested with the TDRSS constellation to insure compatibility.

Product

RxAIT

-

CCI

CCI

*RxAIT includes a Receive Multi-coupler (RMC) with a series of duplexers and Low Loss Combiners (LLC)*Provides the ideal ground based antenna sharing solution and reduces feeder line count and tower loading*Provides a common receive distribution point for multiple base stations*Each cellular and PCS unit supplies 8 ports and supports 2 channels

Product

Switch

-

Chengdu KeyLink Microwave Technology Co., Ltd.

Chengdu KeyLink Microwave Technology Co., Ltd.

The power supply voltage of the series products are ±5V ± 5%，which using TTL control(default “0”：ON；"1"：OFF.).The frequency range covered by 0.5GHz~40GHz.The products have the characteristics of small size, high reliability, low insertion loss and high isolation.The products are applied to all kinds of receiving and transmitting channels. KeyLink's switches can be categorized as follows.

Product

Receiver

-

Beijing KeHuan Century EMC Technology Co,.LTD

Beijing KeHuan Century EMC Technology Co,.LTD

A device or apparatus that receives electrical signals, waves, or the like, and renders them perceptible to the senses, as the part of a telephone held to the ear, a radio receiving set, or a television receiving set.

Product

Car-to-X Signal Strength Emulator

-

Qosmotec Software Solutions GmbH

Qosmotec Software Solutions GmbH

QPER-C2X is a special adaptation of the signal strength emulator QPER, designed for mobile and Vehicular Ad-hoc Networks (MANet and VANet). Every radio devices in such an infrastructure-less network acts as a sender, receiver, and forwarder (router). Therefore, the ports of the QPER-C2X hardware are fully connected with each other by dynamically controllable attenuators. The system is fully designed for frequencies up to 6 GHz, since wireless communication for Intelligent Transport Systems (ITS) is based on the WLAN standard IEE 802.11p from 5.850 MHz to 5.925 MHz. The connected ITS stations can be either on-board units, as they are built into cars, or road side units that are used by road infrastructure (traffic lights, road work area delimiters, velocity signs). For tests in the lab, radio modules of such ITS stations are each kept in a shielding box that prevents any unwanted radiation over the air.

Product

Gateway

CODA-4589

-

Hitron Americas Technologies Inc.

CODA-4589 - Hitron Americas Technologies Inc.

The CODA-4589 has the capability to receive 5Gbps based on 2 x OFDM + 32 QAM over its DOCSIS 3.1 interface.The integrated Wi-Fi 3×3 2.4 GHz 802.11n and 4×4 5 GHz 802.11ac Wave 2 dual band MU-MIMO Access Point significantly improves customer experience extending range and coverage with blazing speeds. For wired clients, the four Gigabit Ethernet ports offer ultra-fast connections. MoCA 2.0 bonding provides a near-Gigabit wired backbone in the customer’s home for Wi-Fi extension.

Product

900 MHz Antenna

PCA900

-

Lectrosonics, Inc.

PCA900 - Lectrosonics, Inc.

A unique and very useful design, the PCA900 antenna provides wide bandwidth from 825 MHz to 1 GHz, moderate gain of 3.7 dB  and a semi-directional polar pattern in a compact, rugged package. A BNC connector allows direct connection to receivers and multicouplers with standard 50 ohm coaxial cable. This antenna is an ideal match for systems in the 902-928 MHz and 941-960 MHz ranges.

Product

Ionizers

ESD

-

ElectroStatics, Inc.

ESD - ElectroStatics, Inc.

Electrostatic discharge (ESD) is the release of static electricity when two objects come static control ESD IT-7000 Tabtop ionizerinto contact. Familiar examples of ESD include the shock we receive when we walk across a carpet and touch a metal door knob and the static electricity we feel after drying clothes in a clothes dryer. A more extreme example of ESD is a lightening bolt. While most ESD events are harmless, it can be an expensive problem in many industrial environments.

Product

Amplifier Built-In/U-Shaped Micro Photoelectric Sensor [Compact/Connector Built-In Type]

PM-65

-

Panasonic Industrial Devices Sales Company of America

PM-65 - Panasonic Industrial Devices Sales Company of America

The Panasonic PM-65 Sensor has a beam emitting / receiving distance of 6 mm. The beam emitting and receiving areas are 0.5 mm thinner compared to conventional models even though the external dimensions have not changed. As a result, the distance between the beam-emitting and the beam-receiving points have increased by 1 mm thereby reducing the possibility of sensing objects colliding.

Product

Digital Wideband Transceiver Analysis

S94610B

-

Keysight Technologies

S94610B - Keysight Technologies

Digital Wideband Transceiver Analysis is an add-on software to Device Measurement eXpert (DMX) that adds cross-domain stimulus response measurements for digital/RF mixed-signal device characterization. Included Waveform Creator helps define digital IQ test stimulus waveforms that are used in the RF signal generators for receiver tests or downloaded to the digital-to-analog converters for transmitter tests. The DUT control is customizable to accommodate various data converters and transceiver types by defining device operation settings, transmit/receive switching, reading and writing digital IQ waveform from and to DUTs. Acquired RF or digital data is processed in the VNA’s applications for faster, accurate measurements and analysis.

Product

CATV & SAT IF Optical Receiver Module

MRS-26D

-

Hangzhou Huatai Optic Tech. Co., Ltd.

MRS-26D - Hangzhou Huatai Optic Tech. Co., Ltd.

*Ultra low noise push-pull technology *Band width of 2.7 GHz* 46dB CNR (typ.) for NISC with OMI = 4% at –8dBm optical input power @ 1550nm* 20dBmV RF output level (-5dBm,1550nm,OMI=4%)* Very low intermodulations *Low power consumption *Small package with single-mode fiber pigtail *Integrated optical demultiplexer (WDM filer) for RF overlay applications *Monitor voltage output and output disable input