Bar Code Verifiers
-
Product
PoE Voltage Monitor Detect & Verify
PE-400
-
PE-400 is specific to test and verify PSE or Ethernet outlet either a standard/active PoE or a NON-standard/passive PoE to avoid damaging Non-PoE device as well as monitor and display available Voltage simultaneously. It built-in PoE interface controller to trigger on 802.3 af, at and bt switch and verify standard PoE type either 802.3 af or 802.3 at, and power source either End or Mid or both, and power polarity as well as display voltage values. The operational voltage which should be measured when installing a new PoE system or when you troubleshooting an existing system.
-
Product
Color Bar Generator
BL-CBG402-01N
-
The BL-CBG402 is a small (2 inch x 2 inch) RGBS Color Bar Generator designed for embedded and systems applications. It produces a split field SMPTE style color bar pattern and has either an external composite sync line of optional sync-on-green (set with an optional on-board DIP switch) Video timing is NTSC/EIA 60Hz field rate. The BL-SBG402 operates from a +5V regulated power source.
-
Product
Time Code Reshaper/ Distributor
SR-28
-
The SR-28 can drive time code over long cables, making it ideal for synchronization during live shows and remote recording. The SR-28 time code distributor, with two inputs and eight outputs, reshapes time code while distributing it, eliminating amplitude distortions and level fluctuations. The level of each output is individually adjustable via front panel pots. The input is selected via a front panel switch. Also included are 2 power inputs and an automatic switch over in case of failure.
-
Product
PCI POST Code Display
post4d
-
During power on self-test (POST), most PC BIOSes will write diagnostic codes to port 80h or port 84h (jumper selection). Use post4d to display these codes on a dual digit LED display. Additional LEDs indicate the status of the power supply rails. Convenient business card size.
-
Product
24U (42") Non-Insulated Bus Bar
BB-42
-
24U (42") non-insulated bus bar provides cabinets with recessed rail option and a convenient, isolated common grounding mechanism.
-
Product
Inline Barcode Verifiers
DataMan 475V Series
-
Cognex barcode verification technology ensures the readability and compliance of 1D and 2D barcodes to industry standardization guidelines. Today most companies spot check codes one at a time using an offline, operator-based verifier which can be slow and cumbersome.
-
Product
Spark Free Generator Bar
993R
-
The Meech Model 993R is a high performance generator bar for use with the Meech range of 30kV and 50kV high voltage DC static generators.
-
Product
12U (21") Non-Insulated Bus Bar
BB-21
-
12U (21") non-insulated bus bar provides cabinets with recessed rail option and a convenient, isolated common grounding mechanism.
-
Product
Formally Verified Optimizing C Compiler
CompCert
-
AbsInt Angewandte Informatik GmbH
Meet the highest levels of software assurance by compiling your application with the only C compiler that's been formally verified to be free of miscompilation issues. All safety properties verified on the source code, e.g. with Astre, are guaranteed to hold for the generated executable as well.
-
Product
Temperature, Humidity, Bar. Pressure Transmitter
T7318
-
For exacting interiors in building energy management and HVAC systems. Are designed for easy installation on ordinary KU68 wiring boxes for household switches and sockets.
-
Product
Code Coverage Tool
Testwell CTC++
-
Testwell CTC++ is the leading Code Coverage Tool for measuring Code Coverage on host and all embedded targets (even very small ones). The tool is compliant to Safety Standards. Hundreds of companies all over the world use Testwell CTC++ with great success. Testwell CTC++ is the first choice for companies which have to achieve and to proof high code coverage in aerospace, automotive, transportation, healthcare and other industries.
-
Product
Wheelset Axle Identification Using 2D DMC Codes
-
Automation of the process of identifying the axles of wheelsets at the site of the final inspection by the two-dimensional codes applied to them. The system should provide automatic search, reading and recognition of a two-dimensional code punching on the axis. The recognition result should be automatically transmitted to the ultrasound diagnostic unit as an identifier of the controlled object.
-
Product
MILLENNIUM HEAVY-DUTY PRO CODE READER
MDM90HD
-
*Read and clear DTCs; read I/M readiness, data stream, freeze frame, O2 sensor info, on-board monitoring, vehicle information on (1996 and newer OBDII protocols based) vehicles*Read and clear DTCs; read data stream on heavy-duty (J1587, J1708, J1939, J1939/13 protocol based) vehicles*Supports 4 PIDs graphing at the same time
-
Product
IP code Testing
-
Educated Design & Development, Inc.
Ingress Protection Test Equipment is used to determine the degree of protection provided by a product enclosure. The level of protection provided by an enclosure is represented by an "IP" code (i.e. IP43). The first digit indicates protection against ingress of solid foreign objects. Many of these tests require accessibility probes. The equipment for these tests is provided below. All equipment fully complies with IEC 60529 (IP Code standard) and all other international standards with similar tests.
-
Product
Color Coded SMT Test Points
-
Color Coded for easy identification, these surface mountable PCB test points are ideal for production testing and service troubleshooting. Phosphor Bronze, Silver Plated terminals allow for superior solderability and low electrical resistance. Wire loop design provides convenient access point for J-hooks, EZ hooks, grabbers, alligator clips, tips or probes.
-
Product
Discharging Bars
-
VARIO discharge products consist of a separate AC power supply for connecting one or more Eltex discharging components. In SINGLE discharging, the voltage generation (power supply ) is integrated in the bar.
-
Product
Flux Leakage Tester For Detecting Surface Defects In Hot Rolled Black Steel Bar
130MM ROTOFLUX® AC
-
Highly sensitive AC flux leakage is especially well suited to test hot rolled black steel bars and rods that have surface conditions which used to make finding shallow defects very difficult, if not impossible.
-
Product
Code Name: Twin Lake
MIO-5854
-
DDR5-4800 up to 16GB4x LAN, 4x USB, 4x UART, 2x CAN-FD, 16bit GPIO, I2C/SMBus2x M.2 Expansions: E-Key 2230, B-Key 2280Support EdgeBMC for OOB(Out-of-Band) remote control
-
Product
Safe Bar Code Positioning System
-
Leuze electronic GmbH + Co. KG
The world's first safety bar code positioning system, FBPS 600i, requires just one sensor for safe position detection. The device is connected to a safe evaluation unit – e.g. a frequency inverter – via two SSI interfaces and is suitable for applications up to performance level PL e. This allows easy implementation of safety functions and a reduction in space and installation requirements.
-
Product
Live-Dead-Live Meter Verifier
LDL-1200
-
The Live Dead Live (LDL) Meter Verifier is a small, lightweight, robust, portable, handheld power supply. It supplies just under 150 volts, AC (rms) or DC with a maximum current of less than 5 mA at rated voltage. The LDL-1200 Meter Verifier is specifically designed to facilitate voltage verification tests on most digital multi-meters, electronic voltage detectors, voltage testers, neon test lights, tic tracers and other commonly used electrical voltage test apparatus, while keeping the user as electrically safe as possible with its extremely low “volt-amp” output.
-
Product
Ultrasonic Testing of Spinning Tube and Bar
ECHOMAC® FULL BODY TESTER
-
At the heart of the Echomac® Full Body Tester for Ultrasonic (UT) Testing of Spinning Tube and Bar is the unique Adaptive Pitch Control (APC) transducer carrier and the precision design “Spin-The-Tube/Bar” conveyor.
-
Product
IP Code Test Equipment
-
Weice Testing Instrument Co.,Ltd.
IP Code, International Protection Marking, sometimes interpreted as Ingress Protection Marking, classifies and rates the degree of protection provided against intrusion (body parts such as hands and fingers), dust, accidental contact, and water by mechanical casings and electrical enclosures.
-
Product
Code Readers/Code Scanners
AutoLink AL629
-
The AutoLINK AL629 can read and erase codes on domestic, Asian and European vehicles, 1996 and newer. In addition to scanning engine codes, the AL629 can also scan ABS, SRS (airbag) and transmission systems for codes.
-
Product
Temperature, Humidity, Bar. Pressure Transmitter
T7411-2
-
Humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy. Built-in pressure sensor.
-
Product
IRIG Time Code Receiver & Generator for Computers (PCI Express)
TCR180PEX
-
Meinberg Funkuhren GmbH & Co. KG
The TCR180PEX receives IRIG-A/B/G, IEEE 1344, IEEE C37.118 or AFNOR NF S87-500 time codes and can be used for synchronizing the system time of its host PC. The IRIG output of this card can generate an IRIG signal for other IRIG time code readers. The output format is independent from the incoming IRIG signal - a perfect solution to your IRIG conversion requirements. It is used in applications like data acquisition, standalone computer time synchronization (for systems without a network connection or higher accuracy requirements) or as an IRIG converter device.
-
Product
Midi Time Code Reader
MTC
-
MTC - Midi Time Code hardware Analyzer or Analyser /Reader/Decoder. The MTC Decodes any (FX) System Common or System Real-Time Messages and displays them in a clock format, independent from your MTC generating device. The MTC has the same input and HOLD and SCROLL features as described in the MA1 module.
-
Product
Static Analyzer for C or C++ Code for Compliance with MISRA, CERT
RuleChecker
-
AbsInt Angewandte Informatik GmbH
RuleChecker is a static analyzer that automatically checks your C or C++ code for compliance with MISRA rules, CERT recommendations, and other coding guidelines.RuleChecker primarily targets safety-critical embedded applications, but can also be used to analyze any structured programs, handwritten or generated, with complex memory usages, dynamic memory allocation, and recursion.
-
Product
40U (70") Insulated Bus Bar
BB-70-I
-
40U (70") insulated bus bar provides cabinets with recessed rail option and a convenient, isolated common grounding mechanism.
-
Product
Intel Core Ultra Processors (Code Name: Panther Lake)
MIO-5381
Single Board Computer
Intel Core Ultra Processors, up to 14 Cores, TDP 28W/15WDual Channel DDR5-7200 up to 128GB, with IBECC support4 simultaneous displays: eDP + 2x HDMI + USB-C with DP Alt.2x LAN, 6x USB (incl. 1x USB4), 4x UART, 2x CAN-FD, 8bit GPIO, I2C(*SMBus)4x M.2 Expansions: E-Key 2230, B-Key 3052, 2x M-Key 2280Supports Windows 10/11 LTSC & Ubuntu 24.04 LTS, embedded software APIs, DeviceOn Remote Management, Robotic SuiteSupport EdgeBMC for OOB(Out-of-Band) remote control management
-
Product
HD Color Bar Generator
CBG830
-
The CBG830 color bar and test signal generators will produce a quality, high definition full field color bar signal compatible with the digital HDMI and DVI-D interfaces. The CBG830 is designed to provide an accurate and affordable signal source for easy testing of displays, cables and systems.The CBG830 will generate a full field color bar signal with eight vertical bars, white through black. This signal is available in a variety of resolutions and refresh rates. TheCBG830 will usually fit in a toolbox with ease and even fit into a pocket. There is also a rack mount kit available as well. Power is provided by a regulated 5VDC source and a small wall plug power module is included with the packaged CBG830 but not with board level products. The CBG830 will have a switch array to select the video standard.
