Visual Basic
A programming language and environment that allows rapid creation of user interfaces by dragging and dropping elements such as buttons and controls.
-
Product
Self Testing Clamps with Visual Indication
Bond-Rite REMOTE
-
As an alternative to the standard Bond-Rite, a ?remote? version is also available. In this configuration, the Intrinsically Safe monitoring electronics, flashing green LED and battery power supply are housed inside a tough, corrosion resistant stainless steel enclosure, designed for wall mounting. An insulated stowage point, for the safe return of the clamp when not in use, is included.
-
Product
Visual Counting & Inspection Systems
-
Sciotex has created a comprehensive line of visual counting and inspection systems. These systems can be custom configured for a wide range of applications and are often delivered, ready-for-installation in your environment.Our Products:PerfectCount, Ball Coleman SeedView, ConveyorView Inspection Systems, Sciotex ImageView, MultiView Inspection Systems
-
Product
Handheld Digital Multimeter, 3 ½ Digit, Basic
U1231A
Digital Multimeter
Ergonomic shaped 6K counts DMM with flashlight, low input Z mode and continuity visual/audio alerts. Keysight Remote Link Solution enabled.
-
Product
Visual Fault Locator VFL X5007
-
Metal case, Rugged and durableLow battery indication, to avoid leakage and wrong judgmentESD protection design, Protect the LD effectivelyIntegrated case, to avoid the case intermediate brokenRe-changeable ceramic tube, to avoid returning to manufacturer for this small faultLong battery life, up to 60 hours＠1mW
-
Product
Basic Quad J-Type Analog Thermocouple Amplifier
SEN-30103-J1
-
Analog thermocouple amplifier board based on the AD849x from Analog Devices (successor of the AD597). This quad-channel thermocouple board converts the very low voltage signal from a thermocouple to a highly-linear, 0.005V/C output with either 0V or 1.245V offset (both configurations stocked) while removing unwanted noise from the signal. Many supply and output configurations are available with this board, though the PCB was designed with Arduino in mind. Specifically, the output header will plug directly into a standard Arduino Uno or Mega, with a pin-for-pin match for power supply, ground and analog outputs. With a 5V Arduino, temperatures from 0C to 1,000C are possible with the 0V offset board and -249C to 750C with the 1.245V offset board. If using a 3.3V microcontroller (Due, etc), the board must be supplied with no more than 3.3V to avoid damaging the microcontroller. Temperature measurement range is dependent on the supply voltage. It is possible to supply the board with higher voltages to allow temperature measurement over the entire operating range of the K-Type and J-Type thermocouples, allowing use with more capable data acquisition equipment.
-
Product
Basic RF Spectrum Analyzers
RF Spectrum Analyzer
Our low-cost RF spectrum analyzers deliver general-purpose functionality and great value with measurement frequencies from 9 kHz to 7 GHz or 1 MHz to 20 GHz. Get the RF spectrum analyzer accuracy you expect with a variety of options provided to you by Keysight.
-
Product
Basic Kit
-
The CTRL UL101 Basic Kit includes attachments for airborne ultrasound applications including leak detection (any type of gas), vacuum leak detection, electrical inspection, and steam leak detection. Additionally, the kit includes a single 3-inch solid probe for diagnosing steam traps and valves by detecting internal by-pass leaks.
-
-
Product
Automated System for Visual Quality Control of Printing and Marking on Plates
-
The automated visual control system (ASVK) is designed to detect defects in the printing of images and markings applied to the blanks of extruded expanded polystyrene during the production of plates.
-
Product
2.5mm Visual Fault Locator
3105
-
Anfkom International Co.,Limited
The 3105 Pen type VFL is specially designed for field personnel who need an efficient and economical tool for fiber tracing, fiber routing and continuity checking in optical network. It includes:Finding the breakpoint, poor connections, bending or cracking in fiber optic cables.Finding the faults of OTDR dead zoneEnd-to-end visual fiber identification
-
Product
Visual Fault Locator ( VFL)
TM315N
-
The TM315N Economical VFL is an efficient and low cost basic fiber test tool, it provides a visible way to find fiber faults and identify fibers in an optical network during and after installation.
-
Product
Real-time Visualization and Exploitation Tool
Optice™
-
Textron Systems' Optice™ software is an easy to use real-time visualization and exploitation tool purpose-built to enhance interactions with full motion video as well as other data sources. Optice delivers a series of advanced capabilities that not only enriches the data but helps shorten the time from data acquisition to action. Optice allows your operators and analysts to focus on all the operational support functions within one simple tool. There is no back-end system required, allowing you to increase capabilities while reducing costs.
-
Product
Basic Pulsed-RF Measurements For E5081A — Up To 44 GHz
S960251B
-
Add pulsed-RF measurement capabilities to your E5081A ENA-X vector network analyzer.
-
Product
Basic Unit - Medical Equipment Functional Test Module System
GS-X
-
The GS-X Testing System consists of a Basic Unit and various plug-in test modules which the user can purchase as required. The range of functions of these Module-Box is being continuously expanded, and presently includes functions for testing the following devices: - Infusion pumps, Cardiac pacemakers, Defibrillators, High-frequency Surgical equipment, electrical safety ECG Simulation, Equipment for electro-stimulation.
-
Product
Basic Spectrum Analyzer (BSA)
N9324C
Spectrum Analyzer
The N9324C includes a window limit feature that makes simultaneous determinations on the frequency and power limits of a signal. This one-button pass / fail determination reduces instrument setup complexity and significantly improves testing efficiency.
-
Product
Visual Evaluation and Lab Tools
-
Tools for visually evaluating color and excelling color development.
-
Product
Optical Visual Fault Locator
SAT-3C01
-
Shaanxi Aitelong Technology Co., Ltd
SAT-3C01 Optical Visual Fault Locator is used for optical identification, fault locating of SM fiber or MM fiber, which is a basic maintenance tool of optical network, LAN, FDDI, ATM optical system, and telecom network system, suitable for field working.
-
Product
Basic Spectrum Analyzers
BSA
-
Increase productivity on a budget with reliable performance up to 7 GHzGet higher test efficiency with optimized measurement speed and value-added features Reduce learning curve and enhance testing productivity with improved usability features Meet a wider range of demanding RF test needs with multiple functionalities covering spectrum analysis, signal monitoring and transmission/reflection measurements
-
Product
Visual Fault Locators
MVFL Series
-
Shanghai Tarluz Telecom Tech Co., LTD
MVFL series Visual Fault Locators is meet the Class IIIA product, which is the easiest way to identify fibers from end to end and locate polished connector endfaces. Its red laser shines through most yellow-jacketed fibers to help you pinpoint breaks, bends, faulty connectors, splices and other causes of signal loss. The 1mW output power enable the MVFL has a reach of up to 5 km. MVFL seires VFL locates faults visually by creating a bright red glow at the exact location of the fault on single mode (SM) or multimode (MM) fibers. Due to its small size, lightweight and simple but proven design, the MVFL can accompany you anywhere In your pocket or belt pouch in harsh environment
-
Product
Configuration And Visualization Software
-
Schweitzer Engineering Laboratories, Inc.
SEL software helps you optimize the configuration and management of your device and system settings. You can also use it to display and analyze relay event data, element operation, and more.
-
Product
PMC Basic Protocol Tx and Bus Monitor
Sy629PMC-BPM
-
The Sy629PMC-BPM card provides a convenient means for transmitting and receiving data over an ARINC 629 bus in accordance with the transmit and receive programme defined by data written into the XPP and RPP memory.
-
Product
Visual Fault Locator
-
OrienTek Optical Technology Ltd.
powerful, mini visual laser source for fiber fault locating. It has attractive design and small size and it is easy to operate. ● Bright red laser at 650nm● Pulsed and CW operation● Outpower: 1mw,10mw,20mw,30mw● 2.5mm universal connector● 40 hours of operation(1mW)● Pocket size design● 1.25 mm adapter for LC (optional)
-
Product
Basic Desktop Appliance for PCI Express® Gen5
DE200-G5
-
Is a robust, versatile test system designed to test and debug solid state drives (SSDs) of all popular storage interfaces and protocols.
-
Product
Test Executive for Visual Development, Database Storage, and Run-Time Execution of Test Strategies
TestBase
-
TYX TestBase is a test executive that supports the visual development, database storage and run-time execution of test strategies (also known as test plans or test sequences).TestBase integrates third-party applications such as: test programming languages, document viewers, report generators, database engines, Configuration Management systems and diagnostic tools.Its modular and open architecture enables system integrators and end-users to customize and extend the product and to integrate additional third-party applications.
-
Product
Visual Editor for the Automatic Test Markup Language (ATML)
ATML Pad
-
Reston Software offers ATML Pad, a visual editor for the Automatic Test Markup Language (ATML).The ATML formats are versatile but complex. Direct editing in XML is next to impossible, even with capable XML editors. ATML Pad overcomes this problem by exposing an application-specific visual interface. ATML Pad manages the complexity of the ATML formats, allowing you to focus on describing your tests. It abstracts XML ID references, allowing you to simply select the referenced item from a list. In addition, ATML Pad can generate XML IDs automatically and ensures that IDs remain unique while you edit the data.ATML Pad allows you to quickly generate complex ATML constructs through a single mouse click. It validates your data during input and on-demand, ensuring that valid ATML documents are produced.ATML Pad interoperates with the NI TestStand ATML Toolkit to deliver automatic code generation solutions that reduce the cost of implementing NI TestStand test programs and ensures their cost-effective long-term maintainability.
-
Product
PXIe-8234, 2-Port Gigabit PXI Ethernet Interface Module
780244-01
Ethernet Interface
Vision Software Included, 2-Port Gigabit PXI Ethernet Interface Module—The PXIe-8234 with Vision Acquisition Software can acquire images from the fastest GigE Vision cameras. It transfers images at full Gigabit Ethernet bandwidth on both ports simultaneously, and it is optimized for extremely low CPU load. The PXIe-8234 with Vision Acquisition Software provides full GigE Vision bandwidth at every port, giving you the bandwidth you need for your most demanding vision applications. It also includes NI Vision Acquisition Software, which is driver software for acquiring, displaying, logging, and monitoring images from a multitude of camera types. With a set of easy-to-use functions and example programs, you can quickly create applications using LabVIEW, C, C++, C#, Visual Basic, and Visual Basic .NET.
-
Product
COM Express Basic Size Type 7 Module with Intel Atom® C3000 SoC
Express-DN7
Computer on Module
The Express-DN7 is a COM Express® COM.0 R3.0 Basic Size Type 7 module supporting the 64-bit Intel Atom® C3000 processor (formerly “Denverton-NS”) system-on-chip (SoC). 16 CPU cores with 31W TDP and integrated 10G Ethernet make the Express-DN7 especially suited for customers who need excellent computing performance with low power consumption, such as edge computing applications, in a long product life solution.
-
Product
Basic Pulsed-RF Measurements Lite For E5081A — Up To 20 GHz
S960240B
-
Add pulsed-RF measurement capabilities to your E5081A ENA-X vector network analyzer.
-
Product
68-Pin VHDCI Male to 68-Pin, Female SCSI, Twisted Pair, Basic Shielded Multifunction Cable
191945-02
Multifunction Cable
SHC68-68, Twisted Pair Cable with Basic Shielding, 2 m
-
Product
4ch Beam Forming Sound Source Visualization System
BF-3200/MI-5420A/BF-0310
-
Beam Forming is one of the sound visualization techniques that obtains the sound pressure distribution using the phase differece information from the sound source to the microphone, and makes it visualized with the color map.This technique requires a lot of microphones to cover a wide area and generally tends to increase the size of the system. By this Beam Forming system, Ono sokki achieved real time sound source visualization with just 4 microphones.
