Improvised Explosive Device
a cobbled together makeshift bomb. Also known as: IED
-
Product
Wireless Device Testing
-
D.L.S. Electronic Systems, Inc
WI the testing and certification of your Wireless Device will be accomplished with precision and efficiency.
-
Product
Circuit Breaker Simulation Device
PSS01
-
PSS01 is the circuit breaker simulator，which can conduct circuit breaker simulation to test the whole secondary relay scheme together with relay test set. It is very good accessory for protection relay test kit to avoid complicated software programming to finalize the same test.
-
Product
Device Testing
-
The BTL Working Group (BTL-WG) has developed a test package which contains a set of testing procedures. These can be acquired and used by manufacturers to pre-test their products for BACnet compliance before they send their products to an RBTO (Recognized BACnet Testing Organization) for BTL Testing. The BTL Test Package is available on the test documentation page.
-
Product
Optical Mixed Signal Devices
-
Analog Devices optical mixed signal devices comprise a portfolio of highly integrated analog front ends and integrated optical modules. The discrete analog front ends offer flexibility in optimizing a given solution. The integrated optical modules are highly optimized for applications such as vital signs monitoring in smart watches and other wearables and offer very small form factors and reduce the required systems engineering to get to market.
-
Product
Device Current Waveform Analyzers
-
The dedicated Current Sensors measure from 100 pA level dynamic current up to 10 A with a maximum of 200 MHz bandwidth. The mainframe acquires the signal from the sensors by a maximum of 1 GSa/s sampling speed and 14-bit and 16-bit wide dynamic range. This combination allows you to measure quite wide range of dynamic current, for example, from standby/sleep state to active state, at a single measurement. In addition, the wide bandwidth and the high speed acquisition enable you to measure high speed pulse response even less than 100 ns previously very difficult with existing instruments.
-
Product
Electrical Circuits Control Device
ZET 452
-
ZET 452 is an automated module for electrical circuits parameters control that is used for electrical circuits impedance and insulation resistance monitoring in automated mode. The monitoring is performed in accordance with the set participation and without participation of an operator. ZET 452 allows to reduce the time necessary for verification procedure more than in 20 times if compared with the standard measurement instruments normally used for these purposes.
-
Product
Monitoring Devices
-
TDK Monitoring Devices - rf shielded hd video camera, rf shielded hd mini video camera, camera controller
-
Product
Control Devices
-
National Meter Industries Inc.
4-input impulse centralising equipment. Inputsare optoisolated to read impulses and it has a 32-bit memory to store the valuesmetered.
-
Product
Device Thermal Test Systems
-
Thermal Engineering Associates, Inc.
Thermal test system combines the test and measurement capability of dedicated instruments with the ease of operation and data collecting capability offered by graphical-user-interface-driven software operating on an integrated computer.Diodes (PN, Schottky, LED, varactor, PIN), Stacked Diodes (Hi-V Rectifiers & LEDs), Laser Diodes, Transistors (Bipolar, MOSFET, IGBT) & Diodes, Integrated Circuits (Application & Thermal Test Die).
-
Product
Flash Storage Device
-
Axiomtek provides various industrial-grade flash storage device for customers to simplify and shorten the system design time.
-
Product
Wireless Device Testers
-
To keep the communications backbone of mobile radio technology running, powerful mobile radio networks are needed. For the complex measurements involved, Rohde & Schwarz offers a wide range of instruments and systems such as wireless device testers, infrastructure testers, protocol testers, conformance and preconformance testers.
-
Product
USB-8506 , LIN Interface Device
784664-01
LIN Interface
1- or 2-Port, USB LIN Interface Device—The USB‑8506 is a Local Interconnect Network (LIN) interface for developing applications with the NI‑XNET driver. The USB‑8506 is powered over the USB bus and does not require external power. The USB‑8506 excels in applications requiring logging or manipulation of hundreds of LIN frames and signals, such as in-vehicle data logging, bus monitoring, automation control, and more. The NI‑XNET device-driven DMA engine enables the onboard processor to move LIN frames and signals between the interface and the user program without CPU interrupts, minimize message latency, and free host processor time. The USB‑8506 is available with a three‑pin COMBICON synchronization connector for triggering and synchronizing the internal hardware timebase with other devices.
-
Product
Ferrite Devices
-
Ducommun's products include very broad ferrite device selections to cover 100 MHz to 110 GHz operation frequency range. These devices include narrow band drop-in (FID and FCD), connectorized (FIC and FCC), junction (FIW and FCW) isolators and circulators and iso-adapters (FII and FCI). The broad bandwidth versions are offered as full band junction isolators and circulators (FIF and FCF) and Faraday isolators (FFF). These devices feature low insertion loss, high isolation and wide operating temperature range. Low cost and volume production versions of these ferrite devices are available per customers’ request.
-
Product
Embedded Device Analytics Sytem
VQmon
-
VQmon® is the most widely deployed and trusted technology for analyzing the performance of IP based voice and video services. VQmon is highly compact and resource efficient, and can be integrated into a wide range of environments including routers, business and residential networking and telecom equipment, soft clients and test equipment
-
Product
Wired Serial Device Server
SD-300
-
The Silex SD-300 and SD-310AN are designed to easily connect and share RS-232 serial devices over a wired or wireless network. Industrial automation, building automation, medical devices, security access and control, point of sale devices, LED signs, bar code/label and other specialty printers, or virtually any other device with a serial port can be now be enabled with secure, robust wired or wireless network capability.
-
Product
Test Device for Bicycle Batteries
ATGF 1500/PBG
-
The ATGF 1500 is a multifunctional testing instrument for bicycle batteries and accompanying battery chargers. The easy to use ATGF 1500 is suitable for battery systems of Derby Cycle, Gazelle, Simplon and ZEG. est programs: Quick Test, Capacity Test, Recalibration.
-
Product
Multi-sensor Drug & Explosive Detection System
HDK
-
LDS Hybrid Detection Kit (HDK) - By operating the sensors in parallel, and in real-time, results in much higher probability of detection than the performance of each specific detector. Integrated solution including laser detection technologies, dual Ion Mobility Spectroscopy (IMS) and chemical detection, that operate in synch.
-
Product
IEC61588 Mandrel Test Device
CX-KD13
-
Shenzhen Chuangxin Instruments Co., Ltd.
This Mandrel Test Device conforms to IEC60588-1 Fig6 and IEC60065 Fig14--16.The test shall be performed by fixing the specimens of thin sheets on a mandrel made of nickel plated steel or brass with smooth surface finish.
-
Product
Differential And I/Q Device Measurements
S93089B
-
The S93089B combines source-phase control of multiple internal or external sources with frequency-offset mode, enabling simplified test of I/Q modulators/converters, differential mixers, and harmonics or amplifiers
-
Product
IV Characteristics Measurement Device [
PECK2400-N
-
Easy-to-use measurement software supports IV measurement (software + source meter + connection cable) ● Compatible with Windows 10 ● RS-232C connection (PC is optional) ● Works with NI GPIB. ● Simultaneous use with IPCE PEC-S20 D type is possible. ● There is only one operation panel. done on one screen.
-
Product
Passive Devices
-
Passive Devices by Senko - attenuators, fused products, optical switches, plc splitter series, routing, WDM series, and more
-
Product
Device Connectivity
-
The ability of electronic devices to link and exchange data with each other, users, or the internet using wired or wireless technologies, forming networks that enable functions like remote monitoring, automation, and seamless data sharing, crucial for the Internet of Things (IoT) and smart systems.
-
Product
Mature & Discontinued Devices
-
The product families on this page have been classified as "Mature". In most cases there is a newer technology product family that will better meet the needs of today's system logic designers. Designers working on new designs are strongly encouraged to evaluate the alternative product families listed in the "Use for New Designs" column. Unless a Mature Family has been formally superseded via our Product Change Notification (PCN) procedure Lattice will continue to support existing business for these Mature products. Certain of the products for which the PCN process has been completed have been transferred, as indicated in the table, to Rochester Electronics or Arrow Electronics. Please contact those companies for availability of the products indicated.
-
Product
IOT Devices Testing
-
IoT devices refer to Internet of Things Devices. They are hardware devices programmed for specific applications and can transmit data over the internet and other networks. IoT devices include sensors, gadgets, actuators, gaming consoles, smartwatches, voice control devices, machines, vehicles, buildings, etc. collection and exchange of data.
-
Product
SpaceWire EGSE & Device Simulator
312
-
The SpaceWire EGSE & Device Simulator is a programmable hardware unit designed specifically for generating sophisticated test schedules involving precision timing and creating accurate real-time simulations for SpaceWire enabled instruments.
-
Product
Microfluidic Device Manufacturing Solutions
-
We provide production automation solutions for microfluidic device manufacturing with precise liquid dispensing. We offer solutions for your POC test, molecular and immunodiagnostics and microfluidic devices manufacturing.
-
Product
PoE Powered Device Analyzer Family
-
A family of Intstruments and Software, including Automated Test Suite Options, to assure interoperability of PoE Powered Devices
-
Product
Integrated NDT Inspection Device
FlawHunter
-
The FlawHunter is an integrated NDT inspection device, equipped with an advanced, high-resolution Laser Shearography sensor with a vacuum (partial) excitation system. It is ergonomic & easy-to-use and is equipped with a workflow-oriented, GUI-display and left/right-hand button control. Regardless of the application, the FlawHunter provides reliable and resolute measurement results for in-field (service) NDT and quality control (post-production) operations.It can be used on any material & surface provided a stable vacuum can be generated within the vacuum seal (viewable inspection area).
-
Product
Security Devices
-
Schweitzer Engineering Laboratories, Inc.
Security devices protect perimeters and secure communications within LANs.
-
Product
Electronic Safe & Arm Devices
-
Excelitas Technologies specializes in the design, manufacture, and testing of MIL-STD-1316 compliant Electronic Safe and Arm Devices (ESAD), Electronic Safe, Arm and Fire Devices (ESAF), and Firing Modules (FM) for safe fuzing requirements of both legacy and next-generation missiles and munitions. Our dedicated staff of research and design experts use the latest advances in technology to design smaller, lighter, and more cost effective ESAFs and FMs to meet evolving requirements of newer more sophisticated weapon systems. Capabilities include a line of components and subsystems that have been qualified for hard target penetration environments and next-generation smaller-class munitions.
