Product

Footwear Testing Machines

-

Dongguan Amade Instruments Technology Co., Ltd

Dongguan Amade Instruments Technology Co., Ltd

Footwear testing machines are designed to determine a variety of mechanical and chemical performances of different types of shoe materials and finished shoes including sneakers, high-heeled shoes, leather shoes, casual shoes, etc. There are appearance performance tests including yellow resistance test, ageing resistance test, fastness resistance test, etc, physical performance tests containing flexing resistance test, rubbing resistance test, anti-slip test, etc, biological and chemical performance tests covering PH test, Formaldehyde content test, flame retardant test, etc,  and service life test. Applicable to standards of ISO20344, SATRA, ASTM, etc.

Product

Hardness Tester

-

JINAN PRCISION TESTING EQUIPMENT CO., LTD

JINAN PRCISION TESTING EQUIPMENT CO., LTD

Hardness testing is measuring a material's resistance to permanent deformation at its surface

Product

Decade Box, Calibrated W/Data, Resistance, 7, 1ohm to 11.11111Mohm, 1 %

72-7270 CAL D

-

Tenma

72-7270 CAL D - Tenma

The 72-7270 CAL D from Tenma is a resistance decade box. It is ideal for service, prototype and experimental use. This useful tool may be set resistance value from 1 to 11,111,110 ohm in one ohm increments. The decade accuracy is ±1% resistors used throughout. It has weight of 320g/0.70lb and dimension 14.7cm × 11.7cm × 5.5cm (5.79" × 4.61" × 2.16"). It is typically used in general applications, troubleshooting, maintenance, education and vocational training, production line testing, radio and TV services, working standards, research design & develop, physics laboratory work.

Product

Shunts

-

Howard Butler Ltd.

Howard Butler Ltd.

Highly accurate manganin resistance d.c shunts. When a current is passed through the shunt a proportional millivolt output is produced.

Product

Electric Insulation Oil Automatic Measurement System

DAC-5016

-

Soken Electric Co. Ltd

DAC-5016 - Soken Electric Co. Ltd

DAC-5016 is an automatic test system of insulation oils according to JIS C-2101.The system automatically enables changing over samples (liquid cells) up to max 8 pieces and testing the dielectric loss tangents and the volume resistivities.In automatic mode, the dielectric loss tangents and the volume resistivities are automatically measured, and then the results are printed out with the built-in printer. And the relative permittivities and the volume resistivities calculated are also printed out. Therefore the test time is greatly saved compared to the conventional test methods.

Product

Bench Digital Multimeter, 4.5, USB, 20 A, 750 V, 0.2 Gohm

72-13625

-

Tenma

72-13625 - Tenma

This 72-13625 is a manual range, benchtop digital Multimeter that features 19999 display counts, large LCD screen with backlight, full scale overload protection and a unique design. This instrument can be used to measure AC and DC voltage, AC and DC current, resistance, frequency, capacitance, transistor, hFE, diode (LED), SCR, continuity, etc.

Product

Built For Demanding Environments, The AIM-77S Rugged Case Delivers Reliable Protection With Drop Resistance Up To 120 Cm Onto Plywood.

AIM-77S Rugged Case

-

Advantech Co. Ltd.

AIM-77S Rugged Case - Advantech Co. Ltd.

Operating Temperature: 0°C ~ 40°C (32°F ~ 104°F)Storage Temperature: -10°C ~ 60°C (14°F ~ 140°F)Humidity: 90% @40°C (non-condensing)Drop Protection: up to 120cm onto plywood

Product

General Purpose Pressure Transducer and Transmitter

P55

-

Validyne Engineering

P55 - Validyne Engineering

The robust P55 pressure transducer provides cost-effective reliability for severe test environments. With extreme resistance to shock and vibration, the P55 pressure transducer delivers the same high-level performance expected from more delicate differential pressure transducers and pressure transmitters. With variable reluctance sensing technology, the P55 pressure transducer delivers fast dynamic response, high resistance to vibration and superior signal stability through ambient temperature change for a wide variety of low-pressure to high-pressure measurements. The P55 pressure transducer will accept both liquids and gases directly at the sensing diaphragm and there are no internal isolation fluids to slow the sensor response or cause excessive temperature drift errors.

Product

PAT Check Box

369A910

-

Di-Log

369A910 - Di-Log

The only check box to provide comprehensive verification of 17th Edition and PAT test equipment. The Powercheck tests for full earth continuity, insulation, resistance, RCD trip time, RCD trip current, touch current and flash test verification.

Product

LCR Meter

-

MRC ltd.

MRC ltd.

LCR meter is used to measure the inductance (L), capacitance (C) and resistance (R) of an electronic component.

Product

Insulation Resistance Testers

-

Shanghai Beha Electronics Co., Ltd.

Shanghai Beha Electronics Co., Ltd.

*This is a variable high voltage insulation tester from 500V to 15kV in 500V steps.*The is menu driven and uses Dynamic Current Auto ranging technology.*It has a Bar-Graph which displays the voltage stressing the insulation while the test is in progress and the voltage decay during the automatic discharge of the tested circuit.*The top line of the display shows the elapsed time at the start of the test. Digital readout of the total time will remain displayed even after testing has ceased.*A 4-digit display (2000 counts) is showing the actual insulation resistance.*This instrument displays a voltage warning and sounds when AC or DC is present before injecting the test voltage.

Product

Semiconductor Large Range Type Tester

HS-PSTT

-

HenergySolar

HS-PSTT - HenergySolar

HS-PSTT large Range Type Tester is a high-grade semiconductor material Type testing equipment,has the feature that testing large range,special suitable for testing the high-Resistivity Silicon Material(contains Silicon Core, phosphorus stick, Boron stick and so on),the resistivity require range is 0.0001～19999Ω·cm, Covers all measurement requirements of various silicon material type testing at the semiconductor and solar energy level at present .

Product

Fiber Optic Sensor & Amplifier

FG-1300 | FS-5500/FS-540

-

Ono Sokki

FG-1300 | FS-5500/FS-540 - Ono Sokki

The FG-1300 is a non-contact type high-performance amplifier that emits red light from LED to a rotating object, and detects the variation of the reflected red light amount.This amplifier is used in combination with an exclusive detector FS-5500*/FS-540 Fiber Optic Sensors which has adopted environment resistant design. The glass fibers are covered with flexible stainless steel tube for rotation measurement in limited space.

Product

Current Transformer Tester

CTT

-

ndb Technologies Inc.

CTT - ndb Technologies Inc.

The CTT is designed to test the current transformer ratio, Phase shift, Polarity, Excitation, Saturation, Winding resistance and Insulation resistance using the voltage method in compliance with ANSI/IEEE C57.13.1 and IEC 60044-1 standards, where voltage is applied to the secondary X terminals of the current transformer.

Product

Wound Component EST Scanner

19035

-

Chroma ATE Inc.

19035 - Chroma ATE Inc.

The quality verification tests for wound components consist mainly of AC/DC Hipot tests and insulation resistance (IR) tests. The Chroma 19035 wound component EST scanner series perform safety tests for motor, transformer, and heater related wound products.

Product

Decade Box, Calibrated W/D & U, Resistance, 7, 1ohm to 11.11111Mohm, 1 %

72-7270 CAL DU

-

Tenma

72-7270 CAL DU - Tenma

The 72-7270 CAL DU from Tenma is a resistance decade box. It is ideal for service, prototype and experimental use. This useful tool may be set resistance value from 1 to 11,111,110 ohm in one ohm increments. The decade accuracy is ±1% resistors used throughout. It has weight of 320g/0.70lb and dimension 14.7cm × 11.7cm × 5.5cm (5.79" × 4.61" × 2.16"). It is typically used in general applications, troubleshooting, maintenance, education and vocational training, production line testing, radio and TV services, working standards, research design & develop, physics laboratory work.