Positioning
Aligning test set with target geography.
-
Product
Cable Assembly, Receiver, TriPaddle, 36", 10 Position Combicon and 4 Position Omnimate
540295010201
Cable Assembly
Cable Assembly, Receiver, TriPaddle, 36", 10 Position Combicon and 4 Position Omnimate
-
Product
Battery Monitor Relay
BMR
-
The Battery Monitor Relay contains over under voltage sensors combined with positive and negative ground detection.
-
Product
Actuator
SCX-SA
-
Actuator for the ignition key in vehicles. Stand-alone controller with buttons for position selection and external selection via potential free contacts.
-
Product
Portable Microscope With XY Stage, X150 2mm Field Of View
-
*Veterinary Worm Egg Counting*Counting of algae and other samples*Easy positioning of the sample*Methodically scanning of slides and counting chambers*Works with standard microscope slides and counting chambers (25x75mm or 1”x2”) and with 32mm wide counting chambers*Allows manual movement of the slide and counting chamber independently in the left-right (X) axis and front-back (Y) axis
-
Product
Source Systems AC
-
The power sources of MTS-series based on digital amplifier modules combined with frequency generator and reference device are the MTS source system. Single-phase systems (MTS1xx) or three-phase systems (MTS3xx) from 1 to more than 40 test positions are available.
-
Product
Photonics for Measuring Laser Output
Ray gt Photonic
-
raygt photonics for measuring laser output assist international research laboratories and laser technology manufacturers with precise positioning and output data.
-
Product
Signal/Thermocouple, Module, ITA, TriPaddle , 90 Series, 84/12 Position
510108245
ITA Module
Primary mating module 510104261.
-
Product
Eyepiece-less Stereo Microscopes
-
Vision Engineering’s eyepiece-less stereo microscopes are better for users and for business. Their ergonomic design lets the operator sit back in a comfortable position, and the expanded pupil technology delivers an enhanced 3D view of the subject. The relaxed natural posture makes it easy and to work with tools and to manipulate the subject. Greater comfort and ease of use directly translate into greater productivity and quality.
-
Product
Spring Back Tester
HTJ-16
-
Shanghai Dean Electrical Co., Ltd
Executive standard: GB/T4074.3-2008/IEC60851-3; Inspection standard: JB/T4279.4-2008Used to measure the spring back characteristic of enameled round wires with nominal conductor diameter of between 0.080mm and 1.600mm;Number of winding turns: 5 turns and a halfStop accurately at zero position of the scale after automatic windingAs soon as the value of spring back angle stop counting, the dial will stop to rotate immediately, so that the value displayed on LED and read on the dial are the same.Sensor is unnecessary to be adjusted for samples of different specificationsCoils loosen slowly during spring back, no action of spring back or jump suddenly.Application of SCM control allows for fast operation and strong anti-interference capacity;
-
Product
Fully Automated In-line Test System For LED Light Engines
-
We are pleased to announce that we have received an order for the supply of a fully automated in-line test system for testing LED light engines from ASD Lighting, based in Rotherham. The solution provided, consists of an in-line handler fitted with a vision system. The camera software is capable of learning the position of all LED’s on a new pcb, thereby reducing the time to introduce a new product. In addition to identifying the location of any missing or faulty LED’s the tester measures the colour temperature of every pcb. An image is taken of faulty units with the location of any missing LED’s identified
-
Product
Signal, Module, Receiver, CASS, 210 Position, Right Angle PCB Mount
510113124
Receiver Module
Signal, Module, Receiver, CASS, 210 Position, Right Angle PCB Mount.
-
Product
20-Pin Scorpion Female Connector, 20A, Straight PCB Mount
C020AFX-2PS-2A
-
This is a female 20-pin Scorpion Connector, straight, suitable for PCB mounting. The connector is keyed to position 1 and it has a maximum current handling of 20A and is suited for direct connection to Pickering Interfaces products.
-
Product
4-Channel High Speed Trigger And Latch EtherCAT Module
AMAX-4270
-
4-channel 32-bit encoder countersEncoder input mode : CW/CCW , Pulse/Direction, A/B PhaseEncoder input signal : A, B, ZEncoder input frequency : 5 MHz (Maximum)4-channel trigger DO for position compareTrigger output frequency : 10 kHz; latch input frequency : 10kHzTrigger output mode : sink, source, TTLSupports trigger delay time setting for each channel4-channel latch DI for position latch
-
Product
C07A THT Horizontal Or Vertical | Threaded Or Non-Threaded | With Shaft
C07A-Overview
-
Compact coded switch with HEX, Gray or BCD coding, up to 16 position, up to 3.5 Ncm switching torque and perfect for rugged environments
-
Product
High-Voltage Test Device
PGK 260 HB
-
Cable testing and diagnostics with the BAUR PGK HB. There are hardly any other longer-lasting, more robust and cost-effective testing devices than the two-piece high-voltage test devices from the PGK HB series. They generate continuous adjustable test voltages with mains frequency or optionally DC with positive or negative polarity. The display instruments for current and voltage, the safety control unit and the regulating transformer for the voltage are integrated in the operating unit. *Testing of medium- and high-voltage cables * DC voltage testing of up to 260 kV output voltage with positive or negative polarity * AC voltage testing - up to 190 kV for switchgear, busbars and insulating elements * Easy-to-maintain 2-piece design
-
Product
NI-9361, 32-Bit, 8-Channel C Series Counter Input Module
783407-02
Counter Input Module
32-Bit, 8-Channel C Series Counter Input Module - The NI‑9361 is a differential or single-ended input module. With this module, you can expand beyond the four counters in CompactDAQ to reach up to 64 counters per 8‑slot chassis. You can configure each channel to read a single pulse train or combine them to read up to four incremental encoders. You can also directly connect sensors with open-collector or push-pull outputs by using an internal switchable 1 kΩ pull‑up resistor. The NI‑9361 counters can perform encoder position and velocity measurements. You can synchronize the counters with other analog, digital, and counter measurements in your chassis.
-
Product
Positive Displacement Pumps
-
Flowserve positive displacement pumps comply either with ASME or API standards. They cover screw and reciprocating pumps in different configurations that guarantee reliable and efficient pumping processes. Numerous sizes, hydraulics and material combinations are particularly well suited for use in applications where uncompromising reliability and efficiency over a wide flow range are key.
-
Product
Enclosure, S6, 1U Height, 4 Cable Clamps, 8" Depth
410112702
Enclosure
Enclosure, S6, 1U Height, 4 Cable Clamps, 8" DepthIncludes hinged cover and 4 cable clamps for discrete wiring that provide secure strain relief. With cable clamps in open position- stiffener bar may be removed to allow installation or removal of cables without requiring wiring to be disconnected from the assembly.Housing: Material = .06" Aluminum, Finish = Powder Coat BlackCover(s)/Access Panel(s): Material = .12" Aluminum, Finish = Black Anodize
-
Product
Wind Turbine Lidar
ZephIR 300
-
ZephIR 300 measures wind characteristics onshore and on fixed or floating platforms offshore from just 10 metres (33 feet) up to 200 metres (656 feet) from installed position to inform wind regime and quality studies during the development and operation of wind farms onshore and offshore.
-
Product
Centralized Motion Controllers
Motion Controller
Pulse train motion controllers generate high-frequency digital signals to control servo motors and steppers, matching performance and precision positioning of high-performance servo amplifiers.
-
Product
4-Channel High Speed Position Comparison and Trigger Module
ECAT-TRG4
Trigger Module
The ECAT-TRG4 is EtherCAT slave module with high-speed position comparison trigger and encoder single redriver function, helping machine and equipment builders to use multiple triggers simultaneously for AOI, glue dispensing, display tests, and storage assembly applications.
-
Product
photonSPECTRAL
-
Photonfocus has developed outstanding solutions for numerous fields of application in order to meet the growing demand for imaging applications in invisible light spectra. The photonSPECTRAL platform offers highly sensitive cameras with wavelengths ranging from deep UV to short-wavelength infrared light (SWIR), as well as innovative systems for the hyperspectral range. Our vast expertise in this area is also reflected in our leading market position: Photonfocus launched a UV-suitable CMOS camera with global shutter for machine vision applications.
-
Product
On / Off Tilt Sensor
SQ-SEN-390
-
The SQ-SEN-390 series sensor acts like a position sensitive switch which is normally closed when below horizontal and normally open when above horizontal.
-
Product
Shock Test Apparatus
-
SCR Elektroniks make Shock test Apparatus is used to test the Electrical accessories / appliances for their mechanical strength. A wooden base fixed to a concrete block and a wooden platform is hinged base. This platform carries a wooden board, which can be fixed at various distance from the hinge and two vertical positions. The end of board bears a metal stop plate, which rests on coiled spring having constant 25N/mm.
-
Product
Position Sensors
-
Panasonic Industrial Devices Sales Company of America
Analog input devices are designed for highest requirements like within the automotive market. In SMD or THT technology, with detents or without detents, the electrical as well as the mechanical performance is impressive. Key features like “long-life endurance” or “accuracy in output-signal” give customer applications highest performance. Possibilities of Haptic-alignment make these components perfect.
-
Product
E37 THT | Threaded Or Non-Threaded
E37-Overview
-
Incremental encoder with dual function, switching torque up to 4.5 Ncm, 16 or 32 detent positions and a rotational life up to 1 Mio revolutions
-
Product
PMC Carrier with 2 Positions
PMC-MC-X2-28
-
PMC-MC-X2 adapter/carrier/motherboard provides the ability to install up to 2 (two) PMC cards into a small enclosure. PMC-MC-X2 has one PMC card mounted front and one rear to create a compact arrangement with 2 PMC positions. The carrier provides power supplies for the +5, +3.3, +12, and minus 12 from a reference supply.
-
Product
Wet/Wet Differential Pressure Transmitter
655
-
The Series 655 Wet/Wet Differential Pressure Transmitter converts a positive or a positive differential pressure measurement into a standard 4-20 mA output signal. Designed for use as a wet/wet differential pressure transmitter, units can be used to measure gas or liquid pressures compatible with 316/316L stainless steel wetted parts
-
Product
LED View Angle Tester
-
360°rotate perspective die scanning.0.36° as the smallest test step unit.Conjunction with LED tester for electrical and optical parts test.Test data collection and perspective diagram drawing.Support 4 sets of probe socket (standard equipment with 2 sets of probe sockets)Clip structure. Easy for die positioning.
-
Product
Slide Screw Tuners
-
Slide screw tuners are particularly suited to establishing impedances for device characterization, or for any other application requiring a precisely repeatable mismatch condition. This is due to the precision with which a specific matching condition can be repeated if the tuner has calibrated position indicators.
