Broadband Light Sources
-
Product
Light Sources
-
There are many low cost artificial light sources used for illumination or for industrial applications: tungsten or halogen bulbs, fluorescent lamps, LED lamps etc. Some of these sources have regulated intensity of emitted light. However, there very few calibrated light sources of precisely known parameters. A light source can be considered as calibrated when its user can precisely regulate its photometric/radiometric parameters like luminance (or illuminance), radiance (or irradiance) at defined spectrum of interest. Such light sources are needed in many applications among them, in systems for testing night vision devices, VIS-NIR cameras and SWIR imagers. Inframet offers a series of calibrated light sources that can be divides into three groups:
-
Product
Portable Light Sources
FOD 2112
-
The FOD 2112 provides two wavelengths: 1310&1550 nm. Available adapter types: FC, SC, ST, Universal 2.5mm. All adapters are changeable. Available hybrid adapter types: FC to LC, FC to Universal 2.5mm
-
Product
Optical Light Sources
-
A fiber optic source is commonly used with a meter to measure optical fiber attenuation or insertion loss.
-
Product
Forensic Light Source
CrimeScope CS-16-500W
-
The flagship of the SPEX Forensics Product Line, the CS-16-500W was designed for those departments that prefer the power and IR capabilities of 500W Xenon lamps.
-
Product
Broadband Detectors
-
These waveguide bandwidth detectors use silicon beam lead diodes on a planar stripline circuit to obtain an extremely rugged and compact device. Most millimeter wave broadband detectors have very poor VSWR due to the difficulty in obtaining a good wideband impedance match to the diode. To overcome this problem, these detectors utilize two diodes and an internal matched termination and 3 dB hybrid as shown below. This circuit allows a VSWR of 2.0 or better over a full waveguide bandwidth for most of these detectors. Detectors for waveguides WR-8 and smaller use a single zero bias GaAs diode. The high sensitivity zero bias GaAs diodes can also be special ordered for use at lower frequencies when highest sensitivity is required.
-
Product
Multi Channel LED Light Source
LE7
-
Image Engineering GmbH & Co. KG
The iQ-LED is the latest development of Image Engineering. It is a multi channel LED light source that provides the possibility to generate the spectral characteristics of nearly every required light source in just one device. With its 22 different software controlled LED channels it is possible to generate a spectral match of standard light sources such as, D50, D55, D65, A, B, C etc. with very high accuracy.
-
-
Product
Source Measurement Unit
SMU8
-
The SMU8 offers high voltage SMU in a compact, 3U PXI / USB form factor. The SMU8 supports 0V to +4V 0.5A or 0V to +12V 25.6mA with FVMI, FVMV, FIMV, FIMI modes. 8 channel can be ganged to support high current driving.
-
-
Product
Handheld Fiber Optic Light Source
-
Anfkom International Co.,Limited
3109 optical light source can provide 1 to 4 output wavelengths to meet specific requirements,including the 650nm red source and the 1310/1550nm wavelengths for single mode fiber or the 850/1300nm wavelengths for multimode fiber,as well as other wavelengths according to customer needs.Together with the 3208 optical power meter, it is a perfect solution for the fiber optic network characterization.
-
Product
Residential Broadband Access
-
Revolutionize communities with disaggregated and flexible broadband solutions from Radisys. Optimize your network and accelerate new rollouts with open and disaggregated networking for next-gen residential broadband solutions.
-
Product
Calibration Light Source
CAL2
-
Image Engineering GmbH & Co. KG
The CAL2, based on our 22 channel spectrally tunable iQ-LED source, can be adapted for use in many different areas.
-
Product
Compact Deuterium, Tungsten Halogen or Glow Bar Light Source
LSH Illuminator
-
Compact lamp housing for a variety of types of light sources from the UV to the IR including deuterium, tungsten halogen and glow barApplications for compact arc lamp housings cover a broad range of scientific, OEM and research applications. Arc lamp illuminators are used for a broad range of applications almost as diverse as the wavelength range across which they emit.
-
Product
Light Sources and Amplifiers
-
Light sources simulate the optical voice, video and data signals of real-life service applications, which is why they are used in various types of tests. Discover a broad range of products that cater to various testing requirements: singlemode or multimode, polarized or non-polarized, broadband or narrowband, tunable, ITU-wavelength-centered and much more.
-
Product
Light Meters
-
Our light meters are designed for simple and accurate results in an industrial setting. Whether you are checking work spaces, parking lots, or baseball fields for safe levels of lighting or measuring for testing design compliance, a light meter from Sper Scientific will get the job done. Obtain precise UV, FC or Lux measurements, in multiple light measurement ranges. These light meters are designed for use in work spaces, labs, schools, outdoor studies, optics, home inspections, and many others. In addition, you may use these meters to check compliance with ANSI/NFPA 101 (standards for emergency & exit lighting).
-
Product
Source Measurement Unit
PEMU4
-
The PEMU4 represents a new level of performance and capabilities for USB-based SMU (Source MeasurementUnit) instrumentation. The PEMU4 supports -1V to +6.5V 0.5A with FVMI, FVMV, FIMV, FIMI modes. 4 channel can be ganged to support high current driving. I2C/SPI/RFFE function for serial port device testing. 4 Counter for frequency measurement.
-
Product
Broadband Sensors
-
Offers a response between 120 sec and 160 Hz in a smaller, rugged, low power and low cost system that is easy to install and deploy. Built with ease of installation in mind, it does not require mass lock, mass centering, and has a large operational tilt range which combines to reduce installation training, time, and cost.
-
Product
Integrating Sphere Light Sources
-
Integrating sphere light sources with LED based or continuous broadband emission spectrum for use as luminance standards for camera calibration, for the determination of veiling glare, for the adjustment of night vision devices and much more. Diameters in the range from 50 mm to 500 mm with options like monitor detector, signal output control by manual and remote apertures and much more.
-
Product
High-Speed Lighting
-
Atlas Material Testing Solutions
Better pictures matter, especially in the automotive safety industry. No matter whether coming from Real-Crash or the Crash-Simulation stand - only high-quality pictures will allow researchers to get insights for superior product improvements.
-
Product
Small Step Broadband Synthesizer
SBC Series
-
*Connectorized Package *Fine Resolution Design *Broadband Designs Available *Low Phase Noise *Ultra-Low Spurs *Optional Internal Reference
-
Product
Broadband Power Amplifier
PAS-08042-60
-
* Solid State Power Amplifier* Small Signal Gain: 60 dB typ.* Rack Mount Case* Internal Cooling Fans*Type N Connectors* Over-voltage, over-current protections
-
Product
DFB Laser Source Module
LaserPXIe 1200 Series
-
The LaserPXIe 1200 Series is a highly customizable DFB laser source available in a wide range of wavelengths and powers.
-
Product
Broadband Products
-
Quintech Electronics and Communications Inc.
Your product description goes here.
-
Product
L-Band ASE Light Source
ASE6000
-
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai ASE6000 series is L-Band ASE light source with featured with high stability and high output. It is mainly applied for testing of L-Band optical components and optical communication equipments as well as Fiber Optical Sensor etc. Huatai ASE6000 has three types of exterior structure, suitable for different customer’ requirements.
-
Product
Light Sensor
NaPiCa
-
Panasonic Industrial Devices Sales Company of America
Visible light sensor (Silicon Photo IC) that detects light and converts into electrical current. Consists of a photodiode and built-in amplifier. Optical filter provides spectral response similar to human eye sensitivity. Applications include: LCD Backlight Control, Commercial and Residential Lighting Brightness Control, Security Lighting.
-
Product
Laser-Pumped White Light Source
LS-WL1
-
Our LS-WL1 is a laser-pumped white light source with a light output of up to 440 mW from a 600-µm fiber and a wavelength range of 450 – 700 nm, designed especially for professional requirements for extremely high luminance.
-
Product
Light Microscopy
-
Materials Evaluation and Engineering
MEE has a variety of light microscopes with magnifications ranging from 5X to 2400X. Each microscope is connected to a camera with digital image capture for subsequent measurements and/or additional image analyses.
-
Product
Broadband Horn Antennas
-
Offer a very low SWR in their nominal frequency range and a very broad bandwidth. The increasing gain with frequency helps to compensate cable losses. Is suitable for both, transmission and receiving applications. The max. allowed Input Power is only limited by the coaxial connector.
-
Product
Forensic Light Source
HandScope LASER
-
The new HandScope LASER is the latest Forensic Light Source by SPEX Forensics. The unique design allows one-hand operation. The same hand holding the light source can change cycle through the four different wavelengths and three power settings using the LCD touch panel. No other Laser offers the same versatility.
-
Product
Light Sources
-
These external units provide illumination which is transmitted to the viewing instrument by a light guide cable, and then through the scope via the integral fiber bundle to the viewing tip.
