Control Software
-
Product
Fan Controller (24V / 48V version)
040-647
-
The Fan Controller (FanCon) is a platform independent system monitoring unit which monitors and if applicable controls the parameters, such as temperature and fan rotation speed, of a basic system.
-
Product
Wireless Test Set Software
-
Extend Keysight wireless test set capabilities with software products designed to streamline wireless measurements and automate testing for time consuming and complex measurement and analysis tasks. Software products are available for all wireless communications test set platforms - automating test for cellular mobile devices, WiMAX™, LTE, and Bluetooth®/WLAN devices.
-
Product
High-Reliability Voltage Controlled Oscillators
-
16 Models with Frequency Bands ranging from 10 MHz to 4350 MHz. 0.5" Hermetically Sealed Surface Mount Package. 50 Ohm Internal Matching. Designed to meet MIL-STD-883 and MIL-STD-202 Test Conditions. Wide Voltage Tuning Range from 0.5V to 20V. Phase Noise as low as -120 dBc/Hz @ 10 KHz offset. 2nd Harmonics as low as -25 dBc. RoHS and REACH Compliant. All models are EAR99. These products are used in military electronics, SATCOM, test and measurement and wireless communications.
-
Product
Signaling Control and Monitor Equipment
MS 1303
-
The Railway signaling unit is used to receive the input signals from the field for validating and clearing route for trains. After receiving the signals, signals are isolated and various tests are done inside the system to ensure the received signals reliability and produce clearance signal to railway line. For security reasons card signature has been given to each card in the system. System consists of digital input modules, digital output module, digital read back module, RS232 interface with 80486 processor board. It is an ISA Bus Back plane based system.
-
Product
Chassis, Carriers And Controllers
-
Automated measuring systems based on the open standards AXIe, VXI, LXI and PXIe have enclosures (base units or chassis) in which modules of a given standard are mounted. Informtest Holding manufactures a wide range of chassis in open standards AXIe, VXI, LXI and PXIe.
-
Product
Corrosion & Temperature Control
-
Corrosion & Temperature Control accessories including corrosion resistant materials, high temperature packages, temperature control jacket, cylinder insulating cover, and more
-
Product
Process Improvement Software for SPI & AOI
SIGMA Link
-
SIGMA Link software suite links altogether solder paste inspection (SPI), automated optical inspection (AOI) and manufacturing execution system (MES). For Smart Factories, SIGMA Link is the essential element to connect inspection machines to Manufacturing Execution System. This real-time interface ensures full traceability and enables interlocking of machines to automate SMT lines while driving yield to new levels.
-
Product
PC Controlled Low Voltage Testers
-
PC Based Testers Low Voltage Introduction. The PC based analyzers provide high-speed testing for wire harnesses, backplanes, and printed-circuit boards.
-
Product
Product Lifecycle Management Software
-
Siemens Digital Industries Software
Our product suites offer capabilities that span the product lifecycle, from design inception to manufacture and support. By doing so, they help turn more of our customers' ideas into successful products. Solutions for: Aerospace & Defense, Automotive & Transportation, Consumer Products & Retail, Electronics & Semiconductor, Energy & Utilities, Industrial Machinery & Heavy Equipment, Marine, Medical Devices & Pharmaceuticals.
-
Product
Reverse Engineering Software Module
Verisurf Reverse
-
Verisurf REVERSE is a complete reverse engineering solution offering innovative tools to create CAD models from points, clouds, and meshes.REVERSE optimizes the performance of probing and scanning technologies such as portable arms, laser trackers, structured light, laser scanners, and many others.
-
Product
Channeling Decoder, Nav/Comm/Control Head
RCD200
-
Designed to provide the Avionics shop a simple and expeditious method for testing general aviation radio tuning. Provided are front panel mounted LED's as well as a digital display to provide the quickest code recognition while testing. With this simple method of testing you will soon find yourself testing all your radios and finding those troublesome intermittents. This unit also decodes altitude and ARC 1000 serial data. Click on picture for larger view.
-
-
Product
Automated System for Identification and Control of Pharmaceutical Codes
-
The automated system for identifying pharmaceutical codes includes two scanners of the pharmaceutical code, two sensors for the presence of an object and a data processing unit (BOD). When the box or instructions are passed under the object presence sensors, the farm code is read by the corresponding scanner and the results are transmitted to the computer via the Ethernet interface. The BOD verifies the correctness of the read out farm code by comparing this code with the reference farm code set at the beginning of the system operation. If the farm code has not been read or does not match the standard, the packaging machine stops and the type of error is displayed on the indicators.
-
Product
Software
DPM-3
-
Was developed to read and edit Plug and Play Smart Sensors that are compliant to the IEEE 1451.4 Standard. TEDS, or transducer Electronic Data Sheet, is a set of electronic data in a standardized format defined within the IEEE 1451.4 standard. This data specifies what type of sensor is present, describes its interface, and gives technical information such as sensitivity, bridge type , excitation, etc. This information is stored in an EEPROM chip attached to the sensor. By having this chip, the sensor can identify and describe itself to the network and or Smart Load Cell Meter (DPM-3), thereby easing automatic system configuration.
-
Product
Application Software for Electronic Test & Instrumentation
-
Application software provides configuration-based workflows for electronic test and instrumentation applications. Application software is part of the NI software portfolio.
-
Product
Force Sensors, Controls & Switches
-
Direct caliper motor/spindle integration for Brake by Wire systemsExtra-small form factor MSG sensors that weigh less than five gramsFacilitating system-level miniaturizationAdvanced button-type sensors designed to lower costs and improve accuracy
-
Product
Plug-in Main Controller and Remote Interface
Series C710
-
Universal Switching Corporation
The Series C710 plug-in controllers are the key to our newer products including the advanced Series G2 product line. The C710 is available in three versions. The C710 is field upgradeable by attaching your PC to the Soft-Load port where it is possible to upload a new firmware package provided by the factory. All firmware upgrades are delivered with the required serial cable to connect between the Soft-Load service port and a standard serial port.
-
Product
Limit Controllers
-
Limit Controllers shut down power to heating and cooling circuits in the event of an out-of-range hot or cold condition. Disables a redundant coolant valve to protect against primary coolant valve failure. Easily read and set by the user. The large LED display indicates temperature and system status.
-
Product
Fast Response Flow Controller for Low Flow
HFM-300 / HFC-302
-
The all metal HFM-300/HFC-302 is Teledyne Hastings' metal sealed, fast response series of mass flow meters and controllers. Featuring reliability and stability, the 300 Series is chosen by OEM's for its fast response under a wide range of conditions. .The HFM-300 / HFC-302 meters and controllers have flow ranges from 0-5 sccm to flows of 0-25 slm; provide analog outputs, are constructed of stainless steel and have normally closed valves. The full scale range is specified by the end user. A NIST traceable calibration certificate is standard. Corrosive gases and pressures up to 1000 psig are easily measured. Cleaning for oxygen service is available.
-
Product
DisplayPort To DVI Adapter For Embedded Controllers
Y1261A
-
Achieve backward compatibility between DisplayPort and a DVI computer monitor.
-
-
Product
PXI Remote Control Interface Cable, 3m
41-924-300
-
The 41-924-300 is a 3m cable accessory for the PCIe to PXI Remote Control Interface Kit. The kit provides a seamless connection between a PC’s PCIe slot and a PXI chassis and is suitable for providing an interface to any PXI chassis.
-
Product
Test Management And Reporting Software
-
AFL’s PC- and cloud-based software solutions provide both the knowledge and the power to analyze your data and generate standard or custom reports that provide actionable intelligence for your business
-
Product
Recloser Controls
-
Schweitzer Engineering Laboratories, Inc.
Recloser controls provide fault location, isolation, and system restoration using protection and communications capabilities, such as Automatic Network Reconfiguration and single- and three-phase tripping. They allow you to automatically reconfigure your distribution system to isolate faults, quickly restore service, and reduce customer impact.
-
Product
DIN Temperature/Process Controller
Series 16B
-
Dual Control Output, RS-485 Communication, Universal Inputs
-
Product
Automated Pit Identification and Measurement Software
APIMS
-
Surface pitting processes are ubiquitous in material science and engineering applications. Rigorous analysis of surface pitting features is time-consuming and error-prone whenever manual measurements are employed. Barron Associates’ APIMS software eliminates the need for tedious manual pit measurements. APIMS analyzes digital surface profilometry data and automatically identifies the location and size (width and depth) of surface pits. APIMS provides built-in noise reduction features to enhance performance and reduce both measurement noise and surface tilt.
-
Product
USB Controlled Loudspeaker & Microphone Test Interface
AmpConnect™ ISC
-
AmpConnect ISC is an all-in-one audio interface that simplifies your test setup and operation. It is a single, rugged, rack-mountable piece of hardware containing a high-accuracy audio interface, impedance box, amplifier, headphone amplifier, 2 microphone power supplies and digital I/O. It replaces multiple hardware devices, connecting to your computer via a single USB cable, and it is fully controlled by SoundCheck. This simplifies setup and calibration, eliminates cabling and reduces connectivity errors, as well as reducing overall system cost.
-
Product
Facility Environment Controller
SMC 2450
-
The SMC 2450 Facility Environment Controller is designed to manage HVAC controls, environmental alarms, and manage rigorous personnel safety requirements of controlled environment vaults (CEVs) and walk-in cabinets. The SMC 2450 also monitors CEVs for the presence of combustible and toxic gases and automatically initiates ventilation when an alarm threshold is exceeded.
-
Product
Flow Ratio Controllers
-
Optimizing process performance just became easier with the DELTA™ Flow Ratio Controller (FRC). Widely used in a variety of flow splitting applications such as etching, stripping, and PECVD, the DELTA™ Flow Ratio Controller (FRC) provides users with the ability to distribute gas or gas mixtures to different zones in a process chamber.
-
Product
Image Processing and Analysis Software
ENVI
-
L3Harris Geospatial Solutions, Inc
ENVI is the industry standard for image processing and analysis software. It is used by image analysts, GIS professionals and scientists to extract timely, reliable and accurate information from geospatial imagery. It is scientifically proven, easy to use and tightly integrated with Esri’s ArcGIS platform.ENVI has remained on the cutting edge of innovation for more than three decades due in part to its support of all types of data including multispectral, hyperspectral, thermal, LiDAR and SAR. ENVI makes deep learning accessible to people through intuitive tools and workflows that don’t require programming. ENVI geospatial image analysis can also be customized through an API and visual programming environment to meet specific project requirements.
