Filter Results By:
Products
Applications
Manufacturers
Component
Testing of individual hardware or software components or groups of related components.
-
product
110 GHz Lightwave Component Analyzer
N4372E
The N4372E lightwave component analyzer helps you with optoelectronic tests with its measurement capability of 110 GHz in an extended wavelength range. It also offers RX testing up to 110 GHz in the full 1260 nm to 1620 nm range. It has a built-in optical power meter that enables you to check and control the operating power. The N4372E lightwave component analyzer's optical transmitter input port connects to an auxiliary tunable laser to verify S-parameters over wavelength.
-
product
DUT Prototype Board
DPB8800
The DPB8800 is an 11? x 14? PC board used to interface the tester with the Device Under Test (DUT). This board contains generous area for custom circuitry and extra relays. The DPB8800 is also available with standard solutions to test families of components like Op-Amps, Regulators, ADC?s and DAC?s. +/-15 V and +5 V are available to support circuitry biasing.
-
product
High Voltage Divider
HIGHVOLT Prüftechnik Dresden GmbH
Is a passive linear circuit that produces an output voltage (Vout) that is a fraction of its input voltage (Vin). Voltage division is the result of distributing the input voltage among the components of the divider. A simple example of a voltage divider is two resistors connected in series, with the input voltage applied across the resistor pair and the output voltage emerging from the connection between them.
-
product
DC Current Bias Supply
DC1000A
To guarantee the quality and performance of inductive components such as inductors, chokes and transformers they are tested at their real-life operating point. If the inductor is designed to carry a DC current, then its inductance must be measured with that DC current present. Until now, these measurements were made by an LCR meter connected via special interfacing to a DC bias supply available only from the manufacturer of the LCR meter. The unique NEW DC1000A can be used with any precision LCR meter and connects simply into existing test fixturing.
-
product
Power Metering Precision Shunt Resistore
PMS
These components have E-Beam welded manganese-copper alloy elements giving high strength, stability and reliability. Low thermal EMF and TCR. Small size and minimal power loss. Minimal heat generation and surface temperature due to small total resistance. Proprietary processing technique allows very low resistance values. Ideally suited for KWh meters and sampling sensor shunts. These units are also suitable for custom design.
-
product
Single Phase Energy Meter Type DDS999
Bofa Instrument & Equipment Co., Ltd
DDS999 series Single Phase energy Meter are new and high-tech products adopting special large-scale IC, latest micro-electronic technology and SMT production crafts. It is designed for rough working condition and components selection as foundation, so it can ensure the long-term stable operation.
-
product
Hyphenated Technology
Evolved Gas Analysis (EGA) solutions couple two or more analytical technologies to greatly increase the power of analyses and save precious time by acquiring more information from a single run, creating a powerful and easy-to-use platform for materials characterization. EGA Hyphenation is a powerful tool in the analysis and identification of complex mixtures, both known and unknown, including identifying harmful chemicals in soil, quantitating components in polymers, determining leachables that may contaminate a product's packaging, identifying phthalates in PVC samples and more.
-
product
Microwave and RF Switching Systems and Drivers
CXM Series
This series is typically used for frequencies from DC to 40 GMHz. We use microwave relays, splitters, programmable attenuators and many other microwave components from the worlds most popular vendors to build standard or custom systems to your specifications. There are a large variety of 1x2 through 1x12 microwave relays available in Normally Open, Failsafe, Latching, Terminated or special configurations to suit your needs. Or simply buy the driver chassis and use it to control your own components. Since Cytec doesn"t build microwave components we can put the systems together with whatever parts you prefer and stand behind the warranty for you.
-
product
NIR & UV-VIS Process & Lab Analyzers
Our Guided Wave complete analytical systems utilize proven Near Infrared (NIR) and Ultraviolet / Visible (UV-VIS) spectroscopic techniques. We deliver a total solution that includes optically matched components and a well-planned calibration approach leading to long-term success and savings. Our state-of-the-art systems are designed for continuous online use, providing real-time data of laboratory quality while thriving in the most demanding processing plant environments. We work with you to tailor a solution for your exact requirements from analyzer to interface.
-
product
Fire Suppression/Detection
Dexter's sensitive yet rugged fire detectors, or fire sensors, serve as the foundation of US combat fire suppression systems on combat aircraft and ground vehicles ranging from the HUMVEE to the Abraham's Tank. Our fire sensors consume low energy, making them the premier safety component on battery-powered as well as hot-wired systems. We like to call them "the eye that never sleeps." How fast are they? Fast enough to race the fire caused by a rocket hitting a fuel tank and win, triggering fire suppression on the spot to help protect soldier and pilot alike. Rugged missions require rugged equipment. Intensive MIL-STD-883H testing performed by Trialon Corporation, an independent testing facility, confirm that Dexter Research's silicon-based temperature sensor detectors meet the same rugged requirements of 1,000G's for mechanical shock and 30G's in random vibration for which our thin-film detectors are famous. Download Dexter's report here (PDF).
-
product
Unequal Split Power Tappers
Pasternack unequal split power tapper product designs are also known as unequal couplers, power dividers or splitters, cross band couplers and signal samplers. Many of our unequal couplers / tapper series are RoHS and REACH compliant. Unequal RF tappers from Pasternack are available with 4.1/9.5, 4.3-10, 7/16 DIN and Type N connector options. These unequal split power tapper components for RF are manufactured to precise specifications required for accurate specified values listed for each product. Unequal split tapper products work with high power of up to 300 watts depending on style. Frequency ratings for unequal power splitter line are wide band components with a 380 MHz to 6 GHz frequency range, based on model selected. Pasternack RF power tappers in unequal design can be ordered with various directivity (dB) values of 4.8dB, 5dB, 6dB, 7dB, 8dB, 9dB, 10dB, 11dB, 12dB, 13dB, 15dB, 16dB, 20dB, 30dB depending on model. As with our other over 40,000 RF, microwave and millimeter wave components from Pasternack, this unequal split power tapper/coupler/divider series for RF is in-stock. These unequal split power tappers are not just in stock, but they will also ship the same-day are they are purchased.
-
product
Vision Measurement Technologies
Some manufacturers of metrology systems utilize one single technology to measure a wide range of components despite the different form factor of each of the components, which can drastically affect the quality of the measurement.
-
product
High Voltage AC Test Systems
Our range of high voltage AC test systems cover from 5kVac to 100kVac. All units have a variable trip range setting and key lock operation to prevent unauthorised use. Applications include testing of insulation systems and measurement of break down voltage of electrical plant and components.
-
product
Fused Wavelength Division Multiplexer（980/1550,1480/1550nm）
Flyin Optronics’ WDM components can effectively combine or separate single mode signals at two wavelength ranges. Available in three wavelength ranges (980/1550 nm, 980/1310 nm, and 1480/1550 nm). Based on the proven Fused Biconic Taper (FBT) technology, these multiplexers provide broad operating wavelengths and low insertion loss. All our WDM are available with any connector style (FC as standard, other connectors available upon request), and include 900 µm loose tubing to protect the fibers.
-
product
Adapters
BroadWave designs and manufactures Coaxial Adapters and other coaxial RF components that are ideally suited for test, verification and system integration. Our products offer consistent performance at a low cost with an emphasis on performance and configuration flexibility.
-
product
Optical Profiler
DRK8090
Shandong Drick Instruments Co., Ltd.
This instrument uses noncontact, optical phase shift interferometry method does not damage the surface when measuring graphics can be quickly measured by a variety of three dimensional surface morphology, and analyzed to calculate the measurement results. Suitable for measuring a variety of blocks, the surface roughness of optical components; scale, dial the groove depth; magnetic (optical) disk, the head surface texture measurements; structural morphology of coating thickness and coating trough structure at the boundary of the grating; silicon surface roughness measurement and the graph structure and so on.
-
product
Environmental Test Chambers
CSZ offers a large selection of environmental test chambers with quality construction and innovative technology, serving a variety of industries. Temperatures range as low as -84C (-120F) with high temperatures to +350C (+662F) and humidity ranges from 10% to 98% RH. Test chamber sizes range from small benchtop chambers for testing small components to full walk-in/drive-in rooms large enough to accommodate a semi-truck and trailer or larger.
-
product
Partial Discharge Detector
PXDP-II
The PXDP-II partial discharge meter is a portable device that performs detection and measurement of partial discharges in electrical devices or components. It records partial discharge measurements for analysis and diagnosis through the optional PC software. The PXDP-II can be used in various applications and complies with IEC 60270.
-
product
Digital Accelerometer
ZET 7152-N-VER.1
Digital accelerometer ZET 7152-N-VER.1 has a compact triaxial sensing element; it is purposed to measure linear acceleration and vibration acceleration variable component in three mutually perpendicular planes. Light weight of sensing element (only 1.5 g) considerably decreases self-mass load effect, and compact dimensions (8.5×8.5×8.5 mm) allow using ZET 7152-N-VER.1 digital accelerometer to measure vibration in small work-area systems.
-
product
Banana Plug Test Clip
PCS
The PCS-MB Parrot Clip model is a Banana Plug Test Clip of a medium size, with a length of 70 mm, including the metal tip and the button. Its weight is 7 g, Due to the banana connection the PCS-MB Parrot Clip can be connected to different cable leads. This is convenient when you want to use different clips like alligator clips or parrot clips or just the banana plug at the leads. The PCS-MB provides also reliable hands-free connections for different component sizes from SMD with the W1 tip up to the W4 tip.
-
product
Inverted Microscope Systems
Below you can see examples types for an inverted microscope system created using our components. Typically these examples are for life science applications, however they can be used for industrial or material applications. Many other automated microscopy systems are possible using our components.
-
product
Test adapter LRM-LR (Type D)
MA-LML01F
Hachmann Innovative Elektronik
Our test adapter MA-LML01D connects LR measuring devices to LRM string parts. Due to the flexible realisation of the LRM-part it is possible to evaluate mechanical non-standardized string parts, as they can be found in switch components, relays or integrated voltage displays.
-
product
Component Test
Our innovative multi-function Electrical Component Testers have advanced functions such as voltage power control feed to activate components like radiator fan, headlights, horn, actuators, etc. and the sensor simulator can provide simulation of voltage signals, frequencies, square waves & duty signals with varying intensity to test the feasibility of good sensor signals in comparison to bad ones when troubleshooting vehicle electrical faults.
-
product
RF/MicrowavePrototyping Boards and Housings
MicroAmp2
MicroAmp2 is a new series of RF/microwave prototyping boards and housings that allow for rapid construction of custom circuits in a fraction of the time and cost of traditional solutions. With the MicroAmp2 series of MB boards, a designer can quickly build amplifiers, filters, passive networks, multipliers, prescalers, log detectors, oscillators, and opamps using many popular components. A growing line of MB circuit boards are available to fit many of the industry-standard components, which can be easily assembled and mounted into shielded RF housings to create fully functional modules. Select parts from popular manufacturers such as Analog Devices, Avago, CEL, M/A-COM, Mini Circuits, RFMD, Triquint, and others.
-
product
Gas Tester for Measurement of Petrol, CNG, and LPG Powered Vehicles
M4GT / MAHA 4 GASTESTER | VP 135120
Maschinenbau Haldenwang GmbH & Co. KG.
The MAHA 4-Gas Tester serves for the measurement of petrol, CNG and LPG powered vehicles as well as the precise analysis of the gas components HC, CO, CO2, O2 with lambda value calculation. The M4GT impresses with its low weight, compact design and short warm-up time for easy handling, precise measurement results and rapid measurement readiness.
-
product
Altitude Simulation
MEDAS
The MEDAS system is a compact altitude simulator that reproduces a wide range of environmental conditions. It allows for testing light- to heavy-duty vehicles, including Non-Road Mobile Machinery (NRMM). It is ideally suited for a range of testing applications, such as durability, RDE replication, emission tests and mapping as well as tests from component to vehicle level. The patented technology inside the MEDAS system allows dynamic changes on the simulated atmosphere with high accuracy. The system can also be moved between different test cells due to its compact design.
-
product
Cross Domain Security Solutions
Stratign’s Cross Domain Security Solutions are highly trusted, government-accredited network security components that control and, if necessary, block the flow of data between two security domains at all layers.
-
product
Linear Motion Potentiometers
A spin-off of the Trimpot trimming potentiometer product line, the linear motion potentiometer was developed to meet the needs of designers wishing to detect movement of position. Applications for these compact components include: Solenoid positioning sensors for automated controllers, volume control on audio equipment, joystick controllers, satellite dish positioning, and robotics.
-
product
Plugbord
3677
VECTOR Electronics and Technology, Inc.
44 Gold plated edge contacts (22 each side)on 0.156"(3.96mm) centers. 3-Hole solder pads (0.28” x 0.080”) and buses forinterconnecting multiple component leads. No pattern on reverse side, edge contacts only Row and column legends provided.
-
product
In-Circuit Test Systems
TestStation In-Circuit Test Systems provide full structural and functional coverage for a wide range of manufacturing, component, process, and performance for high-performance analog, digital, and mixed-signal devices used on modern PCBs.
