Lighting
is used to illuminate.
See Also: Light, Illumination, Lightning, Lightwave, Daylight, Streetlight, Light Sources, DMX
-
Product
Cockpit Lighting
-
Astronics works side by side with you to deliver customized lighted cockpit control panel assemblies and illuminated panels for your commercial, military, and business aviation programs.
-
Product
Exterior Aircraft Lighting
-
When you see an airplane overhead, there's a good chance you see Astronics' aircraft exterior lights. For decades, Astronics has delivered linefit and retrofit lighting solutions for commercial transport, business aviation, military, unmanned, and other aircraft programs.
-
Product
High speed capture lighting
-
EYE / Iwasaki has developed a family of products to address the most demanding test requirements. This includes Overhead Fixtures, Portable Floor and Pit Fixtures, and On-Board Lighting Fixtures.
-
Product
4-CH Lighting Control Module
AX92353
-
*4-CH independent constant current LED drivers (up to 1 A)*Supports strobe and trigger mode*Intensity control by software*Supports duration and delay time for LED output
-
Product
LED Lighting Test Instrument Integrating Sphere
CX-I.5S
-
Shenzhen Chuangxin Instruments Co., Ltd.
Measure Luminous Flux, Luminous efficacy, radiant power, Spectral Power Distribution, Chromaticity Coordinate, Correlated Color Temperature, Peak Wavelength, Dominant Wavelength, Spectral Half Width, Color Rendering Index, Colorimetric Purity, red ratio, Standard deviation of color matching(SDCM), voltage, current, power, power factor, harmonics, and etc. It meets the requirements of CIE standards.
-
Product
LGM-300 Lighting Glare Measurement System
-
Hangzhou Everfine Photo-E-Info Co., LTD
LGM-300 is for glare measurement and analysis of indoor and outdoor lighting scenes meets the measurement requirements of CIE, EN, GB standards with good measurement stability. The system is portable and can be widely used for on-site-glare measurement and analysis such as indoor lighting, road lighting, sports venues and regional lighting.
-
Product
Helicopter Emergency Egress Lighting
HEEL
-
Helicopter Emergency Egress Lighting (HEEL) system provides an independent battery operated lighting system that marks crew and passenger emergency exits onboard a helicopter. In addition, it visually identifies exits under all cabin conditions including smoke or water filled, capsized and completely submerged thus providing the passenger with an unambiguous definition of the location of the nearest emergency exit.
-
Product
Three-Pole Lighting And Surge Arrestor
PIVM12,5-275/3+0 Vseries
-
PIVM12,5-275/3+0 Vseries is a three-pole lightning and surge arrester Type 1+2 according to EN 61643-11 and IEC 61643-11. These arresters are recommended for use in the Lightning Protection Zones Concept at the boundaries of LPZ 0 – 1 (according to IEC 1312-1 and EN 62305), where they provide the equipotential bonding and discharge of both, the lightning current and the switching surge, which are generated in power supply systems entering the building. The use of the lightning current arresters PIVM12,5-275/3+0 Vseries is mainly in the power supply lines, which are operated as TN-C system. The main use of PIVM12,5-275/3+0 Vseries arrester is in structures of LPL III – IV according to EN 62305 ed.2. The marking M specifies a type of construction with removable module.
-
Product
Real Scene Lighting
LightSTUDIO
-
Image Engineering GmbH & Co. KG
Test charts are used to test digital cameras and to perform objective measurements. But there are certain aspects in testing a camera that require a real scene. One of these aspects is the correct white balancing for different types of illuminants. Another aspect might be the determination of the visual loss of detail due to noise reduction or the amount of noise in an image.
-
Product
PLA-30 Plant Lighting Analyzer
-
Hangzhou Everfine Photo-E-Info Co., LTD
The PLA-30 is a professional measuring instrument designed for accurate measurement and analysis of plant lighting. The mobile spectrum measurement technology achieves millisecond measurement speed with high precision, and is widely used in lighting analysis, monitoring, research and communication in plant growth.
-
Product
Static & Lighting Chokes
-
Lighting chokes are used to pass tower lighting voltages across the base insulator of a series-fed tower without appreciably altering the tower impedance. LBA TC-300 general purpose tower lighting chokes are provided for three wire 110/220 VAC circuits. Maximum current is 25 amps. These chokes are rated for peak base voltages to 10,000 volts, and present a typical reactance of +j5000 ohms at 530 kHz. Bypass capacitors are provided on each winding.
-
Product
Lighting ICs
-
Based on its 30-year experience in power conversion and high-voltage technology, ST offers a wide portfolio of solutions for electronic ballasts, ranging from high-voltage ballast controllers for analog solutions (with or without embedded PFC), to complete power management units with integrated drivers and voltage regulator for digital platforms.
-
Product
General Lighting & Luminaire Goniophotometers
-
Photometric Solutions International Pty Ltd
These are Type C/gamma goniophotometers with wide-ranging applications including luminaires, floodlights, streetlights, LED clusters, emergency lighting, flat panel displays and others. These goniophotometers typically have an angular accuracy of better than 0.1°, which is perfect for LED and luminaire goniophotometry. The control software that comes with each system has advanced functions that make testing easy – even for inexperienced users. Additionally, the report generator and other software utilities that are also supplied make these systems powerful and advanced research and development tools.
-
Product
Lighting Reliability
-
LED/OLED package lifetime is highly dependent on thermal management, and LED lamp performance can be dependent on the luminaire in which it is installed. Lighting reliability test system for LED/OLED Products are widely used for normal /accelerated aging, lumen maintenance measuring, lifetime evaluation and temperature characteristic testing for LED/OLED products including LED package, array, module, OLED module and luminaires.
-
Product
Vehicle Lighting
-
The lights are designed for both the retrofit and new build market and include normal visible, NVG Compatible, NVG Friendly and Covert technology. Solutions include infra-red (IR) external lights and low profile interior cabin lighting and task lighting.
-
Product
*Divergent Light Measurement
-
The IS1.5-VIS-FPD-800 & IS1.5-IRG-FPD-800 contain 2 photodiodes: a calibrated photodiode for precise power measurement using Ophir meters and a fast photodiode with integral reverse bias circuit for temporal characterization using third-party instrumentation such as oscilloscopes and spectrum analyzers. Their small, 1.5" internal diameter preserves the temporal shape of pulses down to 3.5 nsec for VIS and 6 nsec for IRG. An SMA fiber optic connector is provided for connection to a spectrometer. The large, 20 mm input aperture allows for wide acceptance angles and long working distances, making these spheres well suited for testing VCSELs and other types of laser.
-
Product
Light Source
FiberPal OT-3000
-
The OT-3220/3221 is designed for a high performance stabilized laser source, especially in practice for FTTX networking installation and maintenance fieldworks environment requirements. It is usually applied as stable laser sources for wide range of optical testers and tools in optical fiber cabling and transmission systems.
-
Product
Halogen & Deuterium Halogen Light Sources
-
Avantes Deuterium light sources are known for their stable output ad are used for UV absorption or reflection measurements. These can also be used as irradiance calibration sources due to their high stability. The standard AvaLight-DH-S mixes the halogen light with the Deuterium light, thus producing a wide spectral range light source. The output spectrum of Deuterium light sources exhibits several peaks, with a prominent peak at 656 nm. The AvaLight-DH-S-BAL incorporates a dichroic beam splitter installed to minimize these peaks, providing a smooth spectrum from 200-2500 nm.
-
Product
Transformer Ratio Meter
TRM 1000
-
AJIT Transformer Ratio Meters are the most modern turn's radio meters widely used to test the turn's ratio of high voltage windings, to low voltage windings, of Transformer. These meters are accurate, compact & light in weight.
-
Product
Relay Buddy
190
-
Relay Buddy is a quick go / no-go tester for the most common automotive relays. It provides you with an indication of the general health and functioning of the relay switch contacts and coil. Relay Buddy will check the control side of the relay by applying a signal to the relay coil while it checks for proper functioning of the relay contacts. Relay Buddy operates the relay several times during each test session as it watches for consistency in every cycle. Relay Buddy will fail the relay and light the RED LED if any one of the cycles proves unsuccessful during the test session.
-
Product
Fuel Injector Tester GM Multiport
FIT457
-
For GM domestic cars with large schrader adapters; light trucks, vans and sport utility vehicles with multi-port. The 2-1/2" gauge has a dual scale dial with ranges from 0-100psi and 0-7 bar.
-
Product
LED
-
light-emitting diode (LED) is a two-lead semiconductor light source. It is a pn junction diode, which emits light when activated. When a suitable voltage is applied to the leads, electrons are able to recombine with electron holes within the device, releasing energy in the form of photons.
-
Product
2MP Sony STARVIS® IMX290 ultra-lowlight Camera Module
e-CAM21_CUMI290_MOD
-
The e-CAM21_CUMI290_MOD is a 2 MP ultra-lowlight RAW MIPI camera module with the S-mount (M12) lens holder. This FHD camera module is based on SONY IMX290, one of the most popular Sony's STARVIS® CMOS sensor. SONY IMX290 is a 1/2.8" rolling shutter CMOS sensor with 2.9µm pixel size. Its effective pixel back-illuminated technology with improved sensitivity in the visible-light and near infrared light enables customers to capture images even in absolute darkness. The e-CAM21_CUMI290_MOD can stream uncompressed FHD @120 fps in 10-bit mode and 60fps in 12-bit mode.
-
Product
Metal Detector
-
Dor Yang precision instrument (Shanghai) Co.,Ltd
1.Fully Automatic and All Metal Detectors - Your detector detects all kinds of metal objects. Unless you have set for some objects that you don’t want to detect.2.LCD – The LCD with light, it improve to identify the metal in night or caliginous outside. 3.Target Identity - The detected objects are shown on the LCD display. You can decide immediately if the objects worth to be recovered.4.Unwanted Target Elimination - You can set the detector not to respond to some objects.5.Unique Tone for Target - You don’t have to keep watching the LCD display, when an object is being detected, an unique tone corresponding to a target will generate. You may even searching when there is little or no light.6.No Clumsy Slack Cable - hidden search coil cable (connecting between control unit and search coil) avoid entangling and for ease of stem length adjustment.7.Headphone Jack - provided for headphone connection. Both stereo or mono headphone can be used.8.Volume Control - for adjusting the output volume to the loud speaker or headphone.9.Batteries Condition Indicator - shows the conditions of the batteries in the battery compartment.10.Waterproof Search Coil - lets you use the detector in the shallow water.11.Adjustable Stem - lets you adjust the detector’s length for comfortable use. The micro-plug that connects the search coil and the controller unit is made of metal which makes the plug more reliable.
-
Product
Transit Resistors
-
Post Glover is North America’s foremost resource for traction and light rail resistors, used daily on high speed trains, locomotives, commuter rail and subway systems. Propulsion system manufacturers recognize our company as a reliable partner for the design and the production of resistors that meet their specific needs and technical requirements.
-
Product
Themal Imagers
-
Shenzhen Noyafa Electronic CO.,LTD
Noyafa Themal Imager pursues the ultimate thermal imaging technology with continuous innovation, 2 million visible light pixels, 1024 thermal imaging pixels are clearly visible, providing high-resolution thermal information, and can operate safely and efficiently.Built for daily use, it is widely used in schools, factories, office buildings, etc.
-
Product
EMF / RF / Radiation Meters
-
Sper Scientific EMF meters measure Electro Magnetic Frequency radiation levels. Whether you're measuring EMF emissions from electrical power lines and transmission equipment, computers, HVAC, audio/video or other electrical appliances, our meters are small and light enough to go anywhere, yet sensitive enough to detect minuscule amounts of EMF radiation.
-
Product
Infrared Moisture Analyzer
LD-LIMA-A10
-
Infrared Moisture AnalyzerLD-LIMA-A10is an online, fast, continuous measurement and non-contact measurement device with measurement distance range of 20 to 40 cm. It provides automated control and 4 to 20 mA current signal. This IR Moisture Analyzer emits different wavelengths of infrared light (4, 6, 8, 10 beam) to calculate the moisture content of the measured object. Designed with long-life high-speed brushless motor, imported high response infrared sensors, information processing chip FPGA + DSP + ARM9 combination, to attain real time data, improved stability and precision.
-
Product
Sapphire Defect Laser Probe and Glasses
LP-100
-
Easy to use and portable■ low price with long lifetime■ can be used to detect many defects, like micro crack, bubbles, impurity, crystal subgrain■ When the laser go though the crystal, if it is monocrystal the light should be scattering, in macro it should be white.
-
Product
Corona Effect Camera
CoroCAM 8 UAV
-
*High-sensitivity UV detector, which can detect UVc light at 2.05×10-18 Watt/cm2, this allows detection of the smallest corona discharges.*9Hz (or 25Hz optional) IR radiometric camera module*Control of a limited number of camera functions from a standard RC controller using PWM or SBUS.*Remote control of all camera functions from the laptop via an Ethernet link.*Soft sync or staggered zoom of the 3 channel cameras. The IR and UV channels are digitally zoomed in, which is visible...optically zoomed in to the minimum FOV, and then digitally zoomed out.
