Hydrogen Detection
sense the presence of Hydrogen gas.
-
Product
X5 Spacesaver/CW3 Check & Detect Combination System
-
The X5 Spacesaver & CW3 Check & Detect Combination System is designed for detecting contaminants and reducing giveaway in food products. This system is perfect for inspecting retail-packed convenience food, ready meals in foil trays and small end-of-line packaged goods.
-
Product
12-Bit, 2.5 GSPS Digitizer Optimized for Pulse Detection
ADQ32-PDRX
Digitizer
ADQ32-PDRX acquires the input signal via a single connector and uses an onboard splitter to separate the signal into two paths with different gain settings. The high gain path is used to accurately capture low-amplitude portions of the input signal whereas the low gain path ensures the acquisition of high-amplitude peaks without causing saturation. The two signal paths are then combined in real-time inside the onboard field-programmable gate array (FPGA) to create a digitized output with improved performance.PDRX increases the dynamic range by 3 bits and is fully integrated into the digitizer for fast and easy system-level integration. ADQ32-PDRX is therefore comparable with a 16-bit digitizer in terms of dynamic range, but with the benefit of offering a higher sampling rate.
-
Product
Partial Discharge Detecting Systems
-
Hangzhou Xihu Electronic Institute
Cable PD detecting and positioning system, transformer PD detecting and positioning system, switchgear PD detecting and positioning system, GIS PD detecting and positioning systems.
-
Product
Gas & Flame Detection System
Syntel
-
Teledyne Gas & Flame Detection
Syntel is an addressable loop system suitable for use in zone 1 and 2 hazardous areas. The complete addressable loo is fault tolerant operating normally with a short or open circuit. Syntel does not have a CPU, so there is no common failure point. It includes a standard OPC interface and can also be supplied by Modbus allowing easy integration with third party systems.Syntel stores alarm and calibration information in distributed non-volatile memory, hence there is no reliance on a centralized system.Syntel is ideal for installations where there is the possibility for future expansion. The system architecture allows very low cost expansion as cable runs to a central location are not needed.
-
Product
Detection Electronics
-
Our detection electronics portfolio comprises all the detection electronics elements required for the operation and automation of a high quality light measurement system, including photo-detector signal recovery and digitisation (with fully programmable DC, AC and lock-in amplifiers having current/ voltage inputs), high voltage supply, optical chopper control, detector thermoelectric cooler control and relay unit.
-
Product
Insight Pharmaceutical Metal Detection System
-
The Insight PH Pharmaceutical Metal Detector is designed for inspecting tablets and capsules after the tablet and de-duster process with throughput of up to 30,000 units per minute. The system is built with a gas strut stand frame offering exceptional manoeuvrability making it convenient for use with all leading tablet presses and encapsulation machines.Designed with throughput of up to 30,000 units per minute, the Insight PH comes complete with full IQ, OQ & PQ validation documents and certification.
-
Product
Gas Detection System Controller
SMC Sentry IT
-
The SMC Sentry IT Controller is a powerful network-enabled hazardous gas detection system that operates up to 32 detectors and interfaces with devices over Modbus RTU, 4-20 mA, Sentry PSG Bus, and conventional dry contact. The embedded web application enables users to view important data remotely and provides connectivity into the Industrial Internet of Things (IIoT).
-
Product
Partial Discharge Detecting Detectors
-
Hangzhou Xihu Electronic Institute
Including pulse current PD detecto, high frequency PD detector, transient earth PD detector, ultra high frequency PD detector, and ultrasonic PD detector.
-
Product
Oxygen/Nitrogen/Hydrogen Analyzers
EMGA-Pro
-
The characteristics and performance of metal and solid materials, including steel, various other metals, ceramics, and electronic materials, are determined by the amount of oxygen, nitrogen, and hydrogen. Analyzing elements in such materials at high accuracy and with a small amount has become increasingly important in the study and performance analysis of materials. The EMGA Series Oxygen/Nitrogen/Hydrogen Analyzers significantly reduces analysis time and costs while enhancing analysis accuracy and functionality. Pursuing also usability, the EMGA Series strongly supports improved efficiency in material research and development and quality control.
-
Product
X5C & CW3 Check & Detect Combination System
-
The X5c & CW3 Check & Detect Combination System is designed for detecting contaminants and reducing giveaway in food products. This system is perfect for inspecting retail-packed convenience food, ready meals in foil trays and small end-of-line packaged goods up to 280mm wide by 110mm high.
-
Product
Indoor Gunshot Detection And Response System
Pre-SenseShot
-
Information System Technologies Inc.
ISTI offers a new detection system to the facility security and safety industry to quickly neutralize an active shooter and more quickly secure and protect occupants. When confronted with an active shooter situation first responders and safety personnel face immediate tactical disadvantages. Beyond rushing towards ensuing chaos, 9-1-1 calls and eye witness reports are often disjointed, inaccurate, and lack precise location information required to make real time responsive decisions as they arrive on scene. Likewise within the building, the crisis triggers panic and chaotic scrambles towards exits and assumed safe havens. However unorganized and uniformed retreats may actually be leading evacuees back into harm’s way.
-
Product
Multispectral Fixed Camera for Early Fire Detection
FH-Series R
-
The FLIR FH-Series R are ruggedized, multispectral fixed cameras that integrate industry-leading thermal imaging with 4K visible imaging to provide rapid visual verification of hot spots in early fire detection applications. When a hot spot or temperature change is detected, the contactless temperature measurement is sent to the operator through a connected Video Management System (VMS) for instantaneous assessment and deployment of response tactics. Custom scheduling provides security personnel the flexibility to enable and disable alarms depending on business hours and seasonality. Combining the power of thermal hot-spot detection with intelligent vehicle detection, false alarms from hot exhaust pipes can be dramatically reduced.
-
Product
Subsea Cable Detection & Tracking System
HydroPACT 350
-
The HydroPACT 350 provides a reliable and simple method for performing accurate submarine surveys on a tone-carrying cable. It is available as a 110V system or a 240V system, both depth rated to 3,000m with a 6,000m option.The 350 system operates in real-time and provides accurate measurements at a rate that allows integration on faster ROVs. The measurement technology used by the system also allows it to operate out of water with no degradation in performance, range or accuracy.
-
Product
Smoke Detection Sensor - CE Approved
ENVIROMUX-SDS-CE
-
For warning of smoke. Photoelectric smoke detector. Smoke sensitivity: 0.08-0.14 dB/m. Built-in 135° F (57° C) thermal heat sensor. Includes mounting hardware. Connect to RJ45 or digital input sensor ports. Supports CAT5/5e/6 UTP or STP cables. Screw terminal. To connect to the RJ45 inputs use CAT5/5e/6 cable terminated at one end with RJ45 connector. Connect the un-terminated end to the sensor screw terminal. Operating temperature: 14 to 122°F (-10 to 50°C). Maximum cable length: 1,000 ft (305 m). Powered by ENVIROMUX-2D/5D/16D. Regulatory approvals: CE, RoHS.
-
Product
CBRNE Detection
-
Investments in intellectual horsepower, research and development; enable Bruker to offer a wide range of products with a broad technological base and high end instrumentation that includes:
-
Product
Subsea Pipe and Cable Detection & Tracking System
HydroPACT Dualtrack
-
Dualtrack is the combination of the 440 and the 350 systems to provide the ultimate subsea detection system, capable of tracking and surveying pipes and cables via ROV deployment.It utilizes the same industry standard pulse induction technology as the 440 system to survey accurately regardless of vehicle heading. The accompanying display and control software is Windowsâ„¢ based providing a familiarity factor that a specifically built interface would not.
-
Product
Photon Counting Detector - Single Photon Detection with Picosecond Accuracy
PPD
-
The PPD Series is a range of miniaturized single-photon counting detectors containing all the electronics necessary to detect single photons with picosecond accuracy.
-
Product
DDR Detective Logic Analyzer
DDR4
-
NOW supports 3DS at 3200MT/s!Provides logic analyzer like deep transaction Listing and Waveform capture. Continuous Capture for Violations and Performance metrics NOT a fill memory and then post process like other tools. This is a FuturePlus ONLY feature!
-
Product
Lightning Detection Accessories
-
Check out all of our accessories for a perfect compliment to any of our lightning detectors. They are designed fora wide range of applications and installation setups, and even for a more personalized custom setup, or simply tohave on hand for spare replacement parts.
-
Product
Test System for Detecting Exact PCB Short Circuit Locations
QT25
Test System
Qmax Test Technologies Pvt. Ltd.
QT25 employs a unique method to detect exact PCB shorts circuit locations and pin down the shorted components and tracks. It is designed in such a manner that it precisely detects exact short circuit locations across VCC - GND or a shorted component connected across a Bus or hair-line shorts between PCB tracks, Which is highly impossible to detect using conventional tools especially when they are connected parallel in circuit. It can also be used in measuring the contact resistance of switches and relays in its milli-ohm mode as a value add.
-
Product
Radiation Detection & Measurement Products
-
Detect, localize, identify, and measure radioactivity in any scenario. From routine monitoring and surveillance to emergency response situations, our advanced, integrated radiation detection instruments mitigate the threat and keep you safe. Our product portfolio of radiation detection solutions provides comprehensive, real-time monitoring, early warning, and complete information in the palm of your hand, in the work place, and in your neighborhood.
-
Product
Real-time Spectrum Analysis up to 510 MHz, Optimum Detection, Multi-touch
N9030B-RT2
Signal Analyzer
See, capture, and understand elusive signals as short as 3.57 s with 100% POI and a complete set of advanced triggers View signal dynamics with integrated real-time displays Maximize your investment by adding RTSA at a fraction of the cost of a dedicated solution Easily integrate the 89600 software and thoroughly analyze complex signals Industry-leading 3 year warranty Every spec verified, adjustments included Lock in support & peak performance from the start
-
Product
Real-Time Spectrum Analysis up to 160 MHz, Optimum Detection
N9030A-RT2
-
Capture elusive signals as short as 3.57 with 100% POI and a complete set of advanced triggers View signal dynamics with displays: digital and swept density, spectrum, spectrogram, power vs. time, gap-free real-time analysis, and more Maximize your investment by adding RTSA to your PXA at a fraction of the cost of a dedicated solution Easily integrate the 89600 software and thoroughly analyze complex signals Extend RTSA measurements to millimeter-wave range with external mixers Industry-leading 3 year warranty Every spec verified, adjustments included Lock in support & peak performance from the start
-
Product
Real-Time Analysis up to 255 MHz, Basic Detection, Multi-touch
N9041B-RT1
Signal Analyzer
See, capture, and understand elusive signals as short as 17.17 s with 100% POI and a complete set of advanced triggers, up to 110 GHz View signal dynamics with integrated real-time displays Maximize your investment by adding RTSA at a fraction of the cost of a dedicated solution Easily integrate the 89600 VSA software and thoroughly analyze complex signals Industry-leading 3 year warranty Every spec verified, adjustments included Lock in support & peak performance from the start
-
Product
For Detecting Low Range And Leakage AC/DC/Pulsed Current.
FDAZCT-20LSP-0.6S
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
*Lowest Influence from Magnetization,Temperature *Change,Residual Current and Terrestrial Magnetism.*Low Cost and High Performance (Output Linearity ±1% F.S)
-
Product
Bleed Air Leak Detection System For Aerospace
-
Ideal for composite aircraft. Our revolutionary detector network accurately locates potentially catastrophic leaks in bleed air systems. By activating a cockpit alarm, it enables mechanics to find the affected areas fast and with precision.
-
Product
Lightning Detection & Early Warning System
EWS-PRO
-
The EWS-PRO is the only professional grade portable lightning detection and early warning device available today. It is a self-contained instrument with the electronic sophistication to detect lightning strikes over 40 miles away, and to accurately track a storm's approach with both its audible horn and its large LED visual alerts.
-
Product
Low-Light-Level Detection Modules
-
From single photons to mW, from 400nm to 1.7µm, the Excelitas family of Low-Light-Level Detection (L3D) Modules offers industry-leading performance in compact, easy-to-use packages operating from a single 5V DC power supply.
-
Product
PCI Express Digital I/O Cards With Counters And COS Detection
PCIe-DIO-24DCS, PCIe-DIO-24DC, PCIe-DIO-24DS, and PCIe-DIO-24D,
-
This product is a x1 lane PCIe DIO board available in four models ranging from basic DIO to advanced COS detection and Counter/Timer capabilities. The card emulates an 8255 compatible chip, providing 24 DIO lines. The DIO lines are grouped into three 8-bit ports: A, B, and C. Each 8-bit port is configured via software to function as either inputs or outputs. Port C can be further broken into two 4-bit nybbles via software and configured as either inputs or outputs.
-
Product
Object Detection Systems
-
Inside or outside: Effective solutions for an incredibly wide range of applicationsObject detection systems detect objects irrespective of size or position, both indoors or outdoors. They are used in intralogistics to increase throughput of conveyor systems. The systems also prevent collisions in outdoor areas and ensure and increase equipment availability in steel mills, ports and other areas. Regardless of the application, system reliability means smooth process flow.
