Particle Impact Noise Detection
vibration, shock, and acoustics testing conducted to find particulate contamination.
See Also: Particle Impact Noise Detectors, PIND
-
Product
V-Band Low Noise Amplifier 50 to 75 GHz, 35 dB Gain, 5 dB NF
SBL- 5037533550-1515-E1
-
50 to 75 GHz, 35 dB Gain, 5 dB Noise Figure V Band Low Noise Amplifier for IEEE 802.11.ad WiGig. Model SBL-5037533550-1515-E1 is a low noise amplifier with a typical small signal gain of 35 dB and a nominal noise figure of 5 dB across the frequency range of 50 to 75 GHz. The DC power requirement for the amplifier is +8 VDC/150 mA. The mechanical configuration offers an in-line structure with WR-15 waveguides and UG-385/U flanges.
-
Product
12-Bit, 2.5 GSPS Digitizer Optimized for Pulse Detection
ADQ32-PDRX
Digitizer
ADQ32-PDRX acquires the input signal via a single connector and uses an onboard splitter to separate the signal into two paths with different gain settings. The high gain path is used to accurately capture low-amplitude portions of the input signal whereas the low gain path ensures the acquisition of high-amplitude peaks without causing saturation. The two signal paths are then combined in real-time inside the onboard field-programmable gate array (FPGA) to create a digitized output with improved performance.PDRX increases the dynamic range by 3 bits and is fully integrated into the digitizer for fast and easy system-level integration. ADQ32-PDRX is therefore comparable with a 16-bit digitizer in terms of dynamic range, but with the benefit of offering a higher sampling rate.
-
Product
10 MHz to 55 GHz Noise Sources
CNS346 Series
-
The Spanawave CNS346 Series is designed for precision noise figure measurement applications. The superior VSWR characteristics reduce multiple reflections of the test signals and significantly increase the measurement accuracy of most noise figure set-ups. The CNS346 Series noise sources have broadband coverage and extremely good temperature and voltage stability, for the finest noise figure meter-compatible laboratory standards. Outputs of 6, 15.5 and 22 dB ENR are available, allowing the units to accurately measure noise figures up to 20 ,30 and 36 dB respectively.
-
Product
Particle Counter
VLT-E9700
-
Modern diesel engines are quite clean, provided the soot filter is present and working properly. A soot filter can get clogged, or even malfunction. In that case the filter has to be cleaned or replaced. Unfortunately, sometimes the vehicle owner has the filter removed altogether. When the filter has been physically removed, it is ‘programmed out’ of the vehicle software, so that the removal of the filter remains undetected during an (E)OBD check. This is why in ever more countries a particle count is mandatory during a periodic inspection of e diesel vehicle.
-
Product
Advanced Threat Detection
-
The Passive Airborne Warning System (PAWS) family of IR-based Passive Warning Systems provides a comprehensive, turn-key solution for airborne platforms. The sophisticated IR missile warning systems enhances airborne platform survivability by providing advanced warning of the presence of threatening missiles and by automatic management to all types of applicable countermeasures available onboard.
-
Product
Low Noise Super Wide Band Amplifiers
WBA Series
-
WBA series low noise amplifiers have the octave bandwidth from MHz to GHz. With super low noise figure and exceptional low VSWR, WBA series LNA achieves exceptional gain flatness accross octave or multi-octave bandwidth.
-
Product
Noise Board
332D-11 VG
-
This printed circuit board was designed to original specifications and contains OEM specified parts. This board is required for testing the 332D-11 series gyros. Also contained on board is the Method A type calibration and sample and hold circuits required to perform the calibration of the noise circuits.
-
Product
Forward Path NPRT 2200 Noise Power Ratio Test Set
NPRT 2200-F
-
The NPRT 2200 measures the NPR of a device across a range of power levels. This test quantifies intermodulation distortion and determines the dynamic range of optical transmitters, amplifiers and other active HFC network devices. The included PC software uses predefined test setups to run a "Power Sweep" series of NPR measurements and graph the results.
-
Product
Digital Impact Test Machine
-
The Digital Impact Testing Machine mainly used to determine the anti-impact capability and strengthen impact toughness of non metallic materials such as nylon, glass fiber reinforced plastic, ceramic & cast stone, electrical insulating materials etc.Sample and support are easy centeringThe pendulum of the machine can be raised or released automatically by button pressedDigital LCD screen control and value displayThe machine comply with GB / T1843, ISO 180, GB / T21189, GB / T2611 and other international standard
-
-
Product
Dual Channel Noise Dosimeter
SV 102+
-
The SV102 + is our latest dual-channel noise dosimeter and replaces our ground breaking SV102. It has been designed for the accurate measurement of noise exposure to ISO 9612 and MIRE (microphone in real ear) measurements to ISO 11904-1.
-
Product
Environmental Noise Measurement Kits
-
Environmental conditions can significantly impact the accuracy of sound level measurements, particularly when conducting assessments in outdoor environments, so this is where an Outdoor Environmental Noise Kit can help you. The kit provides a fully weather-protected system for outdoor noise measurement to protect your sound level meter and microphone from harsh weather conditions, ensuring reliable and accurate readings in any environment for up to 1 week.
-
Product
High Voltage Porosity Detection
-
High Voltage Technique: The high voltage, or porosity technique, can be used to test coatings up to 25mm (1”) thick and is ideal for inspecting pipelines and other protective coatings. Coatings on concrete can also be tested using this method.
-
Product
IEC60669 Pendulum Impact Test Machine
CX-BC1
-
Shenzhen Chuangxin Instruments Co., Ltd.
IEC60669 Pendulum Impact Test Machine
-
Product
Pinhole Detection Devices
-
ElektroPhysik Dr. Steingroever GmbH & Co. KG
The coating control by means of pore testing makes use of electrical voltage in order to uncover microscopically small defects (> 20 μm) in the coating of a surface. If even a small defect can be detected during pore testing of surface coatings, urgent action is required. Minimal flaws in the coating are sufficient to cause great damage.
-
Product
Insight Vertical Fall Pharmaceutical Metal Detection System
-
The Insight Pharmaceutical Vertical Fall Metal Detection system is designed for inspecting powders and granules with a throughput of up to 3000kg per hour.
-
Product
Sound Level Meter - For Workplace And Environmental Noise
SONIK-SE
-
The SONIK-SE is a powerful sound level meter which is ideal for performing occupational and environmental noise assessments for a variety of applications.
-
Product
Quartz Impact Force Sensors
-
Impact-style sensors are specifically designed for impact force measurements. The sensor is typically mounted in a free-standing manner with the installed impact cap directed toward the oncoming object with which it will collide.
-
Product
Drone Detection RF Monitoring System
-
Shenzhen Tangreat Technology Co., LTD.
Drone Detection RF Monitoring System by Tangreat
-
Product
Low Noise Amplifiers
-
Chengdu KeyLink Microwave Technology Co., Ltd.
KeyLink's low noise amplifiers typically exhibit noise figures below 5.5dB and output 1dB compression points up 8dBm. These amplifiers are economical choices for general purpose applications. KeyLink's low noise amplifiers can be categorized as follows.
-
Product
2 Inch 535g Steel Impact Ball For Impact Test
CX-B2
-
Shenzhen Chuangxin Instruments Co., Ltd.
2 inch 535g steel impact ball for impact test
-
Product
Nano Particle Size Analyzer
SALD-7500nano
-
Delivering 10 times the sensitivity of previous models, this innovative analyzer is capable of continuously measuring changes in particle size and particle size distribution at one-second intervals, within a range spanning 7 nm to 800 μm. In addition, unique options that accommodate the measurement of even high-concentration samples (up to 20 wt%) and trace quantity samples (down to 15 μL) are available. Due to its leading-edge measurement capabilities, the analyzer will likely be used for many applications in new areas, including nanotechnology, the life sciences, and fine bubbles (microscopic bubbles).
-
Product
Low Noise Test Cables For N1413 With B2980 Series, 1.5 M
N1427A
Coaxial Cable
The N1427A is designed to operate specifically with the B2985B/87B Electrometer/High Resistance Meter. It comes with a separate triaxial (special screw-type) female connector and a High Voltage BNC (special type) female connector. This allows terminal configuration to be converted to any other configuration. Therefore, custom test fixture can easily be constructed. The N1413A High Resistance Meter Fixture Adapter is also required to connect the N1427A to the B2985B/87B.
-
Product
AEROTRAK™ Handheld Particle Counters
9306
-
The TSI AEROTRAK™ Handheld Particle Counters offer the most features and flexibility for customers interested in low cost and versatile particle contamination monitoring.
-
Product
Fluorescent Leak Detection
-
How to pinpoint the exact source of leaks, save money, and protect your business. Our OEM approved fluorescent dyes work as a preventive maintenance system to protect your workers and your business. Our safety products are being utilized in mines all over the world.
-
Product
Noise Measurement Kits
-
Our noise measurement kits contain all the accessories you need to take accurate noise measurement instruments correctly.
-
Product
Ultra-low Noise Phase Inverter - Buffer
WMA-IB-LN
-
The WMA-IB-LN can be used to double the output voltage of two high voltage amplifiers by driving them in bridge mode, or as high impedance input buffer while maintaining precision and ultra-low noise. The WMA-IB-LN model has been designed specifically for the Falco Systems WMA-200 high voltage amplifier. Two WMA-200 amplifiers combined with one WMA-IB-LN provide unprecedented noise performance and output voltage range.
-
Product
Color Sensor & Proximity Detection
-
The ams family of color and Ambient Light Sensing (ALS) sensors combined with proximity detection provides red, green, blue, and clear (RGBC) or green and clear (ALS) light sensing and proximity detection. These modules also contain an IR LED for the proximity function. Both the light and proximity sensing functions feature high sensitivity and a wide dynamic range, so these devices may be placed behind the dark bezels of smartphones, monitors, laptops and TVs.
-
Product
Noise Monitoring Station
HD2011NMT
-
HD2011NMT is a remote control Noise Monitoring Station with meteo parameters acquisition. It is designed to be part of a network of noise monitoring terminals or a stand alone unit.
-
Product
Noise Bridge, RF 1 MHz to 100 MHz
MFJ-202B
-
Quickly adjust almost any antenna for maximum performance, 1 to 100 MHz. Lengthen or shorten your antenna for minimum SWR. Measure resonant frequency, feedpoint resistance and reactance. Works with any receiver or transceiver. Hand-calibrated resistance scale, expanded capacitance range and exclusive built-in range extender.
