Product

4 Channels, MIL-STD-1553, Dual Redundant, Direct Coupled, Assisted Mode Capable (AMC)

FTF

-

North Atlantic Industries

FTF - North Atlantic Industries

MIL-STD-1553 is a military standard published by the United States Department of Defense that defines the mechanical, electrical, and functional characteristics of a serial data bus. It was originally designed for use with military avionics, but has also become commonly used in spacecraft On-Board-Data-Handling (OBDH) subsystems, both military and civil. It features a dual, redundant, balanced-line, physical layer; a (differential) network interface; time division multiplexing; half-duplex command/response protocol; and up to 31 remote terminals (devices).

Product

Multicore Universal Solderability Tester

MUST System 3

-

Gen3 systems

MUST System 3 - Gen3 systems

The MUST System 3 is the latest technological evolution of the original Multicore Universal Solderability Tester (MUST) that grandfathered all modern solderability test standards. It remains the unquestioned industry benchmark for solderability testing.

Product

Lab Moisture Analyzer

-

Finna Sensors

Finna Sensors

PC-Based laboratory/production Moisture Analyzer connects through the RS-232 Serial Port. For nuts, granules, powders, pellets, chips or flakes. Complete with:– MCPC-RS Test Chamber– Windows PC-Based Software– Two Sample Cups– Dial Thermometer– Standard Block– RS-232 Cable (10 Feet)– USB to RS232 Adapter– Operating Instructions Manual– 115VAC/60HZ Wall Transformer

Product

Intelligent and Unidirectional Scrape Tester

ZDG-25

-

Shanghai Dean Electrical Co., Ltd

ZDG-25 - Shanghai Dean Electrical Co., Ltd

Executive standard: GB/T4074.3-2008/IEC60851-3Inspection standard: JB/T4279.9-2008Meet GB/T6109-2008 standard requirementsUsed to test the film scrap resistance of enamelled round wires with nominal conductor diameter above0.250mm;Application of SCM control，enter the weight value, operation will be completed automatically: put down the scraping rod, stop while film scratch, calculate and show the scraping force, raise the scraping rod, return to zero, sample rotates 120°and repeat the same operation, calculate and show the scraping force of three times and average scraping force.When film is scratched, film scraper would automatically stop scraping, with exposed conductor of sample＜3mmWith the advantages of high sensitivity, good repeatability, stable and reliable characteristics.

Product

Standard Tests

-

LXinstruments GmbH

LXinstruments GmbH

The following list contains only the most important standards and does not claim to be complete.EN 60204-1 Electrical equipment of machinesEN 60335-1 Electrical appliances for household and similar useEN 50106 Sampling test, routine tests (in conjunction with EN 60335-1)EN 60598-1 LuminariesEN 60601-1 Medical electrical equipmentEN 60730-1 Automatic electrical controlsEN 61010-1 Measuring, control and laboratory equipmentEN 61439-1 Switch cabinet and switchgearEN 62368-1 Equipment for audio/video, information and communication technologyEN 62841-1 Hand-held electric toolsEN 50191 Erection and operation of stationary and non-stationary electrical test equipmentLVD Low V oltage D irective _

Product

Fibre Channel

-

Teledyne LeCroy

Teledyne LeCroy

Fibre Channel continues to evolve as the preferred communications standard for mission critical and time sensitive Storage Area Network (SAN) applications. Fibre Channel supplies over 80% of the datacenter and enterprise interconnections where lossless delivery of data is required and will be used for many years to come. Gen 6 (32GFC) products and solutions are rapidly being deployed ubiquitously across key markets today.The Fibre Channel industry is now focusing efforts on the development of Gen 7 – 64GFC utilizing PAM4 signaling – and will continue to serve those applications needing higher bandwidth and guaranteed delivery of time and content sensitive data.The SierraNet Family of Fibre Channel test platforms provides best in class traffic capture, analysis, and manipulation for testing physical link characteristics and application operations. SierraNet is designed for addressing today’s high-speed storage and communications fabrics problems and compliments other tools offering industry leading visibility and utility.

Product

Rail-to-Rail Op Amplifiers

-

Analog Devices Inc.

Analog Devices Inc.

Analog Devices high speed (> 50 MHz) rail-to-rail op amps enable you to operate at lower supply voltages, swing closer to the rails, and provide wider dynamic range. Featuring a portfolio with a wide variety of op amps, including both rail-to-rail input/output as well as just rail-to-rail output, ADI provides the widest portfolio of leading edge products available on the market. Whether it is wide bandwidth, high slew rate or low distortion, or rail to rail, no one sets more performance standards for next generation designs than Analog Devices.

Product

DC Power Source for Standard Lamp

DC502

-

Lisun Electronics Inc.

DC502 - Lisun Electronics Inc.

DC502 is CONSTANT CURRENT DC POWER SUPPLY for standard lamp. Function and technical indexes are as follows: • output voltage 4 grades: 6V/12V/24V/50V • output current: DC 0~2.5A (adjustable) • Output current drift at full scale: ±0.05% reading value/10 mins • Monitor range of ampere meter: 0.0000A ~1.9500A, 1.950 A ~2.500A • Accuracy of ampere meter: ± (0.08% reading value + 0.02% full scale) • Max output power: 80W • Continuous working time: 8 hours • Work environment: Temperature 0℃ -25℃, humidity ≤ 85%R.H, supply source: AC220 ±10%, 50/60HZ • Holding conditions: -20~50℃ humidity < 75%R.H • Outside dimension (W×H×D): 333mm×114mm×307mm • Weight: about 8kg • Power: about 1000VA

Product

Magnetic Field Generator

PFM61000-8A

-

Lisun Electronics Inc.

PFM61000-8A - Lisun Electronics Inc.

PFM61000-8A Magnetic Field Generator is high reliability test equipment with stable performance, specially designed for electrical and electronic products for measuring immunity characteristics and requirements of normal frequency magnetic fields. It provides an accurate basis for the tested equipment in the immunity test of normal frequency magnetic field. The generator can imitate the magnetic field environments such as residential, commercial, industrial and mining enterprises, power plants, as well as middle and high substation. It fully meets IEC61000-4-8 and GB / T17626.8 standards.

Product

mAEStro Audio Analog to Digital Converter

-

En Technology

En Technology

The mAEStro AADC-100 accepts balanced stereo analog audio inputs and converts them into a single digital bit stream in compliance with the AES/EBU (AES3) and S/PDIF digital audio standards. It generates 24-bit values and uses 128 times over-sampling for extremely accurate and linear analog to digital conversion, as well as offering a high dynamic range with exceptionally low total harmonic distortion and noise.

Product

Ionic Contamination (Cleanliness) Tester

Zero-Ion

-

Aqueous Technologies Corp.

Zero-Ion - Aqueous Technologies Corp.

Current IPC standards now require ROSE testing for process monitoring. The Zero Ion ionic contamination tester fully complies with current IPC standards.

Product

Phase Angle Meter

597C

-

Red Phase Instruments Australia Pty Ltd.

597C - Red Phase Instruments Australia Pty Ltd.

The Model 470A has similar software and performance as the Model 465C. It is packaged in a 19? style bench-top case with all connections on the front panel for use in meter test benches. It has inputs for comparison with another polyphase standard or 3 separate single phase standards for verifying calibration accuracy.

Product

Horizontal Profile Projector

-

Sinowon Innovation Metrology Manufacture Ltd.

Sinowon Innovation Metrology Manufacture Ltd.

◆ The lifting system adopts cross roller rail and precision screw drive, which makes lifting drive more comfortable and stable;◆ Coating process reflector, clearer image and great dustproof;◆ Adjustable contour and surface illumination, to meet with difference workpiece demand;◆ Imported high light and long using life LED illumination ,to ensure precision measurement demand;◆ High resolution optical system with clear image and magnification error is less than 0.08%;◆ Powerful Bi-axial fan cooling system，highly increase using life;◆ Powerful and colorful DRO DP400，realized fast and accurate 2D Measurement;◆ Built-in Mini-printer, can print and save data;◆ With standard 10X objective, optional 5X,20X，50X，100X objective，rotary table, foot switch ,clamp, etc.

Product

Portable Connector End Face Geometry Interferometer

-

Thorlabs, Inc.

Thorlabs, Inc.

Thorlabs’ Vytran® Connect-Chek® Interferometer automatically and precisely measures radius of curvature, apex offset of polish, and fiber undercut or protrusion on any PC or APC, single-fiber connector. The CC6000 interferometer uses a non-contact tilted-phase-analysis technique for fast, reliable measurements of connector end faces. This compact interferometer has a carrying handle and must be attached to a desktop or laptop computer (not included) with a standard USB 2.0 port for operation. The included CC6000 software, which is used to control the interferometer, can be installed on a computer with the minimum requirements in the table below. Designed for use in both the factory and the field, this interferometer provides crucial quality information needed to assure long-term performance of fiber optic connectors. One CC250P Mount for Ø2.50 mm PC Connectors and one RT250P Reference Tool for calibrating the CC250P mount are included with the CC6000 interferometer; mounts and reference tools that enable measurement of other PC or APC, single-fiber connectors are available separately below. When used with an appropriate mount for APC connectors, the CC6000 interferometer is also capable of measuring the APC angle and key error.

Product

Function Generator

FG-281

-

Texio Technology Corp.

FG-281 - Texio Technology Corp.

The FG-281 is a function generator using DDS (Direct Digital Synthesis) for superior frequency stability. Possible to output sign wave and square wave at wide oscillation range from 10mHz to 15Mhz. A 10-key keypad provides user-friendly operation even though various functions are available. Possible to memorize 9 kinds of panel settings and they can be recalled easily. RS-232C and GP-IB interfaces are available as standard and enable to be controlled by PC (full remote control).

Product

R3

-

Dewesoft d.o.o.

Dewesoft d.o.o.

R3 - 19'' Rack Mountable DAQ SystemRack mountable DAQ system built into standard PC computer chassis and integrated SIRIUS data acquisition slices. Ready for simple and inexpensive upgrade of PC components.

Product

Flameproof Type Safety Light Curtain Type 4

BSF4-AH80

-

Panasonic Industrial Devices Sales Company of America

BSF4-AH80 - Panasonic Industrial Devices Sales Company of America

Flameproof Type Safety Light Curtains Type 4 from Panasonic comply with worldwide flameproof standards. Protection height of 1,595 mm or 62.8 inches.

Product

Rain Test Chambers

-

Shanghai Morningtest Environmental Chambers Co.,Ltd.

Shanghai Morningtest Environmental Chambers Co.,Ltd.

Rain test chambers for ingress protection testing simulates rain/water test as per IEC 60529 and DIN 40050-9((IP Code standard)) test standard. • IPX1 Protection against vertically dripping water• IPX2 Dripping water ± 15° from vertical• IPX3 Protection against spraying water• IPX4 Protection against splashing water• IPX5 Protection against low pressure jetting water• IPX6 Protection against high pressure jetting water• IPX7 Protection against temporary immersion• IPX8 Protection against continuous immersion• IPX9K Extremely high pressure jetting water

Product

Gas Leak Detector

GSD600

-

Amprobe Test Tools

GSD600 - Amprobe Test Tools

The Amprobe GSD600 Gas Leak Detector is a fast responding gas leak detector for methane and propane gas. The meter emits a frequency tone when gas is detected. The frequency of the beep coincides with the concentration of the gas. The LEDs display the level of gas present in an area or room. Pinpoint gas leaks for closed piping systems. Use the mute function in quiet work areas and utilize the LED displays. Or a standard earphone jack for hearing the meter in loud environments.