Product

OTDR Avalanche Photodetector

APD

-

Macom Technology Solutions Holdings Inc.

APD - Macom Technology Solutions Holdings Inc.

MACOM’s new Optical Time Domain Reflectometer (OTDR) detector products are based on proprietary Avalanche Photodetector (APD) Technology. The MACOM OTDR products are a low noise, low dark current and highly sensitive inGaAs/GaAs APD operating between 1250nm to 1650nm.

Product

Fiber Optic Power Meters

FOD 1204

-

Fiber Optic Devices Ltd.

FOD 1204 - Fiber Optic Devices Ltd.

The FOD 1204 & FOD 1204H Fiber Optic Power Meters are intended for accurate measurements of up-to-date optical communication. Very small temperature and temporal variations of Loss in Fibers and Connectors. Calibration of Optical Attenuators, Light Sources etc.

Product

Digital Output Board, 32 Isolated Channels, 24V

APCIE-2032

-

TEAM SOLUTIONS, INC.

APCIE-2032 - TEAM SOLUTIONS, INC.

32 digital outputs, 24 V or 5 V, 500 mA/channel Optical isolation 1000 V Overvoltage protection Short-circuit protection WatchdogAt power-on the outputs are reset to ì0î

Product

TS Optical Transmitter / TS Optical Receiver

-

Sichuan Jiuzhou Electronic Technology Co.,Ltd

Sichuan Jiuzhou Electronic Technology Co.,Ltd

A 4-way TS optical transmitter can long distance transfer 4-way MTS(multi programs transfer stream) from 4 difference multiplexer output in same optical fiber, then At optical receiving terminal, A TS optical receiver will change the optical signal to 4-way independent standard TS output。

Product

PCIe Digital I/O Board, 64 Optically Isolated I/O Channels, 24V

APCIE-1564

-

TEAM SOLUTIONS, INC.

APCIE-1564 - TEAM SOLUTIONS, INC.

32 digital inputs, 24 V, isolated16 interruptible inputs32 digital outputs, 24 V, isolated, 10 to 36 V, 500 mA/channelOptical isolation 1000 VWatchdog for resetting the outputs to "0" (when Power-On)Protection against fast transients, overvoltage, electrostatic discharge and high-frequency EMIInputs: voltage reversal, input filtersOutputs protected against short circuitOvertemperature and overvoltage protectionDiagnostic report in case of short circuits, overtemperature, voltage drop ...24 V power outputs with protection diodesShutdown logic when the external supply voltage drops below 5 V

Product

Analog Isolator

-

E-Max Instruments

E-Max Instruments

The Analog Optical Isolator module is a single isolated current in / current out or voltage in / voltage out channel of physical separation and electrical isolation for establishing and maintaining the independence of Class 1E equipment from non -Class 1E instrumentation circuits. Input-to-Output isolation has a steady-state isolation capability of 2500 volts AC rms. This isolation will be maintained between:a) input to output signalsb) input to output powerc) output signal to input power

Product

16-bit, 200KHz, 8SE/4DIFF Isolated AI, 4 12-bit AO, 8 Optically Isolated Dig. I/O, 24V, 24 TTL I/O

APCI-3116-8

-

TEAM SOLUTIONS, INC.

APCI-3116-8 - TEAM SOLUTIONS, INC.

The APCI-3116 is a 16-bit multifunction board for 3.3 V and 5 V PCI systems, with optical isolation up to 1000 V and a high throughput rate of 200 kHz. The PCI board has additional types of conversion: Sequence RAM, Auto Refresh, scan, timer or external event.Furthermore, the board has a PCI DMA, 2 watchdogs, 4 digital inputs and 4 digital outputs. Sensors, which allow to supply current signals instead of voltage signals, also can be acquired with the APCI-3116, as this board offers up to 16 current inputs. The board is protected against overvoltage and input filter and it is protected against high frequency emmission. With the free calibration tool you can do the fine adjustment on-site.

Product

High Speed Free Space Optical Detectors

-

Newport Electronics

Newport Electronics

High speed optical detectors use special photodiodes with high speed electronic circuits to convert fast optical pulses to electrical signals for measurement. Unlike our optical receivers, these detectors do not include a transimpedance amplifier.

Product

Infrared Calibration

-

Process Instruments Inc.

Process Instruments Inc.

Optical pyrometers can be calibrated from 800 to 2300C using NIST certified ribbon filament lamps and temperatures up to 3500C using a graphite arc furnace. Infrared thermometers can be calibrated from -30C to 2300C utilizing state-of-the-art blackbody sources and transfer standards.

Product

Optical Communication Probes

-

TransData, Inc.

TransData, Inc.

Abacus Electrics ANSI Type 2 optical probes utilize infra-red LED technology to provide a galvanically isolated, bi-directional communications interface between energy meters and laptop computers or handheld devices for onsite data retrieval, programming and diagnostics.

Product

4-Channel Optical Transceiver

QSFP28 AOC

-

Eoptolink Technology Inc., Ltd.

QSFP28 AOC - Eoptolink Technology Inc., Ltd.

Eoptolink QSFP28 Active Optical Cable is a 4-channel optical transceiver, which conforms to QSFP28 MSA and works at the rage of 25Gbps per channel. The AOC conforms to transmission speed required by InfiniBand™ EDR, 100 Gigabit Ethernet (100GBASE-SR4) and enables to transmit maximum 100m. Best for close-range high-speed transmission, for example, betweenserver racks, between servers.

Product

Rolling Seal 8 Optical Connector - APC (RS8 APC)

-

Teledyne Marine ODI

Teledyne Marine ODI

The Angled Physical Contact Rolling Seal 8 Connector (RS8 APC) from Teledyne ODI is a wet-mateable optical connector with angled endfaces. The design reduces signal interference due to reflections at the connector face, supporting the next generation of subsea optical communication equipment. The Rolling Seal design provides isolation from seawater and silt when the connectors are unmated. As the seals rotate, the fibers join inside a clean, oil-filled conduit, resulting in a reliable optical throughput. The RS8 APC incorporates RS8 Mark III design features to enhance operational efficiency and reduce risks during ROV intervention.

Product

8 Relay Output Board

APCI-2200-8

-

TEAM SOLUTIONS, INC.

APCI-2200-8 - TEAM SOLUTIONS, INC.

*8 relay output channels*Switching voltage 60 V/DC, 48 V/AC, switching current 1 A*Optical isolation*Watchdog*Easy programming

Product

Transmissive Optical Encoder Module

EM2

-

U. S. Digital

EM2 - U. S. Digital

The EM2 provides digital A & B quadrature outputs with a third output index channel. Each EM2 module is resolution specific and is matched to the resolution of a code wheel. The EM2 operates with a single 5V supply and provides single ended outputs which are capable of both sinking and sourcing 5mA. An internal 0.1 uF decoupling capacitor is designed into the EM2 to provide enhanced noise immunity.

Product

Optical Gas Imaging Camera

EyeCGas CO

-

Opgal Optronic Industries Ltd.

EyeCGas CO - Opgal Optronic Industries Ltd.

EyeCGas CO is a handheld OGI camera for CO gas leak detection. With this camera you can safely and remotely detect and locate carbon monoxide as well as other harmful gases emissions. It is also the only OGI camera that is certified for ATEX zone 2 and UL class I Div II, hazardous environments. The EyeCGas CO allows for routine and on-demand inspections in the steel manufacturing operations and other industries where CO emissions need to be closely monitored. With EyeCGas CO, Opgal helps you detect and repair toxic gas leaks inside the facility, whether in vent stacks or pipes, allowing video and audio recording while maintaining safety. Whether these toxic gases are part of the manufacturing process, or a byproduct of the production line, EyeCGas CO helps increasing safety and protect the environment.

Product

Optical tTansceiver Module

QSFP28

-

Eoptolink Technology Inc., Ltd.

QSFP28 - Eoptolink Technology Inc., Ltd.

Eoptolink’s EOLQ-851HG-02 QSFP28 SR4 100G  Optical transceiver module are designed for use in 100 Gigabit Ethernet links over multimode fiber. They are compliant with the QSFP28 MSA and IEEE 802.3bm 100GBASE-SR4 and CAUI-4. Digital diagnostics functions are available via the I2C  interface, as specified by the QSFP28 MSA.

Product

XRD System

SmartLab®

-

Rigaku Corp.

SmartLab® - Rigaku Corp.

SmartLab includes as standard Rigaku's patented Cross Beam Optical™ (CBO) technology. CBO technology uses simultaneously mounted, simultaneously aligned optical components for both focusing (Bragg-Brentano) and parallel beam diffractometer geometries. Users can switch between the two geometries without the need to remove, replace, or realign optical components.

Product

Talk Set

OTS-20

-

ShinewayTech

OTS-20 - ShinewayTech

OTS-20 Multifunction Optical Talk Set enables clear and long distance telephony on single optical fiber. Featuring integrated laser source and optical power meter for loss test, OTS-20 is a reliable toolset for tough environments.

Product

RS485 Mode SI-module With Optical Isolation

MX485-G

-

TEAM SOLUTIONS, INC.

MX485-G - TEAM SOLUTIONS, INC.

RS485 mode SI-module with optical isolation

Product

Fiber Optical Switch at Single Mode Latching 1310/1550nm 5V with LC/PC Connector

SUN-FSW-1x2H

-

Guilin GLsun Science and Tech Group Co., LTD

SUN-FSW-1x2H - Guilin GLsun Science and Tech Group Co., LTD

GLSUN 1×2H Mechanical Optical Switch Fiber Switch Features·Low Insertion Loss·Wide Wavelength Range·Low Crosstalk·High Stability, High Reliability·Epoxy-free on Optical Path·Latching and Non-latchingGLSUN 1×2H Mechanical Optical Switch Fiber Switch Applications·R&D in Laboratory·System Monitoring·OADM·MAN (Metropolitan Area Network)·Network Security and MonitoringGLSUN 1×2H Mechanical Optical Switch Fiber Switch SpecificationsParameters Unit SUN-FSW-1×2HWavelength Range nm 1260 ~ 1650Test Wavelength nm 1310 / 1550Insertion Loss 1, 2 dB Typ: 0.8 Max: 1.0Return Loss 1, 2 dB SM ≥ 50Crosstalk 1 dB SM ≥ 55PDL dB ≤0.05WDL dB ≤0.25Repeatability dB ≤±0.02Operating Voltage V 3.0 or 5.0Durability Cycles ≥ 10 MillionSwitching Time ms ≤8Optical Power mW ≤500Operating Temperature ℃ -20 ~ +70Storage Temperature ℃ -40 ~ +85Relative Humidity % 5 ~ 95Weight g 14Dimension mm (L )22.5×(W)11.8×(H)10.2 ±0.2Note: 1 Within operating temperature and SOP.2 Excluding Connectors.

Product

2-MGEM Optical Anisotropy Factor Measurement System

-

Hinds Instruments, Inc.

Hinds Instruments, Inc.

The 2-MGEM Optical Anisotropy Factor Measurement System is a normal-incidence polarization reflection microscope designed to measure the sample Mueller matrix and is a 2008 R&D 100 Award Winner. This system is designed specifically to evaluate the Optical Anisotropy Factor (OPTAF) of cross sections of TRISO nuclear fuel pyrocarbon layers. Other possible material characterizations include measuring Mueller matrix elements of other crystals, carbon compounds, and thin film coatings (e.g. surfacedeposition films) at normal incidence. The 2-MGEM can also measure retardation (d), circular diattenuation (CD) and the polarization factor (ß). These parameters are not measurable using older techniques, since those techniques do not incorporate a compensating optical element.

Product

47~862MHz FTTH Digital TV Two Output Low Optical Receiver

H9222L

-

Hangzhou Huatai Optic Tech. Co., Ltd.

H9222L - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai H9222L, operating bandwidth of 47 ~ 862MHz, is a suitable digital television FTTH applications, ultra-low optical receiver, Whether used in analog television or digital television. Receiving at high optical power can be adjusted by PAD level, played limiting output, so H9222L within a large dynamic range of the received optical power of +2 dBm ~-20dBm, have excellent characteristics.