Sound Pressure Level
measurement of a sound wave's pressure relative to a reference value. Also known as: SPL
See Also: SPL
-
Product
Level Detectors
-
Becker Nachrichtentechnik GmbH
Becker Nachrichtentechnik offers selective RF level detectors for air interface monitoring. The detectors are especially designed for frequencies used in e.g. electron accelerators. Due its mechanical design, the modules are compatible to cable route mounting systems. The detection of unintentional RF radiation is a main application field.
-
Product
Bi-Directional Level Translator
IFB-10001
-
Easily connect Arduino or other 5V microcontrollers to ~3.3V sensors. Based on the TI TXB0108 auto-sensing, bi-directional level translator, this module provides access to all 8 channels of the TXB0108 and has a built-in 300mA LDO with 200mV max dropout voltage at full load. Regulated 3.3V output allows this single board to both interface withandpower 3.3V sensors. An important feature of this module is the ability to operate SPI and other digital lines (not including I2C) at high-speed, whereas the 'NXP level shifter' maxes out at 400kHz and resistor dividers fail much earlier. The TXB0108, integrated with the LP3981 LDO, provide a fast, reliable solution to mismatched interface voltages that exceeds the performance of other solutions.
-
Product
Selective Level Generator
Model SLG620
-
- Digital Synthesized Oscillator- High Frequency and Level Stability- Frequency Tracking Facility with Level Meter SLM620- Operated from AC Mains or Internal Rechargeable Battery- Built in charger- Alphanumeric LCD Display with Backlight
-
Product
Barometric Pressure Transmitter
-
Comptus Barometric pressure sensors utilize an integrated silicon, absolute pressure sensor with internal temperature compensation. The sensor is mounted to the signal conditioner board. A 3/16 inch diameter tube may be attached to the sensor to provide remote pressure sensing. The output of the sensor is scaled to provide the desired output signal.
-
Product
System to Handle Wafer Levels
AMI AW Series
-
Operator-Free Wafer Inspection, Analysis and Sorting The AW Series are advanced high-capacity, high throughput automated wafer C-SAM® instruments specialized to deliver maximum sensitivity for the evaluation of wafer and device level applications.
-
Product
Pressure / Manometers
-
Sper Scientific handheld manometers, vacuum, and pressure meters are ideal for measuring low differential pressure in clean rooms, test and balance, medical equipment, HVAC, pneumatic systems and computer peripherals.
-
Product
Subminiature Pressure Switch
A2
-
Designed for OEM applications, the Series A2 is economical and is equipped with high proof pressure capabilities for demanding applications. The A2 is available with either spade terminals or flying leads (submersible). Switches with spade terminals can be easily adjusted in the field.
-
Product
RF Admittance Level Measurement
-
RF Admittance is one of the most versatile technologies being used today in a wide range of continuous level applications. It has a long standing reputation as a proven technology in the most demanding level process environments.
-
Product
Sound Level Meters
-
TES Electrical Electronic Corp.
Super high contrast backlight TFT. Compliant with 1 class 2 standard. Real-time 1/1- Octave and 1/3 Octave analysis. Measurement can be started by internal or external
-
Product
Differential Pressure Probes
PP473-S…
-
Differential pressure probes complete with SICRAM module to measure pressure in the range 10, …, 2000 mbar.
-
Product
Production Wafer Level Burn-in
-
TV19 VersaTile™ probe cards are designed with Celadon’s patented ceramic technology for superior electrical performance, yet is highly modular due to it’s 28mm x 28mm chassis. Micro-adjustments can be made in seconds with an allen wrench and a microscope. Easily align VersaTile cards for different wafer layouts using a 4.5” compatible 1×3 , 200mm, or 300mm VersAdjust plate.
-
Product
Signal Level Meters
-
Wuhan Sunma Technology Co., Ltd.
Signal Level Meter is specially designed and manufactured for CATV system installation and testing. It‘s a portable instrument, easy to carry with many functions.It can test CATV signal level both at channel and frequency mode. Also it can measure CATV TILT,C/N, trunk cable Voltage, ect. The big character TN LCD clear1y displays all testing results. It especia1ly fit for CATV station as a professional measurement instrument. it can display 2 channels at the same time.
-
Product
Shield Level / Pathloss Equipment
PAMS & PAMS-C
-
PAMS is a user-friendly, transmitter and receiver system that measures shielding effectiveness in RF shielded enclosures. Lightweight and compact, each PAMS unit measures approximately 12” x 5” x 5” and weighs 5.5 lbs., making PAMS ideally suited to field measurement tasks. Rugged construction insures instrument survivability in a field test environment. PAMS-C is a simple and efficient solution for quickly identifying shielding faults in an RF shielded enclosure. Cousin to the original PAMS used extensively by customers operating RF Shielded Enclosures, PAMS-C gives commercial end-users everything needed to measure shielding effectiveness levels of critical infrastructure - all with minimal or no interruption to normal operations.
-
Product
Level Measurement
Level Measurement
-
AMETEK Sensors, Test & Calibration
B/W Controls uses the same advanced magnetostrictive technology as in Gemco products providing high accuracy and reliability for continuous liquid level measurement.
-
Product
3D Sound Intensity Analysis Software
DS-0225A
-
Finding out the position where the noise is occurring, and grasping the state of acoustic propagation are important ways to find effective noise countermeasure or improvement of acoustic environment.
-
Product
Digital Pressure Meter
ZET 7012-A-VER.1
-
Digital pressure meter ZET 7012-A in BP4-1 casing is used for fast and simple absolute pressure measurements and measured values data transfer in digital format via RS-485 or 4-20 mA interface.
-
Product
Pressure Sensors
-
Kistler offers both piezoelectric and piezoresistive sensors to measure pressure – so we have the right solution for many applications. Piezoelectric pressure sensors are suitable for measuring highly dynamic, dynamic and quasi-static pressure curves or pulsations. Piezoresistive pressure sensors are suitable for measuring static and quasi-static pressure curves.
-
Product
Digital Gauge Pressure
ZET 7012-I VER.3
-
Digital gauge pressure ZET 7012-I VER.3 (open membrane) is used for fast and simple overpressure measurements and measured values data transfer in digital format via RS-485 or 4-20 mA interface. ZET 7012-I VER3 digital gauge pressure meter is intended for integration into various technological processes automated control systems. Open membrane type enables sensors operation in viscous, pasty and rapidly polymerizing environments.
-
Product
Atmospheric Pressure Sensors
-
Equipped with LCD displaySuitable for space measurementsOutput signal RS232Advantech ADAM and Modbus compatible
-
Product
Sound Level Meter, 94 dB, 114 dB, 0 °C, 50 °C
72-2680
-
The 72-2680 from Tenma is a sound level calibrator. It is a useful tool to calibrate the sound level meter. It has two heavy duty or alkaline type, DC 9V batteries 006P, MN1604 (PP3).
-
Product
Sound Level Meters
-
Is used for acoustic measurements. It is commonly a hand-held instrument with a microphone.
-
Product
DBAir Safety & Environment Sound Level Meter
01GA141SE
-
For professionals looking for sound measurement technology capable of a wide variety of applications, look no further than the dBAir Safety & Environment model.
-
Product
Pressure Gauges
-
Digital and Analog pressure gauges covering a broad range of pressures for a variety of applications.
-
Product
Pressure Measurement
-
A wide variety of pressure sensors with an option for nearly every pressure measurement application. Pressure transducers, pressure gauges, pressure switches manometers, calibrators, and regulators.
-
Product
Pressure Calibrators
-
We offer pressure calibrators as portable and as workshop models. Pressure measurement is performed with internal and/or external pressure modules for better flexibility. Pressure measurement ranges go from vacuum up to 1000 bar (14,500 Psi). Both gauge (vacuum and positive) and absolute pressure can be measured with same modules meaning you don’t need to buy so many module for greater flexibility. Also, intrinsically safe pressure calibrators are available for use in hazardous areas.
-
Product
Pressure Sensor
MLV Series
-
The MLV Series Compensated Sensor is based on All Sensors’ CoBeam2 TM Technology. The device provides a high output signal at a low operating voltage while maintaining comparable output levels to traditional equivalent compensated millivolt sensors operating at higher voltages. 1 inH2O to 150 PSI Pressure Ranges.
-
Product
Water Levels Tools
-
Zircon’s line of indoor and outdoor electronic leveling tools are ideal for everyone whether they are professionals or hobbyists. Learn more about our WL25 Water Level and WL25 Pro Water Level here.
-
Product
Pressure / Force Sensors
-
Panasonic Industrial Devices Sales Company of America
Panasonic offers high precision Pressure Sensors for industrial, medical, clean room and other gauge equipment uses. Some include a built-in amplifier and compensating circuit in a compact, low and high pressure Sensor with high accuracy and reliability.
-
Product
Sound Power Reference Source
Qref
-
Precision omni-directionallity in all directions, horizontal and verticalplane. This source has a frequency range of application between 100 and8000 Hz (third octave bands) Despite only weighing 1.4 kg and having a diameter of 105 mm, it produces a maximum sound power level of Lw 104 dB.
-
Product
Analog Pressure Gauges
-
Analog pressure gages use a needle to indicate the pressure sensed on a dial scale. Analog pressure gauges are inexpensive, easy to use, and don’t require a power source.
