-
Product
Portable Flowmeter for Non-contact Measurement
P118i
-
Gentos Measurement & Control Co.
P118i Portable Ultrasonic Flow meter enables the user to do flow measurement checks at many points in a flow process without the need for a permanent installation.
-
Product
Partial Discharge Detecting Detectors
-
Hangzhou Xihu Electronic Institute
Including pulse current PD detecto, high frequency PD detector, transient earth PD detector, ultra high frequency PD detector, and ultrasonic PD detector.
-
Product
Diving Technology Test Systems
-
Ingenieurbüro Dr. Hillger Ultrasonic-Techniques
The imaging ultrasonic testing systems of the USPC 30XX series are optimized for testing a wide variety of materials and provide high-resolution findings in the form of A, B, C, D and F images. The hardware consists of an industrial PC, in which a motor controller and an ADC card are installed, as well as a HILL-SCAN pulser/receiver unit. An overview of the available systems is given in Table 1.
-
Product
Ultrasonic Thickness Gauge
TI-45 Series
-
You can instantly measure the thickness of a material simply by positioning a probe. This innovative gauge is widely used and is capable of measuring a variety of materials including iron, stainless steel, glass and ceramics.
-
Product
Bit Waveform Digitizer
ATS9360
-
ATS9360 is a fast,12 bit waveform digitizer based on the 8-lane PCI Express Gen2 interface. With on-FPGA FFT and boasting data throughput as fast as 3.5 GB/s (3500 MB/s) and sample rate of 1.8 GS/s across 2 simultaneous inputs, ATS9360 is an ideal solution for many applications, including next generation OCT, radar, ultrasonics, spectrometry and RF signal recording.
-
Product
Levitator
-
The ultrasonic levitator is ideally suited for a large number of material science experiments in which small samples or sample quantities have to be positioned precisely. Measurements can be conducted – as they are performed in a touchless manner – without interference from a contact surface.
-
Product
Fixed Clamp-on Flowmeter
D116
-
Gentos Measurement & Control Co.
D116 Series Ultrasonic Flowmeter is a state-of-the-art universal transit-time flowmeter designed using FPGA chip and low-voltage broadband pulse transmission.
-
Product
Digital Ultrasonic Maintenance System
VPE-2000
-
The Superior AccuTrak VPE-2000 is the first digitally controlled ultrasonic detector. Like two instruments in one it uses two independent sensors supported by separate electronic circuits configured specifically to their own sensor. This assures optimum sound clarity and frequency response. When switching between the airborne and contact sensors all settings are retained in memory! Digital LED meters let you establish baselines, perform trending, and accurately repeat these tests better than older more expensive analog instruments.
-
Product
Bit Waveform Digitizer
ATS9350
-
ATS9350 is the fastest 12 bit waveform digitizer based on the 8-lane PCI Express interface. Boasting data throughput as fast as 1.6 GB/s (1600 MB/s) and sample rate of 500 MS/s across 2 simultaneous inputs, ATS9350 is an ideal solution for many applications, including OCT, radar, ultrasonics, spectrometry and RF signal recording.
-
Product
Ultrasonic Distance Sensors
-
Distance sensors for precise measurement on any material and surface, whether colored or transparent.
-
Product
High Speed High Voltage Amplifier
WMA-320
-
The WMA-320 is a high voltage, wide bandwidth laboratory amplifier. Its high output voltage, current and wide bandwidth have been designed to serve the needs of a wide variety of high-tech experiments. The WMA-320 can be used for MEMS actuation, EO-modulators, PZT (piezo) positioners, ultrasonics, and many other applications.
-
Product
Ultrasonic Wind System
UWS
-
Aeronautical & General Instruments Ltd.
Data from the mast-mounted (and virtually maintenance-free) anemometers is processed and used to drive full colour displays. The system calculates cross winds, head winds and tail winds, gusts and lulls and directional variation, as well as allowing for marked discontinuities. Instantaneous data may be displayed, as well as 2 minute and 10 minute averages. Systems can be supplied fully installed with comprehensive engineering and operator training, and post-installation support is available worldwide.
-
Product
Ultrasonic Corona & Arcing Detector
ULD-40™
-
The ULD-40™ is an ultrasonic detector designed for corona effect and arcing detection for predictive maintenance in electric utilities. Available with a variety of accessories, this instrument is a cost-effective must for any prevention plan.
-
Product
Non-contact Ultrasonic Testing System
-
Yamaha Fine Technologies Co., Ltd.
Contact-free inspection through ultrasonic transmission detecting air bubbles, separation, and foreign materials inside workpieces. With a Yamaha ultrasonic amplifier installed, contact-less inspection in the air is realized. Without damaging or wetting the workpiece, it is possible to inspect the workpiece for packing defects, air bubbles, and even flaw depth.
-
Product
Ultrasonic Testing
Pundit 250 Array
-
The Pundit 250 Array brings a quantum leap in the ultrasonic pulse echo testing. A number of unique innovations make the Ultrasonic multi-channel instrument the best and fastest solution for thickness measurements, detecting defects and localizing objects which cannot be easily detected by any other technology. This includes the assessment of thick concrete elements such as tunnel linings as well as pipes and tendon ducts beyond the rebar layer.
-
Product
Ultrasonic Inspection System
PULD 40
-
The PULD-40 is a versatile and highly accurate ultrasonic inspection system designed to meet the needs of our customers.
-
Product
Tide Gauge
TideMaster
-
The Tidemaster is the cost-effective way to accurately record water height, with the added option of gathering meteorological data using its ultrasonic wind speed and direction sensor.
-
Product
Waveform Digitizer
ATS9462
-
ATS9462 was the world''s first waveform digitizer with a 4-lane PCI Express interface. Boasting data throughput as fast as 720 MB/s and sample rate of 180 MS/s across 2 simultaneous inputs, ATS9462 is an ideal solution for many applications, including OCT, RF signal capture, ultrasonic inspection and radar.
-
Product
Giga-Sample Waveform Digitizer
ATS9870
-
ATS9870 is the world''s first Giga-sample waveform digitizer based on the 8-lane PCI Express interface. Boasting data throughput as fast as 1.6GB/s (1600 MB/s) and sample rate of 1 GS/s across 2 simultaneous inputs, ATS9870 is an ideal solution for many applications, including radar, ultrasonics, spectrometry and RF signal recording.
-
Product
Ultra Sonic Flow Meters
-
RB Flow meter manufactures and Supplies Ultrasonic flow meter, non-intrusive, Clamp-on Ultrasonic flowmeters, insertion ultrasonic flowmeters, handheld flowmeter, heat meter, BTU meter, water meter, portable flowmeters, ultrasonic flowmeter, ultrasonic flow meters, portable flow meter, handheld flow meter, and more.
-
Product
Partial Discharge Detection Calibration Device
-
Hangzhou Xihu Electronic Institute
Calibration Device of Transient Earth Voltage PD detector, calibration device of ultrasonic PD detector, calibration device of high frequency PD detector, calibration device of ultra high frequency PD detector.
-
Product
Male/Female DIP Jumpers
Series 200 thru 216
-
Male/Femaie DIP Jumpers. Reliable, electronically tested solder connections. Protective covers are ultrasonically welded on and provide strain relief for cables. 10-color cable allows for easy identification and tracing.
-
Product
Quick Change Probes For Weld Seam Testing (ASTM)
SONOSCAN Q
-
In addition to angle beam probes according to european standards (EN), we offer probes with quick-change wedges for ultrasonic weld seam inspection as well as various wedges for the american market. Quick-change probes are used wherever access to the inspection object is difficult to reach with the larger AWS transducers. The relatively small, round elements also offer better defect resolution.
-
Product
Ultra-sonic Test System
V-Meter
-
The V-Meter is an advanced ultrasonic, pulse-velocity test system widely used for quality control and evaluation of concrete structures. It can identify non-homogeneous conditions such as voids, cracks, honeycombs and frozen concrete.
-
Product
Ultrasonic Flaw Detector
MFD660C
-
MFD660C intelligent digital ultrasonic flaw detector, Mitech concentrated years meticulously developed premium product, has a lot of advantages like unique design, sophisticated manufacturing, convenient operation, powerful function. It had received customers' favored since its inception. It can test, orient, evaluate and diagnose various flaws such as crack, lard, air hole in workpiece’s interior swiftly and accurately without any destruction. With full digital 640X480 TFT LCD display, it can select the operating interface style and the LCD brightness according to environment. With humanizing interface design, the waveform show delicately. It can find the defects clearly in full screen. Single hand capable for holding operation, the curve making, probe calibration and other conventional operation can be completed automatically. Core processor CPU with 400M main frequency, it can complete the complex run quickly and realize intelligent defect analysis. Low power design with large capacity and high performance lithium ion battery module， it can work more than 10 hours continuously. Full English master-slave menu, emphasizing on user experience, collecting shortcut keys, digital shuttle rotary wheel, cross menu three operating ways in one body, customers with different habits can operate it freely. It supports many languages. Its waterproof, oil proof, dustproof function can achieve IP65 protection level. It is the necessary professional precision instrument for defect detection, quality control, on-line safety monitoring and life evaluation in fields of oil, chemical, metallurgy, shipbuilding, aviation, railways and so on.
-
Product
Ultrasonic Wall Thickness
UTG
-
The PosiTector UTG measures the wall thickness of materials such as steel, plastic and more using ultrasonic technology. Ideal for measuring the effects of corrosion or erosion on tanks, pipes or any structure where access is limited to one side. Multiple echo (UTG M) Thru-Paint models measure the metal thickness of a painted structure without having to remove the coating.
-
Product
AWS Probes For Ultrasonic Weld Seam Testing (ASTM)
SONOSCAN R
-
The robust ultrasonic probes with BNC connector allow a fast scanning over comparatively large areas with high precision and repeatability. Both our own and third-party wedges can be attached to our probes. . Thanks to the different types of wedges various material tests can be performed.
-
Product
Thickness Gauges
-
Our digital thickness gauges offer a range of features for advanced performance. Explore different options to suit your application needs, from simple handheld gauges to advanced models. All Olympus ultrasonic thickness gauges can measure thickness from one side of a part.
-
Product
A-/B-Scan Thickness Gauge For NDT
SONOWALL® 70
-
SONOWALL 70 is the first thickness gauge in the market with intelligent probe identification. The extended probe management allows probe-specific information such as DAC-curves, delay lines, and serial numbers to be saved directly in the ultrasonic probe. In addition to various thickness applications, the device can be upgraded to a full-function flaw detector.
-
Product
Multi-mode Ultrasonic Thickness Gauge
MMX-6DL
-
The MMX-6DL has all the features of the MMX-6 plus: An Internal data logger that stores a total of 1000 readings in 10 files of 100 readings each file. This gives the user the ability to store, and download the stored measurements directly to a PC using our DakView software program. The software and transfer cable are included in the MMX-6DL kit.
