Product

EMI Shielding Effectiveness Testing

-

Eurofins E&E

Eurofins E&E

Eurofins E&E North America can easily develop sound engineering measurement techniques to quantify the SE of your product. Our process involves creating detailed SE Test Plans used to insure accurate and repeatable test results.Eurofins a has years of experience to assure our customers that the evaluation reflects the electrical attenuation performance of the material. Often times, our test report becomes supporting documentation for our customer’s end-user contractual requirement, where Independent Test Laboratory results verify the electrical performance of the material being tested.

Product

MIPI Receiver Test Solution

M8085A

-

Keysight Technologies

M8085A - Keysight Technologies

The M8085A is a software plug-in for M8070A Bit Error Ratio Test system software within the M8000 series of BER test solutions. The M8085A software plug-in controls either the M8190A or the M8195A Arbitrary Waveform Generators to create C-PHY or D-PHY standard compliant test signals. In addition it provides routines for calibration of all signal parameters and for all tests specified in the applicable Conformance Test Suite. Together with the additional available DUT control interface it is possible to read the BER of the receiver under test from the M8070A software and display the BER dependency from test parameters within the M8070A user interface.

Product

47~2600MHz Digital TV & Satellite TV PIN Optical Receiver

HRS-26D/P

-

Hangzhou Huatai Optic Tech. Co., Ltd.

HRS-26D/P - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai HRS-26D/P optical receiver, adopting high-sensitivity PIN detector, receiving sensitivity is -22dBm, typical value -13dBm. It can receive analogue and digital signal with the frequency of 47~2600MHz on a single fiber, and compatible with any FTTx PON to achieve triple-network combination between Analog TV(<10CH), Digital TV (DVB-C, DVB-T), Satellite TV (DVB-S) and Internet & FTTH.

Product

Telephone Wire Cable Tester For Testing Continuity With Sender And Receiver

PHCT55

-

Pyle Audio Inc.

PHCT55 - Pyle Audio Inc.

The PHCT55 is a two-piece item that tests telephone wire continuity. Play a test tone on one end and listen on the other, judge continuity, and diagnose break points.

Product

Optical Receiver Stress Test Solution

N4917B

-

Keysight Technologies

N4917B - Keysight Technologies

The N4917B software provides an automated standard compliant stressed receiver sensitivity test according to 100GBASE-LR4, ER4 and SR4 test specification. In order to do this kind of test, several test instruments such as a bit error ratio tester, digital sampling oscilloscope, optical reference transmitter and tunable laser source are required to operate together to achieve a compliant, repeatable optical stressed eye. This stressed eye is then fed to the receiver under test, where bit error ratio is measured under the stress conditions as defined in the standard.

Product

ALC (AGC) FTTB Optical Receiver

BG9244x-LD

-

Hangzhou Huatai Optic Tech. Co., Ltd.

BG9244x-LD - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai BG9244x-LD product series have the bandwidth of 47~862MHz,with ALC（AGC）function, two outputs, the output level Vo=104dBμV （Pin:-7~+2dBm, APD=8dB）. The device has built-level gain and equalization adjustment, visual display about optical power, and can choose 1way or 2 ways high level output by illustration. It applies to FTTB optical access to network, is an ONU optical receiver unit of RFTV radio network with low power, high performance, high cost- effective.

Product

EMI Amplifiers

-

EMCTEST

EMCTEST

Overvoltage protection,shuts off above 29VOver-temperature protection,shut off above +100°CExcellent IP3 Class A amplifierVSWR Short and Open circuit protection

Product

6 Channel Digital Receiver Module

DP-VME-5826

-

Data Patterns Pvt. Ltd.

DP-VME-5826 - Data Patterns Pvt. Ltd.

DP-VME-5826 is a VME64x Six Channel Digital IF Receiver module. It samples and down converts analog IF signals into the digital base band data.The digital base band I/O samples generated from these IF samples are pulse compressed. Down converted I/Q data is sent to the signal processor through 2 channels of 2.5 Gbps speed SFPDP link.The digital waveform generator block of digital receiver unit generates programmable polyphase coded digital pulse coded expander output.

Product

47~862MHz FTTH CATV Optical Receiver

H9122

-

Hangzhou Huatai Optic Tech. Co., Ltd.

H9122 - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai H9122, the operating bandwidth of 47~862MHz, Products with high sensitivity optical receiver tube and Huatai special low noise matching circuit,Whether used in analog television or digital television, have high reception sensitivity and excellent intermodulation distortion index. is a low power, high performance, cost-effective triple play, FTTH CATV optical receiver.

Product

Digital Instantaneous Frequency Measurement Receivers

DIFM

-

Mercury Systems, Inc.

DIFM - Mercury Systems, Inc.

Mercury Systems offers a range of standard high-performance broadband Digital Instantaneous Frequency Measurement (DIFM) receivers and Digital Frequency Discrimination (DFD), which act as functional building blocks in many military electronic warfare systems. Examples include electronic counter measures (ECM) systems, electronic surveillance measures (ESM) systems and radar warning receivers (RWR).